负载

This topic returns in view of the cut type switch spreads the type switch "to return for the predecessor design spreads the type electric power switch utilization in the LED lamps and lanterns" is the research direction, to achieve take reduces the power loss to replace the tradition operational amplifier pulse wave width accent as the goal using IC UC3842 changes part, the actuation returns spreads the type electric power switch's switch of Power MOSFET, so as to controls instead spreads the type electric power switch breakover closure's time then control voltage output size, achieves the output voltage to the load LED lamps and lanterns adjusts the LED lamps and lanterns brightness the goal.

各位大大抱歉~！因为英文底子不好！希望大家帮忙翻译一下，希望不要用翻译软体翻的最好是自己翻！拜托了！本专题针对切换式转换器的返驰式转换器为前身设计「返驰式电力转换器运用在LED灯具」为研究方向，为达到以减少功率损失为目的利用IC UC3842代替传统运算放大器脉波宽度调变部分，驱动返驰式电力转换器的Power MOSFET之开关，藉以控制反驰式电力转换器导通截止的时间进而控制电压输出的大小，输出电压至负载LED灯具达成调节LED灯具亮度的目的。

The simulation model of three-phase bridge controlled rectifier circuit is constructed based on Matlab/Simulink.

应用Matlab的可视化仿真工具Simulink建立了三相桥式全控整流电路的仿真模型，在此基础上，对三相桥式全控整流电路的输出电压与控制角以及负载特性的关系进行了详细的仿真分析。

In this paper, on the basis of circuit analysis, the relationships between the output voltage and flow angle and load characteristics in the three-phase bridge fully controlled rectifier circuit were studied using simulation software Simulink based on MATLAB.

本文在对三相桥式全控整流电路的输出电压与导通角及负载特性的关系进行分析的基础上，采用Matlab的可视化的仿真工具Simulink对其进行了仿真研究。

In the paper,connection of bridge rectifier in rotor,arrangement of winding in the stator and the rotor,analysis of performance of the generator nonloaded and fully-loaded and design characteristic of the generator series are discussed respectively.Some considerable problems in design and m...

着重介绍了该发电机转子旋转整流电路的接线方式和定、转子绕组结构，分析了发电机在空载和负载2种情况下的运行特性以及该系列发电机的设计特点，指出了采用该励磁方式的单相交流同步发电机在设计和制造过程应注意的问题。

The structure of the device is briefness and prone to enlarge power,and the precision of discharge current is high.

其结构简单，放电电流控制精度高，负载调节范围大，体积小，可靠性高。

Stopping or positioning force is the effort required to bring the load to a halt or position it in a specific place.

停止或定位的力量是必要的努力，使负载停止或立场，它在特定的地方。

While your PC is bruting away, a CPU monitor shows you the load on the system.

当你的电脑打边消失，一个CPU监视器显示您系统上的负载。

The burst mode is entered to achieve high efficiency when working in the light load condition.

轻负载条件下引入突发模式可实现系统的高效工作。

In this paper, oligomerization catalyst was prepared by impregnation and the performance of Fe-Ni catalyst was studied for mixed butene oligomerization.The effect of preparation conditions, reaction conditions and molding methods of powder catalyst was separately studied on the performance of mixed-butene oligomerization.

本文采用浸渍法制备了齐聚催化剂，考察了负载型Fe-Ni催化剂在催化混合丁烯齐聚反应中的性能，研究了催化剂的制备条件、反应条件和成型等对混合丁烯齐聚性能的影响。

For this reason, butterfly valve can only be used for load fixed occasions.

由于这一原因，蝶形阀只能用于负载固定不变的场合中。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。