轴向的

In addition, it is well known that axial force coefficient denotes the pressure drop across the turbine to a great extent.

因此，如果知道了轴向力系数，就可由透平的运动状态获得透平前后的压降。

In consideration of the effect of the moment on the axial rigidity of the reinforced beam,the theory and practice of main cable s configuration calculation of self-anchored suspension bridge were systemically introduced with the method of segmental catenaries.

基于分段悬链线法，介绍自锚式悬索桥主缆线形计算原理和步骤，考虑弯矩对加劲梁轴向刚度的影响，在迭代计算过程中，提出采用非线性规划方法，并与传统的影响矩阵法进行对比，计算结果表明，两者结果吻合，从而使借助大型通用优化软件对自锚式悬索桥主缆线形进行精确求解成为可能

Magnetic workholding chucks may not be necessary for finishing operations that do not exert a significant amount of axial cutting forces.

磁workholding夹头可能没有必要的精加工工序不施加了大量的轴向切削力。

Based on the optoelectronic inspecting technology, the chinks between knife edge and the generatrices of measured part were measured by the laser scanned inspecting system and using the rotating and axial feed servo systems, and the non contact automatic measurement of straightness error was realized.

基于光电检测技术，利用回转和轴向进给伺服系统，通过激光扫描检测系统测量刀口尺与被测零件素线之间的间隙，实现了对直线度误差的非接触自动测量。

It is also studied how the axial relative position in the process of drawing affects the finished quality of rifled tubes.

本文还研究了在拉拔过程中芯棒和凹模的轴向相对位置对内螺纹管成形质量的影响规律。

In contrast, the dose distribution in lung shows less attenuation and scatters than that in water.

同理；在肺组织则是相反的情况，轴向剂量率随著深度降低情况的比水中少。

When draw down ratio was greater than 1, the dope thread in the air gap was axially drawn with the rising of orientation degree so the fiber tenacity was strengthened.

在喷头拉伸比大于1的情况下，原液细流在空气层中得到轴向拉伸，加大了初生纤维的取向度，所以纤维强度得到加强。

At the end of drainage and maturation phases, the auger pushes the curd towards the cutter with rotary disk assembled directly on the shaft of the auger near to the machine outlet; some adjustable knives are assembled on the cutter disk so that it is possible to change the cut thickness.

排放和成熟阶段结束时，螺旋向直接安装在螺旋轴上的转盘切割器推进凝乳，接近机器出口；一些可调整的刀具安装在切割器转盘上，这样它可以改变切割厚度。

Oil lubricated plain and rolling bearings of electric motors,axial-flow and centrifugal compressors operating at high temperatures.

需要于高温运作的电动马达、轴向流动及离心式压缩机内的普通轴承及滚动轴承。

This causes the blade arrangements to resemble to an axial-flow compressor, with a stator row in front of the rotor.

这引起扇叶的排列来类比一台轴向流动的压缩机，在压缩机转子前面有一个定子排。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。