跳的

AIR ALERT 3 EXERCISES plan three vertical jump programs vertical jump and vertical jump program 2 in 3 In addition to the following item - squat ...

AIR ALERT 3 EXERCISES 纵跳计划3 纵跳计划3与纵跳计划2在除了下面的这个项目－蹲。。。

The problem is that to represent a pretested loop the assembly language code must contain two jump instructions: a conditional branch instruction in the beginning (that will terminate the loop when the condition is no longer satisfied) and an unconditional jump at the end that jumps back to the beginning of the loop.

因为 为了实现预测试循环汇编语言中必须包含两个跳转指令：一个条件跳转指令用以跳转到循环开始的位置(该条件指令也起着条件不被满足时中止循环的作用)；另一个是结尾处的一个无条件转移指令以便跳转回循环起始处。

The flags are checked by conditional jump instructions, which jump or not depending on the type of jump and

条件跳转指令检查这些标志，跳不跳转，依赖于跳转的类型和这些标志的状态。

The flags are checked by conditional jump instructions, which jump or not depending on the type of jump and the status of the flags.

条件跳转指令检查这些标志，跳不跳转，依赖于跳转的类型和这些标志的状态。

We feature the most commonly used is the BIOS jumper jumper jumper and sound, and operating principles Ibid.

我们最常用到的跳线功能就是BIOS跳线和声卡跳线了，操作原理同上。

So if you want to use a jump instruction to reach exception_address, it should be a simple jump, not a jump to subroutine.

所以如果你想使用一个跳转指令到达 exception_address，它应该是一个简单的跳转，而不是跳转到子功能调用。

Wire jump prevente : The wire jump preventer (wire roller-NT series) is used for a radical change of direction and adequate guidance and prevent the wire jumping during the winding process.

防跳线器：防跳线器用于漆包线大幅度改变方向及作适量导向和防止绕线过程中的跳线。

The relation between the movement parameters in the flow field of jig could be obtained by the Navier-stockes equation of fluid dynamics. The fluid in different jig structure dimension and shape could be calculated and diagrammed by use of calculate fluid mechanics and potential motion theory. The flow field and streamline of jig at different case are expressed vividly, which could provide rational basis for selecting and designing jig structure.

由流体运动的Naver-Stockes方程得到跳汰室内的流场运动参数间的关系，用势流理论对运动流场进行研究，通过计算流体力学方法对流体运动参数在结构不同的跳汰机的跳汰室内的流场进行了绘图，形象地把不同结构的跳汰室的流场、流线体现出来，可为合理选择跳汰机结构提供依据。

Hard disk of the master-slave jumper settings are generally in the hard drive's power cord jack and data jack line between the local, usually from 3-4 group together with jumper jumper cap 1-2 composed of a positive in the hard disk or the opposite is also printed on the main disk, from the disk, as well as by the cable select method of the jumper, as long as the icon of the jumpers in accordance with the method, you can set arbitrary to set the hard disk or from disk-based disk.

硬盘的主从盘跳线一般都设置在硬盘的电源线插孔和数据线插孔之间的地方，通常由三到四组跳线再加上一到两跳线帽组成，在硬盘正面或反面还印有主盘、从盘以及由电缆选择的跳线方法，只要按照图示的跳线方法，就可以随心所欲的设置将硬盘设置为主盘或者从盘。

First the unknown signals were separated by joint approximate diagonalisation of eigen-matrices algorithm. Then the method used the smoothed pseudo Wigner-Ville distribution of each separated FH signal to estimate its transmission parameters such as hop duration, time-offset and hopping frequency pattern.

首先采用特征矩阵联合近似最优化算法分离跳频信号，再利用多窗口重叠的平滑伪Wigner-Ville分布来估计出跳频信号的跳周期、定时偏差和跳频频率等参数。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。