距

Quality of sliver forming is tested using Uster AFIS single fiber testing system under different integrated conditions for the rear hood of the card A186F equipped with back teeth guided flat with cotton web cleaner for the 3-step gauges and cotton web cleaner for 4-step wind throughput.

为了研究棉网清洁器反齿导向盖板隔距大小和风量大小组合对生条质量的影响，采用Uster AFIS单纤维测试系统，对A186F梳棉机后罩板采用棉网清洁器的3档反齿导向盖板隔距和4档棉网清洁器风量，在不同组合条件下生产的生条质量进行了检测，检测结果显示，过大与过小的反齿导向盖板隔距对生条质量均有不利影响。

Of root biomass was distributed in the soil 0～20 cm deep, 69.93% of that in the area 40 cm horizontally away from stem; 92.07% of leaf biomass on the plant part 3～6 m high from ground, 83.80% of that in the area 1 m horizontally away from stem; 84.05% of the stem and branch biomasses in the area 0.5 m horizontally away from stem.

97.48%的根集中于0～20 cm土层，69.93%的根分布于距干基40 cm的水平范围；92.07%的叶分布于3～6 m的垂直范围，83.80%的叶分布于距干基1 m的水平范围；84.05%的干枝分布于距干基0.5 m的水平范围。

By implementing immersion lithography, Matsushita/Panasonic has achieved the smallest minimum metal patterning that we have seen to date, at 67-nm M4 half-pitch.

由于使用了浸入式光刻，松下实现了至今为止最小的金属布线，第四金属层半节距为67nm（两条布线中轴的距离为节距，按布线宽与隔离空间各一半算的话，布线的实际宽度为半节距）。

The commonly-used capacity calculation approaches for ramp junctions are mostly based on the American HCM method, It had been approved that the headways for vehicles following the Weibull distribution function at on-ramp junctions in urban freeway system. The paper examined the critical headway and following time by the modified drew method and the survey traffic flow data on-site. The gap-acceptance capacity calculating model was developed for on-ramp junctions of urban freeway, and the numerical integration method was used to solving the model. Finally, the capacity values were obtained in condition of different mainline design speeds and different acceleration lane lengths.

针对目前国内外匝道连接段通行能力计算以美国HCM为主的现状和不足，研究发现城市快速路入口匝道连接段车头时距服从Weibull分布规律，利用改进的Drew方法及实际现场调查交通流数据确定了临界车头时距和随车时距，建立了城市快速路入口匝道连接段通行能力的间隙接受计算模型，并利用数值积分法进行计算和求解，从而得到了主线不同设计速度及不同加速车道长度条件下的城市快速路入口匝道连接段可能通行能力值。

The results showed that the population density of Kyang was significantly lower within the area of 0-500 m than of 1 001-3 000 m from QTH, indicating the shyness of Kyang to the highway. QTH also had definite disturbance on the activities of Tibetan antelope and Tibetan gazelle. Especially for Tibetan antelope, its moving, feeding and alert behaviors had a significant difference between the areas of 0-500 m and of 〉 2000 m from QTH.

结果表明：藏野驴对青藏公路形成了回避，其在距路基1 001～2 000和2 001～3 000 m区域内的种群密度显著高于0～500 m的区域（P＜0.05）；青藏公路对藏羚羊、藏原羚的行为活动产生了一定程度的干扰，尤其是对藏羚羊，其在距路基0～500 m区域内的行为活动与距路基2000 m之外的区域具有极显著差异（P＜0.01）。

10 P.m.-- When I bypass the last watchtower which is 700m from the confluence, I excitement rush down the hill, holding the GPS, and headed out to the spot, I was too busy to say hello to the local rustics who were ingathering potatoes on the hillside, following the GPS pointer from 200, 100, 70,20, at the spot even showed within 1 m, I succeed hunting my first confluence.

5：10 p.m。--当我绕过最后一个距汇交点最近的烽火台时，GPS显示汇交点就在距此偏西北700多米的距离了。我兴奋地冲下山直奔它，山坡上农民正在收获土豆，我已顾不上和他们打招呼，手持GPS直奔那点，GPS也迅速显示距该点从200，100，70，20，到最后竟然闪过精度不到1米，我成功了。

Transportation Advantages:① 40 kilometers away from the central city of Lianyungang, from the county 20 kilometers ,away from Qingdao, Shanghai, Nanjing, 2-4 hours at the scope of the traffic circle.

交通优势：①距中心城市连云港40公里，距县城20公里，距青岛、上海、南京分别在2—4小时的交通圈范围。

This paper gives a thoeretical analysis on the standard currently adopted in China for the widening of railway track gauge on curves, and points out that this atandard does not tally with the railway oparational actuality, the calculation data used are not in conformity to the present rolling stock conditions in this country and that the marginal radius and the amount prorided for the widening of curved track gauge are on the large side.

本文对我国现行曲线距轨加宽标准进行了理论分析，指出它脫离运营实际，而采用计算数据又不符合我国现有车辆情况，加宽起始半径和加宽值都偏大。提出在理论上比较切合实际的计算方法是车辆按力学自由內接条件计算；机车和少数固定轴距大的车辆，按最小运营半径条件检算，制订我国的曲线轨距加宽新标准。

The company is located in the town of Ware ---- Wenzhou Haicheng District Lantau door industrial zone, 10 kilometers away from Wenzhou airport, 15 kilometers from Wenzhou port, away from the 104 National Road Line 5 kilometers, transportation is very convenient, the company main products Jingyi Series faucets, towel racks, toilet, bathroom cabinet, the whole body shower room, bathtub and other companies to carry forward and never met the spirit of perseverance and even industry, following the people-oriented, technological innovation, quality win, clients supreme business philosophy, adhere to quality-oriented, forge ahead, strive for perfection and create first-class brand of the enterprise purpose, after ten years of diligent entrepreneurial excellence, and accumulated a wealth of professional production experience, to introduce and cultivate a variety of professional and technical personnel, it is fine Arts companies have sophisticated technical equipment, advanced manufacturing technology, strict testing means, a sound management system, excellent after-sales service, and in 1999 through ISO9002 international quality assurance system certification.

公司坐落在洁具之乡----温州市龙湾区海城屿门工业区，距温州机场10公里，距温州港口15公里，距104国道线5公里，交通运输十分便捷，公司主要产品为精艺牌系列水龙头，毛巾架，座便器，浴室柜，整体淋浴房，浴缸等公司发扬永不满足、锲而不舍的什业精神，遵循以人为本、科技创新、以质求胜、客户至上的经营理念，坚持质量为本、锐意进取、精益求精、创一流品牌的企业宗旨，历经十多年的勤奋卓越的创业，积累了丰富的专业生产经验，引进和培养了各类专业技术人才，现精艺公司具有精良的技术装备、先进的制造工艺、严格的检测手段、健全的管理制度、优良的售后服务，并于1999年通过ISO9002国际质量保证体系认证。

Linzhou is a developing city which has flourshing communication,a good transport service,and abandant natural resources of low phosphorus,low sulphur and iron ore.

牋 河南龙鼎铸业股份有限公司位于举世闻名的铸造之乡——河南省林州市，河南、河北、山西三省交汇处，距京广铁路、京珠高速50公里，距天津港5小时车程，距新郑国际机场3小时车程，通讯发达，交通方便，并拥有丰富的低磷、低硫、铁矿资源，而且毗邻富产煤炭的山西省，占有天时、地利、人和的价格优势。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。