计算电路

In addition, the main part of the rectifier and filter circuit, power conversion and other sectors circuit is analyzed and given the parameters and options.

此外，分析了主电路部分的整流滤波、功率变换等环节，给出了参数计算和选择的方法。

Development and experimental study of the key parts of foreside control ultra high speed injection moldingThe designing theories and methods of microdisplacement actuator for controllable nozzle based on GMM are proposed. The designing process of such components as microdisplacement transfer and amplifier mechanism, driving coil and control circuitry is presented particularly.

前端控制式超高速注射成型关键部件的研制及相关实验研究提出了可控喷嘴用超磁致伸缩微位移驱动器的设计理论和方法，通过理论分析计算优化了驱动线圈和控制电路的设计。

The proposed method doesn't need hardware synchronization circuit and can perform the calculation of fundamental positive sequence component of the supply voltage in real time.

这种方法不需要硬件同步电路，能实时地计算电源电压中的基波正序分量。在以DSP为平台的样机上进行了交流调压的实验。

The pulse power supply consists of three-phase half-wave thyristor rectifier and IGBT chopping circuit.

该电源采用三相半波晶闸管整流电路，IGBT进行直流斩波；根据电流电压反馈信号计算偏差，进行数字PI调节获得恒流、恒压输出特性；控制系统通过20mA电流环异步串行通讯接口与人机界面交换数据。

We choose the TMS320VC5402, digital signal processor, as the computing unit, filtering the sampled signal, truncating the harmonic whose frequence greater than 2500hz, then we use the window-interpolation FFT algorithm to get the refined frequence, amplitude, phase of harmonic in sampled voltage and current, other parameter such as harmonic ratio, active power, reactive power, power factor, three-phase unbalance can be also computed base one the result of window-interpolation FFT.

选用TMS320VC5402高速数字信号处理器作为运算单元，先对采样信号进行数字滤波，去除50次以上谐波分量，然后应用加窗双峰插值FFT算法计算电压电流的各次谐波频率、幅值和相位，以及谐波含有率、有功功率、无功功率、三相不平衡度等各项电能指标，同时利用锁相环电路硬件跟踪电网频率以减小采样失步度。

In high resistance circuits, the noise bandwidth is often limited by the time constant of the source resistance and input capacitance, and this value In this case, noise bandwidth is

在高阻电路中，噪声带宽常常受到源电阻和输入电容的时间常数的限制。这个数值为上述各种噪声带宽计算结果中的最小者。在这种情况下，噪声带宽为

The interclass difference matrix is calculated by using the fault class feature data from simulation in order to determinate the ambiguity sets.

算法利用电路仿真故障特征数据计算故障的类间差异矩阵，从而完成故障类模糊集的确定。

The action mechanism of the stun gun is analyzed in detail and the scheme design of the stun gun system is completed. With the SolidWorks software, three-dimensional model of the system has been constructed. The characteristics of the interior ballistics of the proposed scheme of stun gun are analyzed and the corresponding interior ballistics model is proposed. The numerical computation of the interior ballistics is also conducted. According to the functions of the electrical module ,the circuit is designed and the security and reliability of the system is analyzed. At last, the test scheme of the system is proposed and some experiments are carried out which validate the feasibility of the designed system.

论文中分析了电击枪的机理，完成了系统方案的设计；用SolidWorks软件建立了三维实体模型，分析了所提方案电击枪的内弹道的特点，建立相应的数学物理模型，并进行了内弹道分析计算；根据电子模块所要实现的功能设计了硬件电路；对设计的方案进行了安全性和可靠性的分析，最后拟定了试验的方案并进行了试验研究，验证了设计方案的可行性。

On this basis, the prccesses of interrupting small inductive current by the vacuum interruptor were modelled in a computer program, and the effects of the circuit conditions on the vacuums ...

通过试验和模拟计算，获得了ZN—6/600真空开关有关截流、触头间隙击穿和电流高频过零熄弧的随机特性，分析了一些电路条件对真空开关开断感性小电流时的操作过电压的影响。

In order to study the function of line surge arrester at line lightning protection equivalent circuit of line surge operation had been built considering conditions of straight lightning strike on tower top and round strike to conductor .

为了研究线路避雷器在防雷中的作用，根据雷电直击杆塔顶部及绕击导线两种情况，建立线路避雷器动作时的等值电路，推导出考虑残压影响的线路避雷器对雷电流的分流计算公式。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。