负载电压

These converters are characterized by their large voltage conversion ratio, high output voltage.

它是为满足参量阵声纳的现场使用而研制的，同样适用其他场合变换器有四个特点：变换比大；输出电压高；负载电流大；开关频率高。

Otherwise, the load components receive the same harmonically-rich voltages and the lines see the same currents as in a three-wire Y system.

以别的方式，负载成分调和地接到一样的-富有的电压和线见到那同一的涌流当做在一个三电线的 Y 系统中。

With this method the copper plating graphite powder was made up in 50% copper content .The silver- copper plating graphite composite was prepared while the silver- copper-graphite composite and the silver-graphite composite were also made up together .The mechanical and electric characteristics of the three kinds of composites were tested and it was found that the copper plating graphite powder can only optimize the properties of the silver matrix composite under the high content of the graphite ,the conductivity and the mechanical property was improved and the material could take higher current in the same carbon content .At 20% carbon content, the resistivity of Ag-graphite composite was 1.67 times as high as that of silver- copper plating graphite composite, the resistivity of Ag-Cu-graphite composite was 3.23 times as high as that of silver- copper plating graphite composite. The bending strength of silver-copper plating graphite composite was 2.17 times as high as that of silver- copper-graphite composite, and the bending strength was 2.11 times as high as that of silver- copper-graphite composite. The wearability of silver- copper plating graphite composite was also enhanced greatly at high carbon content.

利用该方法制备了50%铜含量的镀铜石墨粉，然后进一步制备了一系列相同碳含量的银-石墨复合材料、银-铜-石墨复合材料、银-镀铜石墨复合材料，对三种材料的机械、电气性能进行了综合对比，发现在低碳含量时镀铜石墨粉不能改善复合材料的上述主要性能，而在中高碳含量时则能明显优化复合材料的整体性能，提高了复合材料的电导率，使复合材料在中高碳含量时既具有较高的耐磨性同时也能负载较大的电流，复合材料的机械性能也因镀铜石墨粉的加入而大幅提高，20%碳含量时，银-石墨复合材料的电阻率是银-镀铜石墨复合材料的1.67倍，银-铜-石墨复合材料的电阻率为银-镀铜石墨复合材料的3.23倍，银-镀铜石墨复合材料抗弯强度是银-铜-石墨复合材料的2.17倍，是银-石墨复合材料的2.11倍，同时，在实验给定的条件下，中高碳含量时银-镀铜石墨复合材料的机械磨损耐磨性和通电磨损耐磨性都得以显著提高，银-镀铜石墨复合材料在实验时的接触电压降也更为稳定。

The article shows a new kind of power controller of micro-satellite. The controller is composed of charge control. Discharge control, shunt control and the equilibration circuit. The output voltage is stabilized by an automatic circuit controlled by the PWM signal, which is produced by comparing the sampling value of the output voltage with the reference voltage. The application indicates that the system which insured the safety property of Li-ion battery series runs stably as well as satisfied the need of the load no matter in what situation.

在我国航天用锂离子电池组控制电路研究相对落后的背景下，设计一了种新型的微小卫星电源控制器；该电源控制器包括充电、放电、分流和均衡保护部分，充电、放电、分流部分通过将母线电压的采样值与预设参考值比较产生PWM信号对制电路进行自动调节，均衡通过采样和处理器计算比较实现；实验结果表明，该控制器工作稳定，确保了锂离子电池组工作安全的同时，很好地满足了各种情况下母线负载的需求。

Based on the electric inertia system, we build a simulator to validate the feasibility of the control method which alters the setting voltage of the current circle in the torque current heft.

根据电惯量系统建立仿真模型，验证改变转矩电流分量的电流环给定电压来实现电惯量的可行性，通过突加负载和改变转速给定来研究加入单神经元自适应控制器后系统的控制效果。

In order to improve the power parameter further,the intermediate frequency inversion of an electric voltage power type series resonance and frequency trace technique are adopted.

为使系统的功率因数较高，采用电压源型负载串联谐振中频逆变器和频率跟踪技术。

Additional efficiencies are achieved through maintaining the voltage ripple across the fly capacitor and/or the load capacitor.

通过保持快速电容器和/或负载电容器两端的电压波动来获得额外的效率。

When the system starts, the speed outer ring saturats non-functional, the current inner ring plays a major role to regulate the starting current to maintain the maximum so that the speed linear change, to reach a given value; when it operates steadily, the speed negative feedback from the outer ring plays a major role ,to let the speed changes with the given speed voltage , at the same time the current inner ring regulates the armature current of motor adjustment to balance the load current.

该系统起动时，转速外环饱和不起作用，电流内环起主要作用，调节起动电流保持最大值，使转速线性变化，迅速达到给定值；稳态运行时，转速负反馈外环起主要作用，使转速随转速给定电压的变化而变化，电流内环跟随转速外环调节电机的电枢电流以平衡负载电流。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐