调整杆

Supporting the 8 inner stay bar with the top frame on around of the tower body as the same horizontal position, press the master chord of the tower body tightly, work in the tower head part of the climbing frame and adjust the vertical angle less than 4/1000 of the tower body.

7.4.7 将 8 根内撑杆支撑在与最上面一个框架位于同一水平的塔身四周，适当顶紧塔身主弦，配合爬升框架上的顶块调整塔身的垂直度至 4/1000 以内，然后，适当顶紧上面两框架的顶块，锁住顶块螺母。

The new presser bar pressure regulating knob enables the simple adjustment of presser bar pressure.

新型设计的压力调整螺丝杆，可微调整设定压脚压力的轻重，简便稳定。

Brfore every jacking, must make good preparations carefully and the ending work, especially after the jacking course, all connected bolts should be fixup tightly as required, no to become flexible, adjust the climbing frame clearance between pulley and tower body section, control rod should be back to the mid position, and should cut off the power of the hydraulic system.

8.2.7 每次顶升前后，必须认真做好准备工作和收尾工作，特别是在顶升之后，各连接螺栓应按规定的预紧力紧固，不得松动，爬升套架滚轮与塔身标准节的间隙应调整好，操作杆应回到中间位置，液压系统的电源应切断等。

The tooth contact and kinematic precision of cone-generated double-enveloping worm gearing with machining and assembling errors have been investigated.

对存在加工及装配误差的锥面二次包络环面蜗杆传动进行了接触分析，探讨了各种制造误差对齿面接触质量和运动精度的影响规律和影响程度，提出了矫正由加工误差引起的齿面接触偏倚，减小运动误差的装配调整作业法。

Additional Unibal joints are featured on the track control arms and the sword-shaped anti-roll bars front and rear are now adjustable to seven different positions on both sides, allowing an even more precise set-up of the car in accordance with the respective race track.

附加Unibal关节是在赛道上控制武器和功能的剑形防侧倾杆前部和后部，现在调整到7双方不同的立场，允许更精确的设定了一辆汽车，按照各自的种族跟踪。

Although Toyota Yaris T Sport uses the same basic suspension design as the standard Yaris hatchback - MacPherson strut front and torsion beam rear - the units have been tuned to suit the sporting characteristics of the car.

虽然丰田Yaris T运动作为标准Yaris掀背车相同的基本悬架的设计-前MacPherson strut，后扭杆式-单位已调整，以适应汽车的运动特性。

Therefore, this method is not appropriate as a single-screw adjusting parameters means.

因此，这种方法不宜作为单螺杆泵调整参数的手段。

The sludge residence time in the screw press and thus the filtration time can be adjusted to individual requirements by adjusting the rotational speed of the screw shaft.

污泥停留在螺旋压力机的时间，过滤的时间可以根据实际情况通过改变螺杆轴转的速调整。

If trip-under stop happens in shifting from higher to lower gear position,screw out the upper adjusting screw.

如果跳闸停止下发生的转变，以降低较高的齿轮位置，螺杆上的调整螺钉。

If trip-under stop happens in shifting from lower to higher gear position,screw out the lower adjusting screw.

如果跳闸停止下发生的变化从低到高齿轮的立场，螺杆出较低的调整螺钉。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。