计算的结果

Combining the definition of CWT and the derivative property of convolution, we constructed a general method to calculate the approximate derivative of signal through CWT by using the first and second derivative of Gaussian function, Haar, and the first derivative of three-order-Spline function as wavelets. As compared with the other approaches of calculating derivative, which include the numerical differentiation, polynomial filters, Fourier transform, and the recently proposed DWT method, fast calculation and simple mathematical operation were remarkable advantages of CWT method. For the signal corrupted by severe noise (Signal-toNoise Ratio=5), the satisfactory results could also obtained via CWT method through appropriately adiusting the dilations.

在此基础上，(1)结合连续小波变换的特点和卷积的微分性质，提出了使用Gaussian函数的一阶和二阶导数，Haar和三次样条函数的一阶导数作为小波函数的连续小波变换计算信号近似导数的一般性方法，与其他导数计算方法(包括数字微分法，多项式滤波法，Fourier变换法和离散小波变换法)相比，本法简单便捷，计算速度快，对于噪声含量较高的信号(S/N为5)，只要适当调节尺度即可获得比较满意的结果。

From the burden increased aspect clarify set up the necessity of station, then pass to drew up to set up generalize of transformer substation and line direction to consider, and pass to analysis of carry the data, safety, economic and dependable consider and made sure the 110 kV, 35 kV, 10 kV and station use electricity of lord connect line, then again through burden calculation and power supply scope made sure main number, capacity and model number of the transformer set, also in the meantime make sure the station uses capacity and model number of transformer, end, according to biggest keep on work electric current and short circuit calculating of calculation result, to the high pressure Rong break a machine, insulate a switch, female line, insulate son and wear a wall set tube, electric voltage with each other feeling machine, electric current with each other the feeling machine carried on choose a type, thus completed a 110 kV electricity a part of design.

本文首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。从负荷增长方面阐明了建站的必要性，然后通过对拟建变电站的概括以及出线方向来考虑，并通过对负荷资料的分析，安全，经济及可靠性方面考虑，确定了110kV ，35kV ，10kV 以及站用电的主接线，然后又通过负荷计算及供电范围确定了主变压器台数，容量及型号，同时也确定了站用变压器的容量及型号，最后，根据最大持续工作电流及短路计算的计算结果，对高压熔断器，隔离开关，母线，绝缘子和穿墙套管，电压互感器，电流互感器进行了选型，然后进行配电装置和平面布置的设计以及防雷的设计，从而完成了110kV 电气一次部分的设计。

Validated by the experimental results of direct-connected test for RBCC, a bias less than 10% is acquired, proving the feasibility on the following numerical study.

采用RBCC地面直连实验结果对模型进行了校验，计算结果与实验结果的相对误差小于10％，表明该模型用于火箭引射模态性能分析所获得的结果具有一定的可信度，可用于本文的后续研究。

The result indicates that PPDW radiation is not blackbody radiation when channel pressure is 10^6Pa.

计算结果表明，当通道压力为10^6Pa时，通道辐射在所计算的温度范围内不能看作黑体辐射。

The inference in Credal network is the computation of tight lower and upper bounds for conditional probabilities.A new algorithm for inference in Credal networks is presented based on the framework of bucket elimination.The burden of computation is alleviated by enumerating some of values and the accurate result is obtained.

Credal网络的推理是计算一定证据下的后验概率最大值和最小值，给出了一种Credal网络推理的新方法，该方法是在桶消元框架下通过枚举计算部分因子函数值，使计算量大大减小，并且可以得到精确的结果。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

A research of freezing process of circular tunnel with initial temperature near 0 ℃has been made.

该解既可用于工程估算也可用来检验数值计算的计算程序及结果。

Monitored on the spot, the deformation characters of these supporting constructions are studied. Campared the calculation translocatins with the monitored translocations, the thesis believes that the translocation can be calculated by the method of "m", when the supporting structures produce small information. The translocation can be calculated by the mothod of "rigid frusta" or "the experiential expressions of shanghai area", when the supporting structures such as cement-soil wall in soft soil area produce big information.

通过实测，研究了小直径双排桩、水泥土深搅桩、土钉墙、放坡开挖等支护类型的变形特性，并用实测位移值与不同位移计算方法得出的结果进行了比较，认为对变形较小的支护类型可以采用& m&法计算位移，而对于软土基坑中变形较大的支护结构重力墙不适宜采用&m&法，其计算可以采用和参照&刚性墩&法和&上海地区经验公式&法。

Therefore, the calculation method used in this paper and the diffusion model presented by Wu are proved to be correct and reasonable. There are many screw dislocations in the surface films.

将扩散方程进行空间域和时间域离散，进行有限元计算，计算值和二次离子质谱测得的结果进行对比，两者基本吻合。

By introducing an effective charge, the influence of the first term of the transition matrix element is considered that makes our model more perfect and the results give good agreement with experimental measurement.

本文引入一个有效电荷，通过对它进行调整考虑了变换矩阵元中的第一项的影响。最后把计算结果与实验结果及他人的结果进行了比较，与实验结果符合的很好。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。