计算程序

Using finite element method for 16 frame-supported continuous masonry walls composed with the normal law,the paper presentes a simple method of calculating bending moment of control cross section of joist s based on Matlab.

通过按正交设计的16榀框支墙梁的有限元结果分析，采用Matlab程序回归得出了托梁控制截面弯矩计算的简单公式，可以供设计者参考。

This is used to calculate the astronomical elements Kepler track procedures used MAtlab prepared, Welcome oh.

这是用于计算天文中的开普勒轨道元素的程序，用MAtlab编写的，欢迎使用哦。

The article provides the C language programming of the calculate formula and formula paragraph in the form of Java language to set up decision tree.

论文同时给出了ID3计算公式的C语言编程和实现决策树的Java程序段。

3DDeconvolve program of AFNI was used to estimate the hemodynamic response function and to generate activation maps. Then the laterality index was calculated and tested statistically.

使用AFNI软件的反卷积程序生成激活图，计算一侧化指数并进行统计检验。

Letter custom stock access plug-ins, embedded access to the letter, enter a parameter, and then stocks in accordance with the relevant data, and then output the data I need.

详细说明：通达信自定义选股插件程序，嵌入通达信，输入某个参数，然后根据相关的股票行情数据计算，然后输出我需要的数据。

This procedure is based on the simplex algorithm for the calculation was made of small linear programming software.

本程序就是基于单纯形算法写的计算线性规划的小软件。

A FDTD program was written and the electromagnetic fields for various polarized incident beams are calculated and the polarization states of the diffractive waves are extracted. The relation between the polarization state of the diffraction wave and the grating balzed angle and polarization angle for the linearly polarized incident wave is analyzed; In the spectral range of 1530 ~ 1570nm, the polarization dispersion is studied for the linearly and circularly polarized incident beam.

用时域有限差分程序计算出任意偏振方向线偏光经过闪耀光栅衍射后的电磁场分布，提取衍射波的S偏振和P偏振分量，分析它们与光栅闪耀角和入射光波偏振角的关系；分析在1530 -1570nm光谱范围内，入射光波为线偏振波和园偏振波时，衍射光波的偏振色散特性与光栅闪耀角的关系。

From the comparison of the numerical example with the finite element program, the results showed that they are in good agreement under static and live load.

通过与通用有限元程序的结果比较，验证了本文算法在静力和动力状态下的计算精度和实用性。

Based on the logarithmic spiral failure surface and combined with the characteristic line throry,a new computational method is proposed and procedure is prepared.

考虑对数螺旋线的破坏面并结合特征线理论，提出了一种新的浅埋条形板极限上拔力的计算方法并编制了程序。

Methods: the rats were intragastric administered with compound recipe and extractive of longspur epimedium respectively. the blood concentration of different time points were tested by proposed established rp-hplc. data were dealed with pharmacokinetic programme, and fitted to kinetic parameter.

实验大鼠分别灌胃复方及单味药材提取物后，测定不同时间点血浆中淫羊藿苷的浓度，采用药动学程序3p97对数据进行统计学处理，进行药动学模型拟合并计算相关药代动力学参数。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。