误差

The experimental results show that a good linear relation between TCD response to the partial pressure of deuterium is obtained.

实验结果表明，TCD对氘的响应与氘的压力呈良好的线性关系；对已知氘丰度为1%~90%的氕氘混合物样品进行了测定，测量结果的误差与气氛混合气体中的HD丰度成正比，绝对误差范围在

A new sequential step diagonal measurement method has been proposed based on the conventional diagonal measurement. In this method, the error in three axis directions can be divided 9 synthesis errors and they can be identified based on the values measured along four body diagonals.

通过对三个坐标轴方向的误差进行矢量分解，在现有的体对角线方法的基础上，提出了一种改进的分步体对角线测量方法，这种方法通过分步测量机床工作空间的四条体对角线可以快速获得分解后得到的9项位置误差。

A leave-one-out error bound for SVR is derived in this paper. After the SVR model is obtained for a given set of hyperparameters, the bound can be computed with very little additional work. Considering the properties of the bound, an optimization method based on difference quotient is proposed.

本文针对当前SVR推广误差的估计大多需要较大计算费用的情况，推导出SVR的留一法误差的易于计算的界，这个界在得到学习算法的解后需要很少的额外工作量。

The characteristics and optical path difference of beam reflected by cube-corner prism with dihedral angle errors were researched;the CCP with errors acts as a phase screen comprised 6 optical wedges.

分析了角锥棱镜对光束的相位变换作用，带二面角误差的角锥棱镜可等效于6块光楔的组合，其楔角的大小和方向由二面角误差决定。

But the construction drawing budget method can cause the greater difference between the accounting results of development organization and construction organization due to their different accounting errors, different understandings of construction drawing and different dinking modes, which leads to the difficulty in project settling accounts.

但是，由于施工图预算计算起来往往由于预算人员的计算误差和对施工图理解的不同，思维方式的不同，造成建设单位和施工单位计算的结果误差较大，给工程结算造成较大的麻烦。

In the case of the iterative learning control for linear continuous system with the initial error, a kind of ILC approach with compensation to the initial error is presented using the theory of the two dimensional (2 D) linear continuous discrete system.

针对线性连续系统迭代学习控制中含有固定初始误差的情形，利用二维系统理论给出了一种带有初始误差修正的迭代学习控制方案和这种迭代学习控制规律收敛的条件，并说明由此设计的迭代学习控制器简单有效，可实现在初始时间段以外部分对期望轨迹的完全跟踪。

DSP is used to realize digital controllers of velocity-loop and position-loop. Analyze and validate that dividing high-level continue controller to several low-level controllers, then discretize the low-level controllers to form series controller can depress the discretization control error.

采用DSP实现速度环和位置环的数字控制器，分析并验证了连续域高阶控制器分解成连续域低阶控制器，将低阶控制器离散后进行串联控制，这种实现方式的数字控制器与连续域控制器之间的控制误差，将远小于直接将连续域高阶控制器离散成高阶数字控制器产生的控制误差。

Polynomial fitting was used to map out the pressure distribution curve of numerica...

与通过试验数据计算出的结果相比，数值模拟计算出来的轴向力相对误差在9%以内，而经验公式计算的轴向力相对误差为14%，采用数值模拟方法计算轴向力具有更高的精度，对多级离心泵轴向力平衡的研究具有指导意义。

Present the research results about servo control error characteristics and a practical rule and method for error parameter distribution.

研究了APT伺服控制的误差特性，并提出了"针对伺服控制系统的误差分配准则和具体方法"。

The Gaussian properties of laser beams may cause the appearance of gradients in the interference pattern in the measuring volume and a broadening of Doppler spectrum....

本文定量地论述了高斯光束的各因素对测量精度的影响；给出了测量误差表达式，经过各种情况下的理论计算值的对比和分析，得出了两束腰分别在测量区两侧，等距离时，干涉条纹空间频率梯度引起测量误差最小的结论。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。