超声波

This paper applied the cross correlation method to measure the flow speed, and verified its feasible.

本文运用相关分析方法测量流速和流量，证明了超声波相关法测量流量的可行性。

Ultrasonic measurement method is a new one. It has many advantages, such as, not changing the profile of the flow and characters of the fluid, non-invasion, no pressure losing and can work under the severe conditions. Collecting the flow noise signals at the upstream and downstream of the pipe, adopting the cross correlation method to analysis signals, calculating the cross correlation function and finding the peak of it, then we can get the transit time.

超声波流量测量具有不改变流动状态与性质、非接触、耐恶劣环境等优点，通过对所采集的上、下游流动噪声信号进行相关分析，其互相关函数的峰值位置所对应的时间，为流体流过上、下游传感器之间的距离所用时间，进而计算出流速和流量。

Put die on the die seat, adjust cross- plate and transducer draging plate of up and down, so that the steel needle can be inserted into die hole to adjust the pressure of weight, and then place the abrasive, open power switch of ultrasonic and rotating switch of die seat.

模具放在模座上，调节十字脱板及换能器上下拖板，使钢针插入模孔内，调整砝码压力，然后放上磨料，打开超声波电源开关和模座旋转开关。

Firstly, variables which were acquired for the above two kinds of classification system were obtained from field and laboratory investigation of the core samples as well as test of supersonic waves in drilling holes. Secondly, distribution functions and parameters of all variables are determined using statistic method. Thirdly, 20000 RMR values or BQ values and cumulative distribution function of these RMR or BQ values have been obtained utilizing Monte—Carlo method and the results are plotted. Finally, risk analysis can be made from above results.

风险评价方法步骤如下：（1）首先通过岩芯样品的现场观测和实验室试验及钻孔岩体超声波测试获得两种分类所需的变量；（2）通过统计分析和判断得出各变量的分布函数及参数；（3）运用Monte—Carlo模拟方法获得2万个RMR值或BQ值及相应的累积分布函数，并将结果绘成岩体质量描述图；（4）运用以上结果作出岩体质量风险分析。

In the simulation, the flow rule of melt metal in mold of horizontal continuous casting with electromagnetic stirring is measured using ultrasonic Doppler velometer, and the result is inter confirmed with the solidification characteristics is tics of zinc cupronickel thin slab in industrial product, some advantageous results are obtained that, when the current is 400 A the inner micro-pores disappear, when the current is 500 A the center equiaxed crystal layers occur and when the current is to 800 A the inner-segregation decreases to zero.

在模拟实验中，用超声波多普勒测速仪测量该电磁搅拌下水平连铸结晶器内金属液的流动规律，并与生产实验中锌白铜板带的凝固特征相互印证，发现搅拌电流达到400 A时，板带内部气孔消失，电流达到500 A时板带出现等轴晶带，电流达到800 A时板带坯偏析率趋于零。

objective to study the changes of nux vomical curare fluid permeating biomembrane by the use of same amounts and different time of ultrasonicwave.

目的：研究中药马钱子液在同功力不同时间的超声波作用下透过生物膜量的变化。

Could you please say something more about ultrasonic curettage?

您能再变谈超声波洁牙吗？

N The ultrasonic cleaning option is used to continuously clean the flow through cuvette, it is not intended to clean cuvettes that are already dirty, or to replace manual cleaning entirely.

超声波清洗选项用于连续清洁测量杯，它不能清洗已经脏了的测量杯，也不能代替手动的清洗。

Furthermore, this paper explored a new feasible process of cyanide recovery,investigated the effect of time, concentration of H2SO4 and temperature on the elution of cyanide and zinc in the process of first stage elution, and discussed the effect of time,concentration of ammonia water, temperature and ultrasonic on the elution of copper in the second stage elution.

另外，本实验探索出一种可行的回收氰化物新工艺，在硫酸解吸过程中，研究了硫酸解吸的时间、浓度和温度因素对氰和锌的解吸率的影响；在氨水解吸实验中探讨了时间、温度、浓度、超声波等因素对铜解吸率的影响。

A sectional hyperbola cylinder sound lens using for oil recovery is designed according to the refraction law of sound.

对于一定的油井，无法改变油井中的原油及其岩层对超声波的衰减作用，但是，利用声透镜可以改变超声换能器所辐射出的超声

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。