轴向

As the foaming agent is the continued increase in frother dosage of 400g / t, the gas holdup appears the phenomenon of axial turning point was not obvious, the axial distribution of gas holdup tends to uniform.

随着起泡剂用量的继续增加，在起泡剂用量为400g/t时，气含率出现轴向拐点现象不明显，气含率轴向分布趋于均匀。

Researching the static performance of angle-contact ball bearings in this paper, the load and deformation characteristics of the rolling bearing under axial and radial loads are studied by using the quasi-dynamic method on the basis of Hertzian contact theory.

研究角接触球轴承的静态性能时，本文主要在Hertz接触理论的基础上采用拟动力学方法，研究了轴向和径向载荷作用下滚动轴承的承载和变形特性，推导了轴承的轴向和径向刚度公式，并进行了实例计算。

First, in accordance with calculate formula of a axis magnetic field in the step-tier limitedlengthily solenoid, calculate formula of a axis magnetic field in the multi-tier limited lengthily solenoidis exiserted.

首先根据单层、限长螺线管轴向磁场的计算公式，推导出多层、限长轴向磁场的计算公式。

The prominence of localizer can induce a certain error of 2％ approximately, which was adjusted in the frontal images.

定位器的突出造成一定程度的轴向误差，约为2％，我们对正面图像进行了轴向误差校正。

Based on monochromatic light,the principle of resulting in nonreciprocal phase error that results from axial magnetic is analyzed,and the theory derivation about the actual nonreciprocal phase error is introduced.

基于单色光分析了轴向磁场产生的法拉第非互易相位差的机理，理论推导了实际的非互易相位差，给出仿真结果、分析结果和实验结果，并提出减小轴向磁场作用下的Faraday非互易相位差的主要方法是使得两个消偏器的45°误差之和(θ3+θ4)→0。

From the base to the crown in axial, the vessel-elements proportion increases in fluctuation, contrary to the ray proportion. The fiber proportions in the regions of base and crown are less than that in the trunk of tree, and fluctuate at 65% or so. The parenchym proportion increases quickly to the 1.3m height of tree, reaching the maximum at 9.52%, and then decreases quickly to the 3.3m height of tree (8.90%); afterward it leveled off and increases slightly.

组织比量轴向变异表现为随树高增加导管比量波动性递增，与木射线比量相反；纤维比量在近根区和近冠区稍小，而主干部稍大，并在65%左右波动；轴向薄壁细胞比量先随树高增加急剧增加，到1.3m树高处达最大值（9.52%）后又急剧降低至3.3m树高处的8.90%，以后基本稳定并在波动中略有增加。

We selected one axial slice that passed through the upper part of the pedicle and another one that passed through the lower part of the pedicle and compared next parameters in both cuts: pedicular cortical width, pedicular endostal width, pedicular angle, vertebral body length, vertebral body width, vertebral perimeter angles, and visual appearance of vertebral body shape.

我们选择一个通过椎弓根上半部的轴向切片和另一个通过椎弓根下半部的轴向切片，对两个切片进行以下参数的比较：椎弓根皮质宽度，椎弓根骨内膜宽度，椎弓根角度，椎体长度，椎体宽度，椎体圆周角和椎体的外形。

A selected one of the front mold or rear mold is axially and slidably movable within the bore relative to the other mold disposed within the bore to a desired one of the plurality of axial separation distances between the molds, whereby the volume is different for each separation distance.

所选择的前模或后模之一相对于设置在孔内的其他模具轴向滑动到一个模具之间所需的多个轴向间隔距离之一，由此每一间隔距离具有不同的容积。

The fractal dimension and tortuosity of trajectory are analyzed. The method of calculating the fractal dimension of trajectory is developed.

分析了孔道轴向分形维数与孔道空间曲折性的关系，建立了关联色谱固定相内孔道轴向分形维数的计算式。

In order to study the influence of the rigidity of unstiffened tubular joints on load-bearing behavior and structural stability,the experimental research on axial rigidity and bending rigidity of the joints was performed,in combination with the practical demands of a steel tubular constructional project.

试验结果表明，当支管与主管直径相差较多时，节点轴向刚度和抗弯刚度均较弱，节点的半刚性能对结构的受力性能尤其是整体稳定性的影响不容忽视；当支管与主管直径接近时，节点轴向刚度和抗弯刚度均较大，基本能够满足节点刚接的要求

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。