试验方法

In light of grading analysis test by densimeter method , this paper analyzes and compares the operative method and criterion of test in "The code of soil test" and "The criterion of soil test method" with improved testing operative method, and summarizes a more perfect, effective and accurate testing method, which to offer a reference for soil tester.

针对密度计法颗粒分析试验，对《规程》和《标准》中的试验操作方法和标准与改进的试验操作方法进行了对比分析，总结出一种更为完善、有效、准确的试验方法，供广大土工试验人员参考和采用。

The products samples came from Guangdong Entomological Institute. The test was made according to the national standards of the People's Republic of China (GB 15670-1995) in Toxicological Test Methods of Pesticides for Registration. SPF SD mice were used to made the peroral toxicity test and percutaneous toxicity test. There were ten mice (including 5 female rice and 5 male rice) in each group. New Zealand rabbits were used to make the eye irritation test and skin irritation test, with 4 rabbits in each test. FMMU albino guinea pigs were used to make the hypersusceptibility test, with 13-20 guinea pigs in each group.

方法］产品样品来源于广东省昆虫研究所，根据中国人民共和国国家标准GB15670-1995《农药登记毒理学试验方法》进行试验，试验使用SPF级SD大鼠，用于经口、经皮毒性试验，每组10只，雌雄各半；新西兰白兔，用于眼刺激和皮肤刺激试验，每试验4只；FMMU白化豚鼠，用于致敏试验，每组13~20只。

With the compare of research methods such as direct experiment, indirect method and numerical simulation method, and with the applied background of the Virtual Prototype technology, the paper puts forward a new strategy for the design of the testing device for dynamic response of road based on Pro/E、 ADAMS and ANSYS software. On the basis of the theory, this paper analyze the scheme and the important parts, and has proposed that actual modeling parameter, pattern and arrangement scheme, and structured the complete machine scheme of a testing device for testing road dynamic response based on dynamic load of vehicle-road.

本文在系统分析了各种车路系统动载荷研究方法的基础上，针对直接试验方法、间接试验方法和数字仿真方法的发展，并结合"虚拟样机"技术的应用背景，提出了一种基于Pro／E、ADAMS和ANSYS软件的基于车路动载荷的测试路面力学响应的试验装置的虚拟样机的实现策略，并在此基础上，对方案和重要部件进行了分析，提出了实际的建模参数、型式和布局方案，构建了一种基于车路系统动力学的测试路面动态力学响应的试验装置的整机方案。

The article analyzes the relationship between transformer s winding structure and its induced voltage test method.

讨论了 110kV双绕组电力变压器内部绕组结构及布置与感应耐压试验方法的关系，变压器的感应耐压试验方法应根据变压器的结构来确定，同时变压器的结构布置也应考虑到试验方法的可行性以达到设计要求和试验要

In handling these problems, integrated test design and evaluation technology is studied in this thesis,the purpose of which is to reduce repetitiveness of test in the developing phase,guarantee quality of test data,make full use of various test i.

针对我国武器装备在其全寿命周期内经历的工作阶段多、各阶段技术状态各不相同但具有一定的继承性、而各阶段特别是全系统现场试验量较少的特点，分析了目前小子样试验方法存在的不足，提出了武器装备综合试验与鉴定的技术框架，重点介绍了支撑该技术框架的综合试验设计方法、小子样多状态试验数据融合处理方法以及战技指标综合评定方法的研究进展，指出了需要进一步研究和解决的问题

The index of flame retardant property,material,product structure and relevant method of test of the antiflaming flexible cable is established according to the standard of GB/T18301-2001《the Third Part of Burning Test of cables in the Condition of flame:Method of Buring Test of Bunchy Wires and Cables》.The Cable will emanate the bad gas in buring to causethe the second calamity,so the smoke capacity of the cable in burning should be tested according to the standard of IECl034-2(1991)《the Second Part of Method of Smoke Concentration Test ofCable 1n Burning:Procedure and Requirement ofTest》The Liberation of Gas 1n burning is tested according to the standard of IEC754-2(1991)《the Second Part of Test of Liberatlon of Burning Materlal from Cable:Method to Measure the ACidity with the Measured PH and Conductlvltv》.

对阻燃型软电缆所要求的阻燃性能指标，是根据GB/T18301-2001《电缆在火焰条件下的燃烧试验第3部分：成束电线或电缆的燃烧试验方法》标准的规定而确定其电缆的材料要求、产品结构和相应的试验方法；对于耐火性试验，并考虑到电缆在火焰中会散发有害气体，造成&二次灾害&，所以还规定了对电缆燃烧时发烟量进行试验，按IECl034-2(1991)《电缆在特定条件下燃烧的烟浓度试验方法第二部分试验步骤和要求》以及燃烧时析出气体按IEC754-2(1991)《取白电缆的村料燃烧时析山气体的试验第二部分用测量PH值和导电率来测量气体酸度的方法》进行试验。

In order to simply the method, we further propose using magnetic stirring with weighted ring in stead of argon sparging; using air-circulated incubator in stead of water bath for better observation and sample collection; using centrifuging in stead of filtration for extract pretreatment; using one phase of simplified bioaccessibility extraction method instead of the two-phase method for a better estimate to the in-vivo method.

爲进一步简化试验方法，建议将开放式反应槽改为密闭式；使用可调速磁力搅拌及具载重环磁石，取代昂贵之氩气搅拌；将水浴温控改为气控式，以利试验观察与采样。此外，小肠相萃取不使用吸附剂，萃取液前处理利用高速离心取代压阻较高之过滤方式。本研究二阶段试验之生物有效性皆低估动物试验RBF，建议可将二阶段胃肠体外试验方法改为单相一阶段生物有效性萃取(simplified bioaccessibility extraction， SBET)试验方法。

In this paper the photocathode and micro channel plate, the two key factors affecting image intensifier operational life, are also analyzed in detail and are listed the life test methods in night vision ind...

通过对国内外加速寿命试验和像增强管工作寿命试验方法的分析借鉴，结合我们二代近贴管二十多年的生产试验，特别是超二代管工作寿命试验积累的宝贵经验，本文提供了一种加速试验方法，在保证像增强管阴极灵敏度稳定性的前提下，采用一个对光电阴极影响最大的应力加倍的方法，以缩短工作寿命试验时间，减少生产周期以保证交货进度。

In this paper, a large number of tests, theoretical and calculating analyses are made on the acceleration wave propagation law, slipform paving resistance calculation and forming quality analyses of paving slab by single factor experiment, orthogonal experiment, statistical method, computer simulation method, and theoretical analysis and experimental verification.

本文针对混凝土中的加速度传播规律、滑模摊铺阻力和路面摊铺成型质量三个方面，采用单因素试验方法、正交试验方法、数理统计方法、计算机模拟方法、理论分析和试验印证方法，进行了大量的试验、理论演引推导和计算分析。

In this paper, test research have been performed on the two important mechanical properties indicator compressive modulus of elasticity and shear modulus. Numerical simulation has been performed on the base of results of test under the situation uniform and uneven thickness of elastomer layer, which analyze internal stress distribution of the elastomeric bearing, as follows:(1) The traditional test methods of compressive modulus of elasticity test are rather cumbersome and take up experimentalists lots of time. This paper has improved the traditional test methods of compressive modulus of elasticity test, which has collected the holding-load time together to concentrate on holding load. The tests have been performed on different types of bearings, which results show that the results of the improved test method conform to the error range regulated by the standard and can effectively save time for the experimentalists, also eliminate the accumulative error.

本文主要对板式橡胶支座的抗压弹性模量、抗剪弹性模量两个重要力学性能指标进行试验研究，并在试验结果的基础上对均匀胶层厚度和不均匀胶层厚度两种情况进行数值模拟，分析橡胶支座内部应力分布规律，具体内容如下：(1)传统抗压弹性模量试验方法比较繁琐，占用试验人员大量时间，本文对传统抗压弹性模量试验方法进行了改进，将持荷时间集中起来进行集中持荷，通过对不同类型支座进行试验，试验结果表明该改进试验方法所得结果符合标准规定误差范围，为试验人员节省了大量时间，并且还消除了传统方法中的累计误差。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。