误差范围

The calculations show that the approximation for the birefringence and the rotatory property of interaction material leads to an error in the optimum incident angle for TeO2 more than 10%, a diviation in fa-λ0 relation from experiment results, and make the spectral resolution and angular aperture of the device to be degrade.

结果指出，在该波长下，对晶体双折射取近似表达式和不计入晶体的旋光特性，对光波最佳入射角θi的选取(在θi小于60°的范围内)，将引入大于10%的误差，这个误差由于涉及到是否满足动量匹配条件，因此会对器件的性能有直接的影响。

In this paper, the error function is adopted to calculate the pore pressure.

针对这种情况，本文以误差函数作为基础，对孔隙水压力的计算进行了分析，发现在一定的精度范围内，采用误差函数可以有效地消除由于Gibbs现象带来的振荡。

The results of variance and residual error showed that the error was in the range of kinetic toleration. and the experiment did not have system error.

对上述模型进行了方差和残差分析，其误差在宏观动力学研究允许范围内，试验无系统误差。

A variable-step modified Euler time integration method is proposed and analyzed. Four major factors that affect the efficiency of the variable-step modified Euler time integration method are discussed. These include stability and accuracy analysis for the damped fix-step modified Euler integration formula, adjustment method of the fix-step basic integration formula to accommodate step-size changes, suitable range of the step-size selection strategy based on truncation error concept and development of the step-size selection strategy based on apparent frequency concept to satisfied the specified error bound and stability condition.

提出了变步长修正Euler时间积分法，详细讨论了影响变步长修正Euler时间积分算法效率的四个主要因素，它们包括：有阻尼问题的修正Euler法的稳定性和精度分析，调整固定步长的基本积分公式使之容纳步长大小变化的研究，基于截断误差概念的步长大小选择策略适用范围的讨论，同时满足规定误差界和稳定性条件的、基于表观频率概念的步长大小选择策略的建立。

The sidelobe has many ripples in condition of small training sample size and the diagonal loading technology is applied to this method, which improve the convergence speed of sidelobe. We also study the pattern control of area array. The effectiveness of this new method is illustrated by the designed simulations.5. Adaptive sidelobe cancellation is a important part of phase array radar. To realize low sidelobe and suppressing the interferer the antenna technique and signal process are combined.

用对角加载方法解决了小快拍数下收敛速度慢的问题，并仿真给出了加载量的选取范围，对面阵的自适应方向图控制文中也进行了详细讨论，阵列幅相误差和互耦误差对自适应方向图控制影响，文中也给出了仿真和分析。5、自适应旁瓣相消是相控阵雷达技术的一个重要组成部分，它将天线技术与信号处理技术结合在一起，使相控阵天线实现超低副瓣，达到抗有源干扰的目的。

Hypothesis in 0 ~ 10 speed range between 2000 and r/min speed error Δ requirement f r/min, more than 1 and measuring time, time than 100 ms t take 3 muon s acuities error Δ than eight mu t s, according to the formula (1) and (3) and assumptions, and computer programming.

假设转速范围在0～10 000 r/ min 之间，要求转速误差Δf ≤1 r/ min ，并且测量时间T ≤100 ms ，时间误差取3μs ≤ΔT ≤8μs ，根据公式(1)和(3)及假设条件，进行计算机编程求解。

The errors and area limits caused by the lunar curvature were avoided in this model established under the Selenocentric Orthogonal Coordinate System, the accidental errors of exterior line elements were reduced by orbit fitting and interpolation, the polynomial orders of systematic errors in satellite orbits were decreased with their expression in the flying coordinate system moving and rotating with satellites, and the reliability of exterior orientation solution was enhanced under the condition of sparse and low accuracy control points by appending constraint of orbit and attitude parameters.

该模型通过在月心直角坐标系进行影像空中三角测量来消除月球曲率引起的误差和测图范围限制，通过轨道形状的拟合与插值来减小摄影时刻轨道位置的偶然误差，在飞行坐标系中建立轨道修正模型来减少定向参数的数目，对轨道和姿态增加约束条件来提高月面控制点数目稀少及精度低条件下外方位解算的精度与可靠性。

Specially,it introduced the process and algorithm of error compensation which has been effective on controlling the measure error within the range of requirements of the whole system.

摘 要：为了提高电池检测系统中电池测量的精度，对MAX197模数转换器的主要误差源进行了较详尽的分析与测试，在此基础上提出了提高测量精度的建议和处理方法，其中对误差补偿方法，给出了具体的过程和算法，在实际应用中已有效的将测量误差控制在系统的要求范围内。

The error of the elongation is 2.3%, by the multi-dimension linear regression model, the relative error are from ? 5% to ? 15% respectively. Comparing the results, it can be found that the neural network overmatches the multi-dimension linear regression. So that, the model can be used in the production of the marine propeller aluminum bronze.

计算结果表明，三项输出的预测值与实测数据接近，抗拉强度和屈服强度的相对误差在±1％的范围以内，延伸率的最大绝对误差为2.3％，明显优于多元线性回归模型±5％—±15％的误差，能较好地满足工程应用的要求，对高强度船用螺旋桨铝青铜的生产具有一定的指导意义。

Then the error sources of the reaction type and electron type electric energy mete were analyzed and the theory analysis result through the concrete test have been proved. At last, the main conclusion has been drawn. When the induction type electric energy meter measures harmonics energy, the negative error characteristic appears. The higher the frequency of harmonics is, the greater the error is. The electron type electric energy meter can measure harmonics energy accurately in general cases. Except thermo-electrical conversion type electron type power meter, reaction type and electron type electric energy meter can measure direct current power.

本论文通过分析感应式和电子式电能表的工作原理推导出了电能表计量电能的数学模型；分析了感应式和电子式电能表的误差来源以及谐波对计量的影响，并通过具体的试验对理论分析结果进行了验证；得出了如下谐波对电能表计量影响的主要结论：感应式电能表计量谐波电能时，呈现负的误差特性，谐波频率越高，误差越大；电子式电能表在其频响范围内可以准确计量谐波电能。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。