负载

The method selected will depend on the speed-load coefficient of friction requirements of the application.

该方法将取决于选定的速度负载的摩擦系数要求的申请。

This paper introduces the research results of techniques of testing PC pump oil well through one-year efforts. Which covers the mathematical models of a number of force characteristics strength analysis, and resonance critical problems of rotation rod-string in PC pump wells: resulting of testing method of polish-rod load and rotation rate on the basis of feasible demonstration and technical requirement analysis; study and manufacture of system of testing PC pump well, which involves sensor, collector ring, acquisition circuit and computer; research and determination of assistant technology of testing force on rotation polish-rod and formulation of testing force on polish-rod. A spot testing has been carried out by means of the above research fruit and good results have been achieved.The success testing results in has laid a strong foundation for the oil well diagnosis.

本论文介绍了对螺杆泵采油井的研究成果，其内容包括，对螺杆泵采油井中的旋转杆柱的若干受力特征、强度分析方法及共振临界问题进行数学建模；在可行性论证和技术需求分析的基础上，研究产生了对油井进行光杆负载和旋转速度测试的办法；研究制作了螺杆泵采油井测试系统，它包括传感器、集流环、采集电路和计算机等；研究确定了对实施旋转光杆测力的辅助工艺；制定了对光杆受力进行测试作法，利用以上研究成果实施了现场测试，并取得了理想的结果。

Model structure form of photoelectric tracking platform mainly includes: adjust flat framework, base, perpendicularity axis, level axis, collimate framework and machine design of left or right load.

型结构形式的光电跟踪平台主要包括调平机构、底座、垂直轴、水平轴、照准架、以及左右负载部分的机械结构设计。

However, this is rare and in fact it's common for multiple developers to share the load.

然而，这是罕见的，实际上它的多个开发人员共同分担负载。

In order to drive a high impedance load such as HPM sources, it is necessary to commutate FCG's long pulse width, high-current and low voltage pulse to a short pulse with high voltage.

为用FCG驱动象HPM源这样较高阻抗的负载，必须使用脉冲功率调制电路把FCG产生的低电压、大电流、上升时间长的电压脉冲转化为高电压、上升时间短的脉冲。

The speed of this type of motor is controlled by the load and position of the commutator brushes.

在这种类型发动机的转速控制负载及整流子电刷的位置。

In order to eliminate the influence caused by the nonminimum phase characteristic of a common Boost DC／DC converter, Viswanathan K has proposed a novel tristate Boost DC／DC converter. For enhancing performance, the statespace averaging model of this converter was first presented in this paper. Due to the nonlinear nature in this model, an inputoutput feedback linearization technique was adopted, and a complete controllable linear system was obtained. Then a statefeedback control strategy was designed based on this linear system. Simulation results show that the proposed control strategy can assure constant output voltage in a wide range, so as to realize the stability of the system during large fluctuation of power supply and load disturbance. Good dynamic performance can also be achieved.

针对 Viswanathan K为消除普通BOOST DC／DC变换器的非最小相位特性而提出的三态Boost DC／DC变换器，为进一步提高这种电路拓扑的性能，在建立了变换器状态空间平均模型的基础上，针对其多变量、非线性特点，采用输入输出线性化将其转化为一个完全可控的线性系统，在此基础上应用现有成熟的线性控制策略进行了控制系统的设计，并且采用MATLAB进行仿真验证，结果表明：这种非线性控制策略可以确保输出电压在大范围内恒定可调，且即使存在大范围扰动(输入电压和负载变化均较大)的情况下，系统也可以确保稳定性和良好的动态性能。

In the algorithm designed here, polygon-fill algorithm and "Painter Algorithm" are used to display 3-D isoline," Windup Storage" method to balance computer processing load,"Associative Fan in" method to conflate results, and "Run Length Compression" method to save network communication time.

根据等值线数据量随其属性值而变化的特点，设计了采用"卷帘存储法"实现负载平衡的等值线三维显示的并行算法；采用"结合扇入法"实现结果合并，并采用"运行长度压缩法"以缩短网络通讯时间。

In the algorithm designed here, polygon-fill algorithm and "Painter Algorithm" are used to display 3-D isoline,"Windup Storage" method to balance computer processing load,"Associative Fan in" method to conflate results, and "Run Length Compression" method to save network communication time.

运用多边形填充和"画家算法"，实现了等值线三维显示；根据等值线数据量随其属性值而变化的特点，设计了采用"卷帘存储法"实现负载平衡的等值线三维显示的并行算法；采用"结合扇入法"实现结果合并，并采用"运行长度压缩法"以缩短网络通讯时间。

That would mean the so-called roads of national significance will be congested in no time at all.

而这意味着我们所谓的国道将根本来不及消化那么庞大的负载。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。