轴向的

And in the long run the situation is relatively stable, with the type of impeller pump to force smaller, and can be set in the cover before and after the deputy leaves.

且在长期运行中情况比较稳定，采用该型式叶轮的泵轴向力较小，且可以在前后盖板上设置副叶片。

The impeller can be used 90 years of the best self-balancing axial force hydraulic model, making pump bearings and mechanical seal life greatly extended.

叶轮采用90年代最优秀可自平衡轴向力的水力模型，使得泵轴承和机械密封使用寿命大大延长。

Hydrostatic bearing can solve the equilibrium problem of axial force of multistage centrifugal pump satisfactorily.

液体静压支承技术可以很好地解决多级离心泵轴向力的平衡问题。

Off-design flow field analysis and radial force prediction of centrifugal pump

合成气在催化剂床层内的流动方向既有轴向，又有径向。

A novel tubular permanent magnet linear servo motor was proposed. The motor applies the axial magnet array topology of the secondary rod, and the air-cored armature windings and slotless structure of the forcer, which totally eliminates the cogging force of general permanent motors.

介绍了一种圆筒型永磁直线伺服电机，电机次级采用轴向磁通结构，初级采用无铁心空心式绕组设计，完全消除了传统有铁心永磁电机固有齿槽效应所引起的推力波动问题。

Observation of machine closure dynamic and static ring plane, its surface has a layer of thin furring, be able to wipe the surface, the basic non-wear, This is the loss of flexibility and spring assembly caused by bad, or motor causing axial movement.

观察机封动、静环平面，其表面有一层很薄的水垢，能够擦去，表面基本无磨损，这是弹簧失去弹性及装配不良造成，或电机轴向窜动造成。

The knitted techniques, hot-press technology and tensile properties of biaxial weft knitted thermoplastic composites are investigated in this article.

本文对纬编双轴向热塑性复合材料的编织工艺、热压成型技术及拉伸性能进行了研究。

Because hyperboloid gear wheel have a series of advantage, therefore it use than spiral awl gear wheel extensive.

3双曲面主动齿轮具有较大的轴向力，使其轴承负荷增大。

Three hyperextension angles (0°, 5° and 10°) and axial tibial rotations (0°, 2.5° and 5°) were assumed to simulate different knee alignments.

在膝关节过度伸直分析中，模拟膝关节三种过度伸直角度(0， 5和 10度)同时伴随有膝关节轴向转动(0， 2.5和 5度)的受力接触状态。

When subjected to the axial fluid-structure slamming compression, the structures exhibit three different critical conditions: buckling, plastic incipience and plastic collapse.

在轴向流-固冲击作用下，这些结构单元呈现出三种不同的动力临界状态：屈曲、塑性和塑性失效。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。