软化

SUPPLIES:1 - Nail scissors2 - Small tray, about the size of a soap dish3 - Gentle dishwashing detergent or other skin softening, bubbly liquid (such as some bubble bath products)4 - Warm water5 - Two to three hand towels6 - Moisturizer or Hand Lotion with Aloe Vera, Cocoa Butter or similar ingredient to condition skin7 - Clear Base Coat Nail Polish8 - Colored Nail Polish9 - Top Coat Nail Polish10 - Small lamp or other radiant source of light11 - Table or desk so that, when seated, your arms can easily extend across from the relaxed position of a comfortable chair12 - Hair dryer or similar device13 - Cotton swabsSTEPS:1 - Fill tray with warm water and sudsy liquid (the trick is to add water at just the right temperature so it will soften skin without being too hot to the touch)2 - Place one hand in tray and let it soak for several minutes3 - If you're giving someone else a manicure, you can use oil or moisturizer to massage one hand while the other one is soaking4 - Remove soaking hand and pat dry with hand towel5 - Place other hand in tray to soak for several minutes6 - While the second hand is soaking, you should carefully begin trimming cuticles that form around the edges of the nail itself NOTE: Pay close attention to what you're doing, so you don't cut too close and end up causing skin to bleed.

本指南会给你的基本方向，指甲护理，但它无法提供同一方向亲身体验提供一个专业学校cosmetology.supplies：1钉scissors2-小托盘，大小相当于一个肥皂dish3-温柔洗洁精或其他皮肤软化泡液体4-温暖water5两到三手towels6-保湿或手洗剂芦荟，可可或类似成分条件skin7-清晰基地大衣指甲polish8色钉polish9顶大衣指甲polish10小灯泡或其它辐射来源light11桌或书桌等，坐时，你的武器可轻易横跨从宽松立场的一个舒适chair12头发吹干或类似装置13-棉花swabssteps：1-填补托盘用温水和味液(诀窍在于加水只是在合适的温度会软化皮肤无过于炎热，以触摸)2位之一手托盘，让它浸泡几个minutes3如果你给别人一个美人，你可以使用石油或保湿按摩一方面，而另一人是soaking4-清除浸泡手帕特和干手towel5位另一方面，在托盘中浸泡数minutes6尽管二手是浸泡，你应该开始精心修剪角质层，形成围绕边缘指甲本身注：密切注意你在做什么，所以你不减少过于接近，并最终造成皮肤流血。

Mainly use C5 petroleum resins, C5/C9 copolymerized resins and DCPD resins with low softening points, these kinds of resins have very good mutual solubilities with natural rubber particles, No affect to the sulphurization of rubber.

橡胶主要使用低软化点的C5石油树脂、C5/C9共聚树脂及DCPD树脂。此类树脂和天然橡胶胶粒有很好的互溶性，对橡胶硫化过程没有大的影响，橡胶中加入石油树脂能起到增粘、补强、软化的作用。

With the amount of water in your porridge, i am not surprised the you tiao would get soggy in record time!!!!

当然啦！！！！你的粥那么多水，不软化才怪呢！！！！搞不好还会创在最短时间软化的新记录呢！！

The chicory root could be forced better after vernalization with low temperture, otherwise, the quality of chicon was worse.

菊苣根采收以后需要经过一段时间的低温春化处理，才能更好地进行软化，否则软化出的芽球质量较差，重量轻、体积小。

Damage hair is qualitative must first daub of the ability after attenuant emollient , also can allocate with 3 agents, scale chooses according to the damage level of the hair, if discover after bate judgement error brings about bate excessive should pour water instantly, develop the 3rd agent, if the hair is sere only OK redo, if the hair has resembled cotton shrink into oneself is washed-up.

受损发质一定要先稀释软化剂后才涂抹，也可以用三剂调配，比例则根据头发的受损程度来选择，如在软化后发现判断失误导致软化过度则应立即冲水，冲水后涂抹上第三剂，如头发只是干枯则可以再做，如头发已经像棉花一样缩成一团就不行了。

The results showed that the softening point of the asphalts rised linearly as the blowing time last, but the penetration decreased with the increase of softening point exponentially.

结果表明，在氧化过程中，氧化产物的软化点随着氧化时间的延长线性升高，针入度随着软化点的升高呈指数规律下降。

The results show that the mechanical properties of this PMMA depend strongly on the testing temperature. The Young's modulus and flow stress were found to decrease with increasing temperature at low strain rate. At the strain rate of 10^(-1) 1/s, strain soften was observed under all experiment temperatures. At high strain rate, with the temperature increase, the flow stress deceases remarkably while the failure strain increases, and the strain softening was also observed at the temperature above 333K.

试验结果表明：在准静态载荷下，随着温度的升高，材料的弹性模量和流动应力减小，在应变率为10^(-1) 1/s时表现出明显的应变软化行为；在高应变率(550 1/s)下，随着温度的升高，材料的流动应力逐渐减小而破坏应变增大，当温度超过333K时也有应变软化现象发生；在相同温度下，随着应变率的升高，材料的流动应力增大，但破坏应变减小。

ABSTRACT In order to study the thermally activated characteristics of plastic deformation and the effect of alloying element on the thermal activation of structural steels, the properties of plastic deformation for 20g and 13Ni3CrMoV steels have been examined in the temperature of 77—473K and strain rate of 〓. The experimental phenomena show that the effective stress of plastic deformation decreases with the increase of alloying elements content (namely solute solution softening) and the frequency factor deceases with the increase of effective stress.

本文以13Ni3CrMoV钢焊接结构的动态断裂破坏为背景，通过系统测试20g和13Ni3CrMoV钢的动态屈服特性，分析比较了结构钢的形变热激活特点，从频率因子〓随有效应力σ〓增大而下降和合金固溶软化的实验现象出发，在位错以弯折方式克服晶格Peierls位垒的基础上，提出了溶质原子与螺型位错热激活弯折相互作用的物理模型和σ〓-T分段线性关系的形变热激活理论假设，并借助计算机数值模拟，分析探讨了合金固溶软化的微观机制。

The corrosion of demineralized water is discussed through the analysis of the quality of demineralized water and corrosion products.

通过对软化水水质及腐蚀产物进行分析，论述了软化水的腐蚀机理，指出水中的溶解氧和氯离子是造成腐蚀的主要原因。

The capacity of single pile will enhance when the length and diameter of pile increases, but effect of pile diameter is more obvious. While pile diameter increases 20、40 and 60 percents, the capacity of pile will enhance 20.4、53.7 and 78.1 percents. And with the effect of mud-cake, the capacity of single bored pile will fall down nearly 20 percents, and pile-side resistance will also reduce 15 — 35 percents. In the centrifuge tests, when the relative displacement between pile and soil was 45 —85mm, which is much more than the criterions, the pile-side resistance will become most. Meanwhile the intenerated value of utmost resistance is close to the resistance in situ. In the pile group tests, the capacity of pile group , which the space among piles increases from 2D to 3D、 4D and 5D , will enhance 6.1、9.6、18 percents .

当桩径增加20%、40%、60%时，桩承载力分别增长了20.4%、53.7%和78.1%；在考虑泥皮效应后单桩侧摩阻力减小15～35%，极限承载力减小18%～24%，且减小率随桩径的增加而变小；试验中桩身侧阻软化值与原型桩实测侧阻软化值接近，且极限侧阻所对应的桩土相对位移试验要比规范值大得多，约为45～85mm；同时群桩极限承载力随桩距的增大而增加，其中桩距为3D、4D、5D的群桩承载力分别比间距为2D的群桩高6.1%、9.6%和18%；其承载力效应系数η接近或大于1，并随着桩间距的增大而不断提高；群桩侧摩阻力沿深度的分布与单桩略有不同，即桩身上部由于承台的作用，侧阻削弱，但桩身中部侧阻具有增加的趋势。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新