试的

At the same W/C condition, ocean-sand (standard and non-standard) is mixed, non-standard ocean-sand shall have more compressive strength than standard ocean-sand about 10%, Add slag additament to motor test sample of ocean-sand mixing, bending strength shall be according to slag additament, but 40%~60% slag additament shall be quite obvious. Motor test sample of ocean-sand mixing shall be compared type Ⅰ cement with type Ⅱ cement, to make use of type Ⅱ cement to motor test sample of ocean-sand mixing shall have more compressive and bending strength about 10%, Rising of strength is best among non-standard sand mixing.

若添加炉石於海砂所拌和的水泥砂浆，其抗弯强度会随著炉石添加量的增加而增加，以40%~60%的炉石替代量为最佳；以第Ⅰ及第Ⅱ类型所拌和的海砂水泥砂浆试体做比较，依晚期强度而言，第Ⅱ类型水泥所拌和的试体，其抗压及抗弯强度比第Ⅰ类型水泥约高出10%左右，其中以非标准砂所拌和的试体强度上升最大。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work.Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。2。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work. Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted. It was found in our drop tests that the root cause of lead-free solder joints under drop impact was the combined effect of mechanical shock and PCB bending vibration.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。

Check content covered the aspect of almost full knowledge of series, if tried check of the 11st problem 2004 of series connect with knowledge of sue for peace, the 2 content check that try the 2nd big problem to combine analytic geometry, inequality of recurrence series, monotonicity and;2005 of knowledge of sue for peace year try the 7th problem to combine polynomial coefficient check knowledge of geometric series sue for peace, the 13rd problem is background check with recurrence series the preliminary knowledge; of the property that series concerns and number theory

考查内容涵盖了数列的几乎全部知识点，如2004年一试第11题考查了数列的通项和求和知识，二试第2大题结合解析几何、不等式的内容考查了递推数列的通项、单调性及求和知识；2005年一试第7题结合多项式系数考查了等比数列求和知识，第13题以递推数列为背景考查了数列有关的性质和数论的初步知识

In Experiment 1, the pattern of spatial attention shift was examined by instructing participants to saccade to the cue.

实验一要求被试将眼睛跳往提示刺激处，通过对线运动错觉的分析确定该条件下的空间注意转移规律；实验二要求被试在将视线保持在注视点处的条件下判断目标色块是否出现，以探明线运动错觉是否受对目标色块前注意阶段加工的影响；实验三要求被试将眼睛跳往提示刺激的对侧，分析眼跳位置与提示刺激空间方位的一致性对空间注意转移的影响。

The basic procedures of the experiments were:(1)rule training:thisis pretraining in order to make subjects attend gradually to the numberdimension of stimuli,and master the rule of number matching.(2)formaltraining:a variety of cards loading number"3"or"5"served as samplesand comparisons.(3)transfer test,test trials were interposed among usualtraining trials of each session,the number is from 1 to 9,and three typestransfer test were proceeded.

两个实验的基本程序为：（1）规则训练阶段：用几个步骤使被试逐渐注意刺激的数维度，并掌握数目匹配原则；（2）正式训练阶段：数目3、5的多种变式作为样本和比较刺激，通过被试在各种样本和比较刺激对上的反应分析它们所利用的线索；（3）迁移测试阶段：将迁移测验随机插入每天的正式训练中，数目扩展为1至9，以验证被试数能力的抽象程度。

Seven inactivated tetravalent vaccines of Riemerella anatipestifer,of which three (1#,3#,7#) employed oil-emulsion,two(4#,6#) employed propolis,two(8#,10#) employed aluminum hydroxide as their basic adjuvants,were developed and compared by the methods as follows:challenges were performed by homologous virulent RA strains to measure their protective abilities;indirect enzyme-linked immunosorbent assay was used to monitor antibody production;lymphocyte transformation test was performed to study the expression of cell-mediated immunity.

本实验通过对供试鸭的攻毒保护试验、通过用ELISA方法对供试鸭特异性抗体消长规律的研究以及通过用~3H-TdR掺入法对供试鸭T细胞免疫水平的检测三个方面对所研制的七种不同佐剂类型的鸭疫里氏杆菌四价灭活苗的免疫原性进行了比较研究。

The primary aim of this experment was to make clear the photosynthetic characteristics of eggplant.The photosynthetic charateristics of different varieties, nodes, growth and development stages and the effects of photo, CO2 concentration and temperature on Pn of own-rooted seedlings in eggplant;the photosynthetic charateristics of grafted seedlings that cions were grafted on rootstocks; the effects of low temperature(10/5 ,day/night) and poor light(60mol.m-2.s-1 and l20mol.m-2.s-1) on photosynthetic and other physiological characteristics of own-rooted seedlings in eggplant with four and five leaves were studed.

以茄子自根苗为试材，研究了不同品种、不同叶龄、不同叶位、不同生育期单个叶片的光合特性及环境因子对盛果期功能叶片Pn的影响；以托鲁巴姆、CRP为砧木，二苠茄和快圆茄做接穗所得的茄子嫁接苗为试材，研究了嫁接苗单个叶片光合特性及环境因子对嫁接苗功能叶片Pn的影响；以自根苗幼苗(4-5叶)为试材，研究了低温(10／5℃)弱光60μmol.m~(-2.s~(-1)和120μmol.m~(-2)。s~(-1)对茄子幼苗光合及其它生理特性的影响。

This study was conducted to examiune the fibrotic effect of Ni-Ti and 317L al loys in esophagus.The extract fluid from Ni-Ti,317L alloys was made according t o the ASTM standards of U.S.A. The Fb of esophageal scar was cultured primarily ,then incubated with alloy abstract fluid. The proliferating activity of Fb was measured by MTT at 4, 24, 48, 72 hours in the course of culturing. The esophagu s embedding test of Ni-Ti,317L alloys was made according to ASTM standards of U .S.A.The tissue around the alloys was taken at weeks 2 and 12,and the pathologi c changes were analysed.

为探讨新型支架材料Ni-Ti、317L合金在食管局部的致纤维化作用，按美国ASTM标准制备NiTi、317L合金的金属浸提液；&组织块培养法&原代培养食管壁疤痕的成纤维细胞，传代后以金属浸提液进行培养，分组后分别培养4、24、48、72 h，MTT法检测不同培养时间后Fb增殖功能的变化；按美国ASTM标准进行NiTi、317L合金试件的食管壁内包埋实验，即将金属试件经表面处理后直接置入食管壁粘膜层与肌层之间，术后2、12周取出包埋组织，分析试件周围组织的病理变化，并进行胶原纤维染色，观察纤维形成状况。

Participants required more time to shift their focus over the imaged stimulus in the KBR paradigm. More fixations,more saccades,and rarer saccade distance were found when they scanned in the KBR task.Detailed analysis showed that participants scanned the whole distance from the original point to the target point in KBR paradigm,while the scanning distance were much shorter in FP paradigm.

在距离相同的情况下，被试完成KBR任务需要更多的时间，眼动特征表明，被试在完成KBR任务时，需要更多的注视点、眼跳次数和更远的眼跳距离，对眼动轨迹图的分析显示，完成KBR任务时，被试进行的是从初始点到目标点的全程扫描，而完成FP任务时，扫描距离较短。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。