误差范围

Experimental results indicate that the variance coefficient was not bigger than 4.98% in the range of 50×10^(-6)~10000×10^(-6); the coefficient was not bigger than 0.44% and the absolute error was less than 0.35×10^(-6) in the range of 2.5×10^(-6)~10×10^(-6).

该分析方法在50×10^(-6)~10000×10^(-6)范围内，变异系数不大于0.44%；在2.5×10^(-6)~10×10^(-6)范围内，变异系数不大于4.98%，绝对误差小于0.35×10^(-6)。

For a wide variety of lithologies from granite through gneiss, carbonate and amphibolite to basaltic rocks, it is shown that this relation is valid in the range 0～350 API and 0.03～7μW/m3 respectively with an error lower than 10%.

从片麻岩、碳酸盐岩、角闪岩、花岗岩到玄武岩，在这样宽的岩性变化范围内，显示出这种线性关系在0～350 API和0.03～7 μW/m3范围是有效的，其误差均小于10％。

The first approach was a qualitative test method, and gave statistical correlation trend. Second and third approaches were quantitative test methods, and indicated the goodness of fitting and the ranges of the residual estimation errors.

拟合相关图法属定性检验，给出了统计相关趋势；回归分析法和残差估计误差指示法为定量检验，给出了模拟计算值与实测值间的拟合优度和残差估计误差的范围。

Test results show the linearity of COCT is better than IEC 0.2 class limit, and is suitable to the applications, in which the voltages are higher than 220 kV, the COCT accuracy is almost not affected by the existence of neighbor phases. The temperature test result tells in the temperature range of 50 ℃ the error of COCT is less than 1%, much better than an uncompensated one 16%. And thus the effectiveness of COCT is verified.

试验结果表明：比较式光学电流互感器的线性度可达到IEC 0.2级要求；在光学电流互感器适用的220 kV以上电压等级应用场合，比较式光学电流互感器具有较好的抗干扰性能；在50 ℃温度变化范围内，普通光学电流互感器的误差变化量高达16%，而比较式光学电流互感器的误差变化仅有1%，证实了基于比较法的补偿方案的有效性。

But the error tolerance of Chahine iterative scheme is very small when using it to calculate the equation of Mies theory. The main reason is the anisomerous distribution of the light energy error on the detector.

在全量程范围内采用Mie理论计算时，Chahine叠代算法的误差容差限比较小，这主要是因为光能在光环检测器上的截断误差决定的。

All dresses that sell in our stores are measured in the flatwise, but due to some of the clothes have flexibility and the way of measurement and margin mark may dissimilar it may cause some slightly different, so that all the size measurement that labelled in our stores are just for reference basis, error margin that within 2cm is consider normal.

本店所有商品尺寸皆平放测量，但因衣服有弹性、测量方式不同标示略有误差，所以本店商品里标注的尺寸仅作为参考基准，误差在2cm以内均属正常范围哟

The algorithm has some problems, such as bias problem, aliasing problem and one problem that affects none-shade part of image and is caused by Gaussian blur. To solve these problems, this paper makes some improvement on the algorithm. Firstly, it uses the Woos average depth principle and PCF algorithm to solving bias problem and aliasing problem; secondly, it designs and implements an effective method to control the range of blur; thirdly, it adapts any size texture to story information. This method for keeping information plays important part on raising realistic graphic; fourthly, it takes use of the technology of programmable graphics hardware and the method of FBO to improve efficiency of algorithm.

由于基于高斯模糊的阴影算法存在阴影走样、量化误差和高斯模糊影响非阴影部分图像等问题，因此本文从以下几个方面对算法进行了改进：第一，在算法中添加了woo的平均深度值原理和PCF算法，改善了量化误差和阴影走样问题；第二，设计并实现了一种方法，有效地控制了高斯模糊的范围，提高了三维图形的真实感；第三，使用任意大小的纹理进行存储，提高了阴影的真实感；第四，通过可编程图形硬件技术的应用，提高了算法的运行速度。

Because the variation of the light source and other errors related to light intensity are not so critical for the measurement in this system and some 1/4λ wave-plates affect on the other wavelengths is very little, the retardance can be measured in high accuracy and high repeatability. In principles, the system accuracy can measure any retardance, and can be used in characteristic spectrum analysis of other phase retarders.

由于此系统可忽略光强的波动及与光强有关的误差，且1/4λ波片对多波长测试误差的影响很小，故其有很高的精度和可靠性，可以测试其精度范围内的任意小延迟量，亦可对其他光学相位延迟器件进行光谱分析。

It has been validated that the prediction accuracy is enhanced and the average errors of the yield strength and strain hardening exponent are 1.6% and 12.6%, respectively.

通过模拟验证，此方法提高了计算精度并扩大了材料的计算范围。所获得的屈服强度平均误差是1.6%，应变硬化指数的平均误差12.6%。

Simulation results show that in the image rotation and scale variation range resulted from the navigation system error and the measurement error of the wireless pressure altimeter, the proposed image matching algorithm can satisfy the accuracy demands of the scene aided navigation system and provide the location error-correcting information of the system.

仿真分析表明，在导航系统误差漂移所引起的图像旋转和气压高度表所引起的尺度变化范围内，该算法能满足匹配准确性的要求，并能有效给出系统的定位误差修正信息。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。