转子的

Experimental synchronous rotor internal mixer and two kinds of 55L synchronous rotor internal mixer, consulted a number of published articles at home and abroad, then, for the first time, formed four kinds of physical model and the corresponding mathematical model which related to the mixed stock between the mixing chamber side and the top of the rotor wing, to the mixed stock between the two rotors and to the mixed stock at the various temperatures of the mixing chamber. And from the character of model, the author gave the relevant analytic solutions and finite element approximation arithmetic solutions during the experimental process of the synchronous rotor internal mixer.

因此，本文作者在XM—1.7实验用同步转子密炼机和两种50L同步转子密炼机上进行了大量的实验，并参阅国内外已发表的文献和资料，首次建立了同步转子密炼机混炼过程中，胶料在转子棱峰与密炼室壁之间、胶料在两同步转子之间和密炼室中混炼胶温度变化的四种物理模型及其相应的数学模型，并根据所建模型的特点，分别给出了相应的解析解或有限元数值解。

Based on the approximation expression of the oil film force of CSFD presented in chapter 6 for the short bearing, effectiveness of the active vibration control of CSFD on the rigid rotor、flexible rotors with one disk and two disks are studied both theoretically and experimentally.

在第六章推导出了CSFD在短轴承π油膜假设下油膜力的计算公式之后，分别从理论及试验两方面详细地分析了CSFD对刚性转子、单盘柔性转子、双盘柔性转子系统的振动进行分段控制的控制作用；讨论了不同的控制规律、切换滞后、切换次数以及转子角加速度等对控制效果的影响，以及在双稳态区切换时转子运动的方向性问题。

First the passivity of motor rotor flux subsystem is proved. Workless forces have no influence on the energy balance equation and have no effect on the asymptotic stability. Then it is discussed that the system can stably track the reference rotor flux without rotor flux observer. At last an adaptive PBC strategy is proposed with regard to the rotor resistance change. A clear and simple design for the speed control subsystem with inner current loops is presented.

证明了感应电机转子磁链子系统的无源性，找到系统能量耗散特性方程中的无功力，它不会影响系统的稳定性，得出无需转子磁链观测反馈即能稳定跟踪转子磁链的参考值，同时考虑电机转子电阻在运行中发生未知变化，设计自适应调节器使系统对转子电阻呈现鲁棒性，构建了带电流内环速度控制系统。

The resection electrode types include: a hand-crafted, temperature-resistant tungsten wire-cutting loop; a coagulating perforated resector that provides a 40% greater coagulation zone than standard cutting loops and performs cutting and coagulation simultaneously during tissue resection; a dimpled vaporization roller that offers a smoother area of vaporization than a grooved roller while providing deep-tissue coagulation; a roller ball and roller barrel, which are used for coagulation and ablation of soft tissue in the bladder and prostate (the roller ball may also be used for endometrial ablation in the uterus); and a Collings knife that allows urologists access to all areas of the prostate and is most commonly used for ureteral meatotomy and transurethral incision of the prostate.

切除电极包括：手动操作、耐受高温、钨丝切除线圈；凝固穿孔前列腺切除器，比标准切除线圈的凝固面积大出40%，能够在组织切除过程中同时进行切除和凝固；一种漩涡汽化转子，比槽式转子提供更加平滑的汽化区域，同时产生深部组织凝固；一个转子球和转子滚筒，用于膀胱和前列腺软组织的凝固和汽化(转子球还可以用于子宫内膜的消融)；一个Collings刀能够帮助泌尿科医生进入前列腺的所有区域，通常用于输尿管切除术和经尿道前列腺切开。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷（附加离心力和附加陀螺力矩），分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数（转速比、机动飞行半径、机动角速度等）对该系统振动特性的影响。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related. Then, SFDs are introduced into typical Jeffcott rotor system. The whole system will be statically displaced in maneuver flight and the nonsynchronous components of oil force appear in the response of rotor system.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷(附加离心力和附加陀螺力矩)，分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数(转速比、机动飞行半径、机动角速度等)对该系统振动特性的影响。

Detailed discussion about distribution and changes of the current in every rotor bar and end ring, the relationship between the number of broken-bar and fault features in stator current after broken bar fault appearing was shown.

转子断条位置对电机影响很大，过去没有引起人们的重视，该文对此进行深入研究，分析电机转子断条位置与故障特征量之间的关系，转子断条位置与转子导条电流、转子端环电流之间的关系，并总结出其规律，指出哪些位置导条进一步断裂的可能性较大。

In the meantime, the difference between a direct integration method and a modality superposition method in the nonlinear solution of large sized shaftings was also investigated. It can be shown that the use of a nonlinear method for solving the kinetics response of a higher dimensional rotor bearing system is both essential and feasible. With regard to the nonlinear kinetics problems of a rotor system the direct integration method is more effective than the modality superposition method. steam turbine, rotor, dynamics, nonlinearity

国内外先后采用非线性油膜力的数值积分方法对转子轴承系统的非线性动力学行为进行了一定研究，但主要集中在简单转子—轴承系统的研究上，在分析上主要采用的是简单离散方法，转子多被简化为刚性转子和Jeffcott转子模型，只能对简单转子—轴承系统的非线性动力学行为进行定性的分析，而对于象汽轮机组轴系这样的高

An auxiliary power motor with improved structure includes wheel shell, rotor ring, stator plate, central wheel axle and control circuit.

一种改良结构的辅助动力马达，包括轮壳、转子环、定子盘、中心轮轴及一控制电路，转子环的内环面埋设磁铁，定子盘周围固设环形矽钢片，其外环面具有多个T形齿牙，其齿数为非转子环磁铁数的公倍数，矽钢片设有三相星形线圈绕组，且于定子盘电机最佳启动角度处设有霍耳元件组；借此将定子盘固设于中心轮轴，令轮壳夹设住转子环并套设于中心轮轴两侧，当转子环旋转时，即可降低磁极间的钝齿转矩，令电动车行进更加顺畅无噪音。

The hybrid induction motor includes a housing; a stator installed in the housing and having a stator core portion and a stator coil portion; a rotor coupling body having a rotary shaft rotatably installed in at the housing, a cage rotor portion rotating integrally with the rotary shaft, and a permanent magnet rotor portion coupled to a circumference of the cage rotor portion with a certain air gap so as to be freely rotatable with respect to the rotary shaft; and a reverse rotation preventing switch, when the rotary shaft rotates reversibly, coming in contact with the permanent magnet rotor portion which is moved along the shaft by thrust generated by the rotor coupling body and cutting off power being supplied to the stator coil portion.

公开了一种混合式感应电机。所述混合式感应电机包括：壳体；安装在壳体中并且具有定子铁心部分和定子线圈部分的定子；篆字联接体，具有可旋转地安装在外壳中的旋转轴、整体地与旋转轴一起旋转的鼠笼式转子部分，以及永磁体转子部分，该部分以一定气隙连接到鼠笼式转子部分的周围以可相对于旋转轴自由旋转；以及防止反转开关，当旋转轴反转时，与永磁体转子部分形成并且切断提供给定子线圈部分的电源，其中当旋转轴反转时，转子联接体产生推力，通过该推力永磁体转子部分与反转防止开关相接触。

I will endeavour to find you some assistance.

我尽力帮你找人帮忙。

At first I only know bruck is the idol of American younglings, afterwards I returned back to Taiwan ,even in Beijing last year ,I saw her poster everywhere, I was so surprised at her charm.

起初我只晓得布鲁克雷德丝是美国少男少女崇拜的偶像，后来回台湾，甚至去年在北京，居然也四处看见她的海报，才惊讶她的魅力之大。