误差曲线

On the basis of analysing the vibration of the axle briefly, it is discussed in detail that the source of error in measurement with photoelectrical sensors, and a simple but efficient methodleading and trailing edge compensation—is proposed to solve this problem.

在简要分析轴的振动情况基础上，从探头切割特性曲线入手，详细研究了用光法进行转矩测量误差产生的原因，并提出简单而又有效的解决办法—栅条反射面的前后沿补偿法。

Methods. PSF 1000 analyzer was used to measure retinal image quality for eye of 26 subjects (spherical ranged from –3.00 ~-6.00Ds, astigmatism ranged from –0.75~-3.00Dc) fitted with three forms of full correction in random order : unaided eye, with rigid gas permeable contact lenses and toric soft contact lenses. The modulation transfer function curve was observed, 12 points of the MTF curve ( equivalent 12 points of LogMar VA) was used for analysis. Results.

利用人眼点扩散函数分析系统（PSF-1000）检查和评估26例近视散光患者（年龄18~28岁，球镜–3.00DS~-6.00 DS，角膜散光-0.75DC ~-3.00DC）在裸眼、配戴散光软性角膜接触镜和透氧性硬性角膜接触镜三种全矫状态的光学成像质量，采用26眼屈光介质MTF曲线中的12个点（即分别等同于对数视力表4.0~5.1的12个点）进行比较和统计学分析，为了避免主观误差，三种矫正方式的先后顺序随机选择。

00Ds, astigmatism ranged from ?0.75~-3.00Dc fitted with three forms of full correction in random order : unaided eye, with rigid gas permeable contact lenses and toric soft contact lenses. The modulation transfer function curve was observed, 12 points of the MTF curve ( equivalent 12 points of LogMar VA) was used for analysis. Results.

3.00DS~-6.00 DS，角膜散光-0.75DC ~-3.00DC）在裸眼、配戴散光软性角膜接触镜和透氧性硬性角膜接触镜三种全矫状态的光学成像质量，采用26眼屈光介质MTF曲线中的12个点（即分别等同于对数视力表4.0~5.1的12个点）进行比较和统计学分析，为了避免主观误差，三种矫正方式的先后顺序随机选择。

In demarking the heat-bulb velocity measurement head , the computer-measurement system is taken as a whole, so the demarked data can be conveqed directly to the computer to decrease the possible error of the system.

在热球风速仪测头的标定中，将电测系统看成为一个整体，由微机直接读数以降低系统误差，并给出了16路测头的修正曲线。

Pesticides were extracted from tea with hexane-acetone (volume ratio is 1:1) in an ultrasonic bath and cleaned up on a Florisil and neutral alumina column, then were determined by gas chromatography with negative chemical ionization mass spectrometric detection in the selected ion monitoring mode, and with heptachlor epoxide as the internal standard. Spiked blank samples were used as standards to counteract the matrix effect observed in the chromatographic determination.

茶叶试样用V/V=1/l混合提取剂超声提取，经Florisil矽藻土和中性氧化铝混合层析柱净化后，以环氧七氯为内标物，采用GC-NCI-MS的选择离子监测方式分析；探讨了茶叶试样的基体诱导色谱响应增强影响所产生的分析误差及其减小的措施，用空白试样基体匹配校准曲线法定量分析。

We present a method of circular arc fragmented curve-fittingbased on least mean-square error rule in this paper.

谭勇 ，徐守时，涂嘉文提出了一种基于最小均方误差准则的圆弧分段曲线拟合方法。

Based on this algorithm, we use the circular arc as basic element to fit curve accroding to least mean-square error rule.

在该算法的基础上根据最小均方误差准则，以圆弧作为基元对曲线进行拟合。

For convenience of the comparison and application, method for calculating the binder path length is set up in accordance with Newton-Cotes method under the aid of computer. The binder shrinkages, which are more useful in fabric production, are converted from binder path length, and compared with the testing shrinkage results.

为了方便比较和应用，采用Newton-cotes法，建立了接结纱曲线长度的计算方法，并由计算机进行求解；再将模型计算的接结纱长度转化为接结纱缩率，并与实际测试的接结纱缩率相比较，发现两者基本是一致的，误差较小，说明建立的接结纱模型是正确的。

The thesis introduces an equal difference between an approximate value and an accurate value waY for panel point's coordinate calculation of the irregular curve by means of tangent line's approaching;illustrates it with a concrete example;and falls back on MATLAB mathematic software to draw an imitation picture of cutting tools' locus.

介绍一种用切线逼近非圆曲线节点坐标计算的等误差法，结合实例，借助M ATLAB数学软件，绘制出刀具轨迹的仿真图。

In an admirable error bound, the numerical simulation had the close results with experiment by the characteristic curve of cold mass flow fraction, as well as Thermodynamics model of vortex tube, So Thermodynamic theory hypothesis was available to explain Ranque-Hilsch effect of vortex tube.

在误差允许的范围内，涡流管冷流率特征曲线描述的结果与涡流管热力学理论给出的结果非常相近，说明涡流管热力学理论假设能够描述Ranque-Hilsch效应。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。