负载

Since the load is applied by a contact surface with small touching areas at the beginning no initial velocity distribution is required .

由于负载由具有应用在小接触区的接触面开始没有初始速度分布是必需的。

Measurements from voltage sources with high internal resistance are subject to a number of errors, such as loading errors from the voltmeter's input resistance and input bias current, as well as from external shunt resistance and capacitance.

对高源内阻电压源的测量容易产生几种误差，诸如：电压表输入电阻和输入偏置电流以及外部分流电阻和电容引起的负载误差。

Therefore, these converters provide a low-ripple power over broad ranges of input voltage and load current.

因此，这些转换器可提供比输入电压和负载范围广泛的低纹波电流。

Given that V2 is applied to the amplifier input lead, the high input resistance of the operational amplifier is the only load on V2, and the only current drawn from the source is the very low input offset current of the operational amplifier.

若V2加到放大器的输入端，运算放大器的高输入电阻成为V2的唯一负载，而且唯一从源吸取的电流是运算放大器非常低的输入偏置电流。

Thus, input resistance loading would result in an error of 1% in this example.

这样，在这个例子中，输入电阻的负载效应将产生 1%的误差。

As in the case of input resistance voltage loading, the shunt resistance and the source resistance form a voltage divider that reduces the measured voltage as follows

和输入电阻的电压负载作用一样，分流电阻和源电阻也形成了一个分压器，并将测量的电压衰减如下

To minimize circuit loading, the input resistance of an

为了尽量降低电路负载，安培计的输入电阻应当很小以便降低输入端压降（V2）。

However, research shows that when the measurement signal is very small, a differential amplifier consisting of one OP amplifier can easily cause load effect due to low input resistance and signal voltage decline.

不过，研究显示，当测量信号，是非常小差分放大器组成，其中运算放大器可以很容易造成负载效应，由于低投入及抗病信号电压下降。

Voltage measurements from high resistance sources are subject to loading errors from the meter input resistance, as well as the leakage resistance ofthe connecting cable.

对高内阻电压源的测量容易产生由仪表输入电阻和连接电缆泄漏电阻引起的负载误差。

The experimental results shows the converter has a good performance of input capacitor voltage balancing and load sharing..

实验结果表明所采用的方法使变换器具有良好的动态均压与负载均分特性。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。