设置

The method to configure RED parameters based on network properties is also presented. Simulations show that the modified Random Early Detection algorithm really performs better than the original Random Early Detection algorithm and can work for a much wider range of traffic. Finally, whether the assured service mechanisms i. e. an edge router tags every arriving packet of a TCP flow based service profile and core router drops packets differently at congestion using active queue management scheme is possible to provide a throughput consistent with target rate, is investigated under different network scenarios. Different factors including target rate tagged algorithm, RIO algorithm and TCP congestion control mechanism how to affect the throughput of an assured service TCP flow are examined. Based on a fluid model. we then derive a model of an assured service TCP flow, which is the function of round trip delay, packet loss rate and token bucket parameters. Based on this model, we observe that in some cases it is possible to regulate the token bucket parameters to gain a consistent throughput with the target rate, while in other cases there exist ranges of values of the achieved rate for which the token parameters have no influence. With the latter, some modified TCP congestion control mechanisms to assure TCP throughput are proposed.

最后，在区别服务网络结构内，研究了当前提出的一种边缘路由器根据服务合同标记、分类数据包，结合内部路由器采用主动队列缓冲管理机制区别处理数据包的确信服务机制是否可在不同网络情况下使TCP连接获得同目标速率相一致的、公平的吞吐量问题；指出影响TCP连接获得同目标速率相一致吞吐量的主要因素是目标速率大小、标记算法参数和TCP连接的拥塞控制算法；对此，基于流模型假设，首次推导出一个以端到端时延、数据包丢失率、漏桶参数为变量的确信服务TCP连接吞吐量模型；利用这个模型进行分析，得到主要结论是在一些情况下可通过设置合适的漏桶参数得到同目标速率更一致的吞吐量，而在另一些网络情况下不管如何设置漏桶参数都不能使TCP连接获得同目标速率一致的吞叶量；对于后一些情况，还初步讨论了改进TCP拥塞控制算法来改善TCP连接性能的方法。

In a method providing sub-code data to a host computer in an optical disc drive formed so that data from a pick-up is reproduced through a buffer, the method includes the operations of setting sub-code data whenever data of a predetermined unit is output from the buffer, and transmitting the set sub-code data to the host computer when the sub-code data is requested from the host computer during the reproduction mode.

用于在光盘驱动器中向主计算机提供子代码数据从而通过一个缓冲器将来自拾音器的数据重现而构成的方法中，该方法包括步骤：只要从缓冲器输出预定单元的数据，就设置子代码数据，以及在重现期间，当主计算机请求子代码数据时，将该设置的子代码数据传送给主计算机。

The setting problem that says here, not be the problem that guidance causes a website to cannot be opened, below factual circumstance, the setting of a lot of leader of domestic, although the user is visited when without any problems, can open normally, but pile up to searching engine spider to return 500 errors however, so stationmaster brother wants leader when choosing leader, should multi-purpose a few online detect the tool detects whether can lead plane appear such problem

这里所说的设置问题，并不是指导致网站打不开的问题，事实情况下，国内很多主机的设置，虽然用户访问的时候没有任何问题，可以正常打开，但对搜索引擎蜘蛛却返回500错误码，所以站长兄弟在选择主机的时候要主机，要多用几个在线检测工具检测主机是否会出现这样的问题【以下内容为IT者网站提供英文翻译，未经授权请勿转载

Several common errors in the design of brace, tension rod , tension rod joints are introduced and analyzed through engineering practices.

针对这一情况，结合具体实例，总结了轻钢结构设计中在支撑设置、拉条设置、拉条节点等几方面的常见设计错误，并加以分析，供设计人员参

The paper explains the basic operation of the new type of GPS 72, and emphasizes its application in forestry survey and planning and the use method of its interface setting, parameter setting, known coordinate storage, current place coordinate storage, spot navigation, primary navigation, area survey and declination survey.

在叙说新型GPS72基本操作的同时，重点介绍了该机在林业调查规划中的应用，以及该机型的界面设置、参数设置、存储已知坐标、存储现地坐标、单点导航、航线导航、面积测量和罗偏角(指罗盘仪所测方位角与公里网坐标方位角的差)测算等的使用方法。

The closed ring confining truss is set along the periphery of the reticulated shell, and the stiffening truss is set in the middle single-layer shell which can take advantage of the architectural shape. These measures resolve the contradiction between overall stability and temperature stress, and also avoid the shell thrust act on the lower concrete structure directly. Besides, these measures simplify the design of the shell bearing and the concrete structure, and the cost of the concrete structure can also be saved.

网壳通过可径向滑动球铰支座与下部混凝土结构连接，网壳周边设置封闭环形约束桁架，中间单层壳体部分利用建筑凸肋造型设置加劲桁架，解决了保证整体稳定和减小温度应力之间的矛盾，同时避免了网壳侧推力直接传递给下部混凝土结构，简化了网壳支座及下部混凝土结构的设计，节约了混凝土结构的造价。

In the gasifying oven, there are coal feeding port and fuel gas feeding port at the top and the bottom, an inclined plane which drops coal grains and accumulates them onto the bottom, and the ventilating duct with opening over the fuel gas feeding port. It has also steam feeding port at the bottom, resultant gas outlet on the side and waste gas outlet at the upper part.

它是在气化炉的上部和底部分别设有煤供给口和燃气供给口，并设有使投入的煤颗粒落下、堆积到底部上的倾斜面，以及开口端在燃气供给口的上方、在炉内朝上延伸的通风管；还在气化炉的下部和侧部分别设置蒸汽供给口和生成气体排出口，并在上部设置废气排出口。

This consisted of a pillar on which were speed settings, the sight being fixed to an arm fitted at right angles from the top of the pillar which varied the line of sight according to the setting.

这个系统有一个带有速度设置的立柱，瞄准镜固定在一个臂上，这个臂与立柱成直角安装在立柱之上，立柱上刻有不同的线做设置的参照。

In this article , the application of PLC in straightening and cutting the steel bar with regular length is introduced, measuring the length by high speed counter in PLC, cutting the bar by servo working-bench with pneumatic clamp and setting the length and showing quantity of the bar straightened, shutting down without bar or in malfunction.

介绍了PLC在钢筋定长矫直切断中的应用，提出利用PLC的高速计数器进行测长，气动夹具随动剪切，用显示装置完成长度设置、产量设置和产量显示，实现无料与故障自动停

Note also that these settings only need to be set manually if you wish to transfer more than 64K of data in a single transfer.

另请注意，这些设置只需要手动设置，如果你想转让一个转让超过64K的数据。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。