负载

In order to achieve load balance in task scheduling under the grid environment, in view of the resources' autonomy, isomerism and distribution under this circumstance, a model of resources real-time prediction was designed based on improved GM (1, 1) prediction method, which could get satisfied load balance with smaller expenditure.

为了达到网格环境下任务调度时的负载平衡，针对此环境下的资源的自治性、异构性和分布性等特性，利用改进的灰预测模型GM(1，1)预测方法，设计了资源实时预测模型，可在较小的开销下取得满意的负载平衡。

Moreover, we mensurate the reactances ofthe experimental motor by the way of direct Joad method, and verify the vaIidity of"electromotive force method ".

文章还运用直接负载法测定出样机在不同负载下的电抗参数，验证了"电势法"的正确性。

Load balancing mechanism is an approach to improve the overall handling capacity of the cluster, but the unreasonable structure of the clusters tends to limit the efficiency of load balancing mechanism. Incoordination between the two limits the performance of system hardware and software.

负载均衡机制是一种用于提高集群整体处理能力的方法，但是不合理的集群结构往往会影响负载均衡机制的效率，两者的不协调在一定程度上限制了系统性能的体现。

But disconnect the load and the output correctly, in the time, I fail to understand why it suddenly occurred to power does not output voltage may also be due to eircuit the power protection, since switching power supply does not have the problem, according to the circuit diagram check switching power supply external power supply module one by one, if the hinge-counter, discovered its signal line wrap wire close to counter one end of the triadha into the signal lines, causing a short circuit input line.

可是断开负载，其输出正常，在百思不得其解之时，笔者突然想到电源不能正常输出电压也有可能是由于负载短路使电源保护造成的，既然开关电源本身没有问题，按照电路图检查开关电源外围的供电模块逐一排查，当检查到折页计数器时，无意中发现其信号线外缠绕的钢丝线接近计数器的一端扎进了信号线中，造成输入线短路。

Through mathematical reasoning, this article found the relationship between the output voltage and the load, the curve of the generator external characteristic being provided.

本文运用数学推理的方法找出了同步发电机的输出电压与负载电流及负载性质之间的关系，确立了发电机外特性曲线的具体形状。

VVVF control through the pump motor so that the load curve in line with or near air-conditioning load curve of the host.

通过变频调速控制使水泵电机的负载曲线符合或接近空调主机的负载曲线。

Relative study indicate that current doubler rectifier is misfit for high-voltage low-current apply.so This paper proposes a auxiliary net ZVS PWM full-bridge three-level converter, its" improved topology structure and its"topology family in different controlling mode. The principle of these converter is analyzed in detail. Simulation results verify the effectiveness of the proposed converter.

为了进一步简化辅助网络的结构，并解决轻载时，超前桥臂实现软开关困难的问题，提出了一种新型宽负载范围辅助电感ZVS PWM三电平全桥直流变换器，它在基本拓扑结构的基础上只需增加一个辅助电感，利用辅助电感的能量就可以实现宽负载范围内所有开关管的软开关，详细分析了该变换器的工作原理，进行了参数设计和仿真验证。

Next, the following points are emphasized:(1) The design of photoelectric conversion preamplifier circuit. In order to improve the measurement accuracy of luminometer and ensure linear relationship of the photoelectric, operational amplifiers is designed as current-voltage converter form, on the one hand, it is available to zero-load effect; on the other hand, short-circuit current can be transformed into a voltage volume through the feedback resistor, it is equivalent to voltage drop flowed through a load resistor on the actual effect.

其次，本文重点做了以下工作：(1)光电转换前置放大电路的设计：为了提高照度计的测量准确度，确保光电间的线性关系，本设计把运算放大器接成电流电压变换器的形式，一方面可得到零负载效应；另一方面，短路电流通过反馈电阻变成电压量，实际效果相当于流过一个负载电阻形成的压降。

On that basis, the corresponding linerized model is built, and the dynamic properties are analyzed while the configuration or end-point load is greatly changed, the predictable equation of the built-in frequency is established by virtue of perturbation method for the application of variable parameter control in that case.

利用拉格朗日方法推导了双杆柔性机械手的动力学方程，在此基础上了建立相应的线性化模型，分析柔性机械手当位形和负载发生较大改变所表现出的的动力学特性，用摄动方法建立了固有振动频率的预示表达式，以应用于位形和负载有较大改变情形的变参数控制。

This paper has analyzed the receiver-initiated and sender-initiated strategies to be commonly used, and then proposed a universal model of dynamic load balancing based on the mixed strategy.

本文在简单分析了动态负载平衡调度中接收者驱动和发送者驱动这两个常用策略基础上，提出了一个通用的基于混合驱动策略的动态负载平衡调度模型，并给出了曙光1000并行机上的部分实验结果

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。