转换程序

In addition, they perform checks on program control to ensure that control transfer always conforms to the ABI.

此外，它们也进行对程序控制的检查，以确保控制的转换总是符合ABI。

This procedure is used C language is to achieve analog signal to di...

本程序是用C 语言实实现模拟信号到数字信号的转换，经过验证。

This procedure is used C language is to achieve analog signal to digital signal conversion, after certification.

本程序是用C 语言实实现模拟信号到数字信号的转换，经过验证。

First, a program which can be used to obtain the encoder values of each joint D. C. servomotor and then change them into angular position is developed. By means of cubic spline, the angular velocity and angular acceleration are calculated.

本文开发了实时采集和转换机器人各关节的码盘值为角位移的程序，并提出了以三次样条函数求各关节角速度和角加速度的方法，提高了计算精度。

Do you need to convert your asp application to an exe executable file so you could do the following?

你需要转换您的ASP应用程序的EXE可执行文件，因此您可以做以下？

This program in assembler language, and its main ...

本程序用汇编语言编写，其主要目的是实现各种数值之间的转换，并显示在屏幕上。

ADC0809 based on the number of assembly language to program mode, to achieve accurate voltage acquisition and conversion.

详细说明：基于汇编语言的ADC0809数模转程序，能够实现电压的精准采集与转换。

With a program written in assembly language,each source statement is converted to a machine instruction by

一个由汇编语言编写的程序，每一条语句都会被编译器转换成机器指令。

Firstly, we research the Vlasov antenna with reflector mainly. A new method to calculate the radiation of the antenna is founded with Vectorial Theory of Diffraction, and the corresponding program is made. The reflective characters of Vlasov antenna are studied with Moment Methods, and the results show that the total reflected energy is less than 0.25%. The radiation patterns of the antenna are analyzed, and the formulas to estimate the wave beam parameters and to design the antenna are provided. The feasibility of radiating high-order modes by Vlasov antenna is also discussed and verified. The hermetization of the Vlasov antenna is researched and the results show that with such kinds of hermetization the antenna can work under gigawatt level. The design of the mode converter from TEM to TMoi is studied, which is useful when the TEM coaxial mode is radiated by Vlasov antenna. At last, the flared-end Vlasov antenna is also discussed.

在Vlasov天线方面：用矢量绕射理论建立了天线辐射场的计算模型并编写了计算程序，该程序计算结果在主瓣上与实验测量吻合良好，近旁瓣也基本一致；利用矩量法计算了天线的反射系数，表明该天线有较小的反射，总的能量反射小于0.25％；详细分析了天线的辐射特性，给出了天线辐射波束相关参数的估算公式和天线设计公式；进一步研究和论证了Vlasov天线辐射高阶轴对称模的可行性；对天线的密封方式和功率容量进行了讨论，结果表明在不需很大密封罩的情况下可以获得GW级的功率容量；为了用Vlasov天线辐射同轴TEM模，研究了TEM-TM_(01)模式转换器的设计，得到了一些基本规律；最后，介绍和分析了带有锥形喇叭的Vlasov天线。

Simulation of robot welding process is completed with the application of ROBOGUIDE, the simulating path is changed to TP program for practical welding, and TP program is transferred to robot controller, which all the work about off-line programming and simulation of the saddle-backed welding seam are completed.

应用离线仿真软件ROBOGUIDE完成马鞍型焊缝曲线焊接过程的仿真，将仿真路径转换成实际TP程序，并输入到机器人控制柜，完成马鞍型焊缝焊接过程的离线编程及仿真，运行TP程序完成马鞍型焊缝的实际焊接。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。