计算的结果

So far, the soils limit analysis result in engineering practice is often obtained by taking experimental or semi-experimental measures, and it is very difficult to estimate the departure with the actual conditions. But by using KEM, the precision of soils limit analysis can be enhanced.

目前对此类实际工程问题大多是作大量的简化得到经验、半经验的结果，与实际情况之间的计算误差难以估计，而KEM（运动单元法，Kinematical ElementsMethod）则可以从根本上提高分析结果的精度。

Calculations of the density of alloys based on Bernal-type models of the alloys metal component agreed fairly well with the experimentally determined value s from measurements on alloys consisting of a noble metal together with a metalloid, such as alloys of palladium and silicon, or alloys consisting of iron, phosphorus, and carbon, although small discrepancies remained.

对于合金密度的计算，以伯纳尔建立的金属模型为基础的计算，很大程度上等同于实验中测量的结果，测量是针对于贵重金属和非金属的合金，比如说，钯和硅的合金，或者由铁、磷、和碳组成的合金，尽管还存在一些小的差异。

Afterwards, according to the optimally condition of sinter-roasting between coal and Alumina, emphasis on sinter-roasting process between coal and Bauxite, from reaction coefficient and fixed carbon content in coal and Oxidate content in Bauxite, figure out that coal and Bauxite's mixture ratio which needed in the reaction was 71.85:100, however, at the experiment can found that if to the theoretical calculation result make up the charge, the coal and Bauxite basically can not close-burning.

然后，根据煤和氧化铝的最佳烧结条件，着重对煤和铝土矿的烧结工艺进行了研究，由试验反应配比系数和煤中固定碳的含量以及铝土矿中氧化物的含量，计算出反应所需的煤和铝土矿的配比为71。 85：100，在试验的研究中发现，严格按照理论计算所得的结果进行配料时，物料基本上不烧结。

Based on collected drill hole materials and predecessor publication\'s dates on seabed sediments physical and mechanical characters in the Yellow River subaquatic delta,the distribution and engineering geological nature of this area sediments are studied systematically;though the analysis geotechnical achievement tables and compression curves of those data,the layered summation was used to calculate the final subsidence quantity;Terzaghi consolidation theory was calculated and the Plaxis software was simulated subsidence with time changes;based on measured dates and other method,the quantitative analysis results were verified,Finally this study analyzes influencing factors and proposes control measures and proposals.

本文通过收集的钻孔资料以及前人发表的黄河水下三角洲海底沉积物物理力学数据，对研究区的沉积物分布，沉积物工程地质性质进行系统的研究；通过对调查资料中的土工试验成果表以及压缩曲线分析，采用分层总和法计算最终沉降量，采用太沙基固结理论计算和Pl(来源：ABCe2论文网www.abclunwen.com)axis软件模拟沉降随时间的变化关系；通过实测数据以及其它方法验证定性分析得出的结果，最后分析引起地面沉降的因素，并提出地面沉降的控制措施和建议。

The experimental plot situated at the middle of Sichuan Basin, the peculiar resource of purple soil and subtropic climate make it become the principal part of Sichuan agriculture.This paper,using Soil Conservation Service Curve Number method,calculated the volume of rainfall runoff in 2005, through calibrating the parameter Ia and parameter CN. it can received the suitable range of parameter, and the arverage error are respectively 6.46%,10.22% and 8.40%. It also show the feasibility that the application of SCS model to estimate the volume of rainfall runoff in sloping field of purple soil

此次试验地位于四川盆地中部，独特的紫色土资源与亚热带气候的最佳组合成为四川农业的主体区域，运用SCS模型计算试验小区在2005年的三场降雨产生的径流量，通过校正Ia和CN参数，小区计算值和实测值的误差分别为6.46%，10.22%和8.40%，得到了可信度较高的结果，同时说明了SCS模型在估算紫色土流域径流量的可行性。

Experimental results show that the zero effort miss vector calculated by using approximate formulas is close to the real miss vector. Under the conditions of small initial errors, the satisfied results can be obtained by approximate function. The zero effort miss vector obtained can be used for the preliminary design and analysis of kinetic interceptor guidance.

测试结果表明该近似算法得到的零控脱靶量与真实值比较接近，在较小初始偏差条件下，简化的近似计算公式能给出满意的结果，所得零控脱靶量可用于空间动能拦截制导系统的初步设计与分析。

Then detailedly introduces the principle of pole-changing modulating speed and design feature in times pole proportion and non times pole proportion in the Mixed pole-changing simplex winding multispeed asynchronous motor , carry on discuss to the main parts of electrical machinery electromagnetism computation; by using VISUAL BASIC under WINDOWS platform for computer-aided design method for the mixed pole-changing simplex winding multispeed asynchronous machine, carries on profound analysis for the computer-aided design in the following aspect such as rotor and setting flush piece size, groove shape size, the rotor and setting winding connection, and start performance.

本文在介绍了单绕组多速电动机的概况，阐述了目前多速电机的发展现状与前景；利用槽号相位图以及混相原理对变极绕组进行了研究，确定了绕组的混相方案；并详细地介绍了混相变极单绕组多速电机在倍极比与非倍极比时的变极调速原理以及设计特点；对电机电磁计算的主要几个部分进行了讨论；介绍了使用WINDOWS平台下的VISUAL BASIC对混相变极单绕组多速异步电机的计算机辅助设计方法，对混相变极单绕组多速异步电机的定转子冲片尺寸、槽形尺寸、定转子绕组接法、定转子相带、起动性能的几个方面的计算机辅助计算进行了深刻分析；最后，对混相变极单绕组多速异步电机的样机检测试验结果进行了分析。

The results calculated by the Elovich rate equation showed that K release rates from 1 mol.L-1 HNO3 extraction ＞those from 2 mol.L-1 HNO3 extraction ＞those from H-resin extraction. Elovich equations combining with the data of H-resin and 2 mol.L-1 HNO3 successive extraction could well described the release characteristics of soil K. The correlation coefficients of the equations reached most significant levels (r＝0.956**—0.999**), and standard errors of specific K release capacities between the vaules calculated by the equations and those measured by both successive extractions were smaller(s=1.61 and 3.52). The specific release rates of soil K calculated by the Elovich rate equations were significantly correlated with the indices of soil K availability (the amounts of easily available K, nonexchangeable K, total available K in soils and K absorbed by ryegrass).

研究结果表明：1 mol.L-1 HNO3提取法的释K速率＞2 mol.L-1 HNO3提取法的释K速率＞氢饱和交换树脂提取法的释K速率；氢质交换树脂和2 mol.L-1 HNO3提取法结合Elovich模型较理想地描述了土壤K素的释放特性，拟合方程的相关系数均达极显著水平(r＝0.956**-0.999**)，土壤特征累积释K量的计算值与实测值的标准差较小(s=1.61和3.52)，且通过速率方程计算的土壤特征释K速率与K素有效性指标(速效K、缓效 K、有效K及黑麦草总吸K量)的相关性也较为密切。

In this experiment, we were successful to establish the finite element model of pelvis after subtotal sacrectomy. The calculated result was similar with the reference. The model could be used to evaluate different ways to reconstruct the sacroiliac joint.

成功建立了保留骶髂关节活动的骶骨次全切除术后骨盆的有限元模型，计算结果与文献中报道的结果较好地吻合，可认为有效，能够用于各种骶髂关节重建方式的有限元评价。

On the basis of experimental research,through compartmentalizing experimental beams into plenty of tiny cell,according to constitutive equation of each materials including steel bar,concrete,CFRP, this paper presents numerical simulation study of flexural all course of RC beams strengthened with CFRP, the theoretical results agree closely with those of the test.

在试验研究的基础上，将CFRP加固钢筋混凝土梁划分为若干个微单元，根据组成CFRP加固钢筋混凝土梁各材料的本构关系，通过数值方法，实现了对碳纤维布加固钢筋混凝土梁受弯全过程的数值模拟，其计算结果与试验所测得的结果符合较好。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。