计算程序

System volume flux was gained by loop integral the momentum equation. The simulation program was complied under the real-time simulation support system, ASCA.

在实时仿真支撑系统ASCA下编写了计算程序，通过改变程序运算速度达到实时的需要。

Based on the simulation model theory of temperature and stress fields presented in this article, a large simulating program for high RCCD has been developed, which can numerically simulate all kinds of temperature control measures, including water pipe cooling, heat insulating in winter, reducing place temperature of concrete, spraying water brume, and long interval over-watering surfaces overflowing in flood season..

基于本文提出的温度场和徐变应力场仿真模型理论，编制了高碾压混凝土坝的三维有限元仿真计算程序，在程序中考虑了各种温控措施的数值模拟，包括：水管冷却、冬季保温、降低混凝土的浇筑温度、夏季混凝土表面喷水雾、施工汛期坝顶面过水等。

But there isn't a open and general program which can systematically compute heat transfer and wall temperature of vectored nozzles cooled with varied film models to date, not to say spectral properties.

但目前国际上尚无一套公开的、通用化的计算程序可以系统地计算各种形状的矢量喷管在采用不同气膜冷却方式下的换热及温度分布，并能分光谱计算喷管的红外辐射特性。

Numerical simulation methods of infrared characteristic s of vectored nozzle in the spectrum range of 2 100～5 260 cm~(-1) are studied and corresponding Three Dimension (3-D) program was developed.

研究了轴对称矢量喷管在光谱2100～5260cm-1范围内红外特性的数值计算方法，并开发了三维计算程序，可以计算喷管在加力与非加力状态下的红外辐射特性。

The wind shear,yawing,structural parameters and installation parameters are taken into account to make the theoretic model more close to the wind turbine in opera...

应用所设计的气动性能计算程序对一台1.3MW的失速调节风力机进行了气动性能计算，与国外大型商业软件的计算结果取得了良好的一致性，从而验证了模型的正确性和实用性。

One thing is to analysis the overvoltage due to the switches of compensating capacitorusing ATP-EMTP program, the other thing is to develop an ovevoltage monitoring system to monitorthe overvoltage at the substation. Based on a real 10kV substation model, the simulation resultsunder various operating modes indicate that the overvoltage of the capacitor is much greater whenthe 10KV bus is light-loaded or the switch is multi-reburning.

论文主要进行两方面的工作，一方面以某一10kV变电站为原型，建立了补偿电容器投切过程过电压的仿真计算模型，利用ATP-EMTP电磁暂态计算程序对多种工况下电容器上的过电压情况进行了仿真计算；另一方面设计组建变电站配网过电压测试分析系统，开展现场实际过电压的监测。

In the calculation of transverse bent of wharf on high-piles,p—y curve method is used instead of "m" method to consider the interaction between pile and soil,and the program is designed.

在高桩码头横向排架的计算中，用p—y曲线法代替m法来考虑桩土的相互作用，并编制了计算程序，通过分析表明，p—y曲线法比m法更能真实反映桩土相互作用的非线性，计算结果更符合工程实际。

On the basic assumption of WENCAL,using pre parameter method,the equation calculating multi element beam of different section and elasticity modulus on different groundsill are given in this paper. The programming language is QBASIC.

依据文克尔基本假定，利用初参数法推导出不同地基及不同地基梁截面弹性模量的多单元弹性地基梁计算公式，并用已编制的 QBASIC语言计算程序，通过实例计算，结果正确、合理。

On the basic assumption of WENCAL,using pre-param eter method,the equation calculating multi-element beam of different section and ela sticity modulus on different groundsill are given in this paper.The programming language is QBASIC.The results of example show that the calculation is correct and reasonable.

文摘：依据文克尔基本假定，利用初参数法推导出不同地基及不同地基梁截面弹性模量的多单元弹性地基梁计算公式，并用已编制的QBASIC语言计算程序，通过实例计算，结果正确、合理。

The new calculation method of structural surfaces with different scales is given on the basis of block discrete element method in which contacts face to face. Moreover, a new discrete element model for simulating rock and soil blasting problem is built. The elements of new model can be split by itself in the program. There are small scale blocks around the charge, and large scale blocks are adopted in far zone.

在块体离散元面－面接触的基础上，给出不同尺度结构面的计算方法，建立离散元对岩土爆破模拟的计算模型，实现块体白分裂计算程序，在药包附近采用小尺度块体，远区采用大尺度块体，可以更为准确地描述爆破载荷下岩体结构面的尺寸效应。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。