轴向的

In the present study, through using non-linear three dimensional finite element analysis, considering the contact in flange to nut and flange to gasket, we accurately computed the stress distribution in the flange joint in the normal work condition.

采用ANSYB软件，应用三维有限元技术，考虑了垫片的非线性和法兰和螺母、垫片的接触问题，并且采用了螺栓预紧单元，准确计算出法兰连接在承受内压、轴向力和弯矩外荷载时的应力分布。

And fill in 3 of the pump noise to rub pair in influencing the axial column of the Model 63CY14-1B: With mix oil friction , variable head and slippery friction , column of boots of record fill in with column friction to fill hole cylinder block.

而对于影响63CY14-1B型轴向柱塞泵噪音的3个摩擦副：缸体与配油盘的摩擦、变量头与滑靴的摩擦、柱塞与柱塞孔的摩擦。

This paper gives cracking criterion of interface between steel rope with grout also, then two expressions of the relationship of slip displacement and friction force are put forward.

采用模型试验与曲线拟合法，对砂浆和混凝土所形成的不同角度界面的试件进行轴向拉伸试验，导出界面开裂时正应力和剪应力的关系表达式，以此作为界面开裂判据。

The different friction coefficient between tube and die is one of the important influences in tube hydroforming. Reduce the friction as possible, it can not only benefit to tube forming, but also reduce axial force effectively.

不同的管坯和模具之间的摩擦系数也是影响管坯成形的重要影响因素之一，要尽量减少摩擦，不仅有利于管坯的成形，还能有效地减小轴向力。

Moreover, based on the uniformity of solid axial distribution, the respective performances of the radiant orifice gas distributor and the perforated plate （1 mm） were compared, as well as with and without internals.

从固体轴向分布的均匀性分别比较辐射式锐孔气体分布器和1mm多孔板气体分布器的性能以及有／无内部构件的性能。

If longer heat-conducting paths are necessary, actively heated nozzles fitted internally with electric heating elements in an axial direction can be employed.

如果需要较长的热传导路径是必要的，积极喷嘴加热装置对内与电热元件的轴向可以采用。

Flat self adhesive business card printing and membership card making machine ink roller is a diameter of 150 mm mini can Dynamic axial series of chrome-plated iron roller, what it does is from monlchamus tuhung roll and ink roller accept ink and printing ink evenly over the field uniform allocation, and then delivered to the inking rollers, oscillating roll lost oscillating formation halo effect is easy.

陡压陡不潮胶制卡和会员卡制息机的匀不朱辊是一个直径为150mm可以轴向串不静的镀铬铁辊，它的息用是从不朱斗辊和传不朱辊上剥夺油不朱并把油不朱匀匀调配，再传送给着不朱辊，串不朱辊获得串不朱息用很便当变成晕影。

DIS has continued to develop its isolators to perform well at large lateral displacements accompanied with high axial loads.

DIS继续开发它的免震支座使它很好地做到在带有高度轴向负荷的情况下进行大的横向位移。

The influences of Halbach magnet axial length on the leakage flux density are analyzed. The relationship between the key design parameters of motor, such as leakage coefficient and the calculated length of the armature, and the structure parameters of motor are obtained.

通过大量的计算，探讨了Halbach阵列永磁电机在转子无铁心情况下影响气隙磁密的各种因素，分析了不同Halbach磁体轴向长度对端部漏磁的影响规律，给出了无铁心永磁电机漏磁系数、电枢计算长度等主要设计参数随电机结构尺寸的变化规律。

The axial stress-strain curves under various level of confinement and strain rate were derived according to the experiment. It shows that the strength and ductility increase significantly because of confinement, and finally turn into plasticity, also it is strain rate sensitive.

实验得到了水泥砂浆在不同围压、不同应变率下的轴向应力应变曲线，发现材料在围压作用下抗压强度和韧性大大提高并且整体进入了伪塑性，而材料的应变率效应也是显著的。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。