负载电压

The VCO core uses a differential topology to provide a stable frequen- cy versus supply voltage and improve the immunity to load variations.

VCO的内核采用了微分拓扑提供一个稳定的同步周期- cy的改善与电源电压和负载变化的免疫力。

Here, the discrete ON or OFF state of the modulation itself can be used to control the switches, thereby controlling the voltage or current across the load.

在这里，离散的开或关的状态调制本身可以被用来控制开关，从而控制电压或电流负载。

D. Applications, characteristics, sizing and selection of different types of cables/overload lines with due considerations to load factor, diversity factor, power factor, voltage drop and maximum demand of the installation.

各种电缆/架空电缆的应用、特性、尺寸定位和选择，必须适当考虑有关负载系数、不等率、功率因数、电压降及装置的最大需求量等因数。

It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor.

即以水阻作为负载，模拟机车运行，对机车的主发电动机的电流、电压和柴油机的转速等参数进行检测，并对检测结果进行处理，计算出模拟机车运行时的功率，并以此为依据，对机车的工作状念进行判断，通过水阻试验，调整有关参数，使机车运行时能发挥所要求的功率和满足规定的工作特性。

SN54LS596J is a monolithic, high-voltage, medium-current power logic 8-bit D-type latch, with eight positive edge-triggered D-type flip-flop, there is a direct clear-side, each flip-flop is the drain Open power DMOS transistor output, can provide 150mA continuous current, for the need for relatively high load power system design.

SN54LS596J是一种单片、高电压、中等电流的功率逻辑8位D型锁存器，具有8个正边沿触发的D型触发器，有一个直接清零端，每个触发器都是漏极开路功率DMOS晶体管输出，能提供150mA连续电流，专为用于需要相对高的负载功率的系统设计。

Theresults show that the electron mean drift velocity is affected by the cathode radius, theimpedance of the load diode, the inner radius of vanes and the input voltage.

结果表明电子平均漂移速度决定于阴极杆半径、负载二极管阻抗、阳极慢波叶片内径和输入电压。

This constant emitter current, multiplied by a constant α ratio, gives a constant collector current through Rload, provided that there is enough battery voltage to keep the transistor in its active mode for any change in Rload's resistance.

这个恒定的发射极电流，乘以恒定的系数α，就得到流过负载Rload的恒定的集电极电流。前提是电池电压足够高，不论Rload如何变化，晶体管都能工作在放大区。

Furthermore, the process of proportion resistance in the feedback circuit is changed, and the change of sampling voltage with sampling resistance is compensated with resistor. The impact of environment temperature on loading capacity and peak current is reduced.

此外，对反馈环中的比例电阻采用不同的工艺制作，通过电阻的温度系数补偿由采样电阻随温度变化所造成的采样电压的变化，减小温度对电路的带负载能力和峰值电流的影响。

Because of this circuit has free-wheeling loop, even to the perceptual load, the output voltage waveform nor distortion.

由于该电路具有续流回路，即使对感性负载，输出电压波形也不会畸变。

It measures each temperature with heat-resistance, and measures electric current and the voltage with Hall sensor,and measures pressure with pressure sensor,and measures rotational speed of diesel engine indirectly through analyzing output wave shape.

第二章概述了干阻负载试验中各项参数的检测原理，以及被测参数的检测方案设计，用热电阻等测量各处温度，用霍尔传感器和钳形表测量电流和电压参数，用压力传感器测量压力，通过对输出波形的分析来间接测量柴油机的转速等内容。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。