计算时间

Aiming at the strong coupling characteristic during the multi-disciplinary optimization process of hypersonic aerocraft, in order to reduce computing time and increase the feasibility of optimization process, this paper adopted the approximate method to build the responding model between disciplines, In this paper, under the condition of ensuring the engine stable and high efficient , the designing work also consider the whole aerocraft performance sufficiently from the effect of forebody and afterbody.

针对高超音速飞行器多学科设计优化过程中的强耦合特性，为了减少计算时间，提高优化过程的可行性，采用近似的方法来建立学科之间的响应模型，以此来减少每次迭代时所用的大量计算时间。

We refer to an accurate DVFS algorithm which calculates proper frequency of a program according to the ratio of on-chip computation time to off-chip access time.

我们修改现有的DVFS策略，其主要参考目前工作的程式中记忆体存取时间以及处理器计算时间的比例，计算适合的电压，节省电耗。

In view of disadvantages in present defect reconstruction methods,such as over-long time or excessive need for training samples,a new defect reconstruction method based on similar model and genetic algorithm was investigated as follows:similar model between non-axisymetric defect and axisymetric defect was represented,and proportionality factor was deduced by skin depth equation.

针对以往缺陷重构方法中普遍存在的计算时间长或需要大量训练样本的缺点，提出一种基于相似模型和遗传算法的缺陷快速重构方法，分析非轴对称缺陷与轴对称缺陷之间存在的相似模型，并利用集肤深度公式推导出两者之间的缩比因子，从而将耗时巨大的缺陷重构问题转换为二维轴对称情况下的计算问题；同时为进一步缩短重构时间，提出一种加快遗传算法收敛速度的方法。

The results show: all processors have better load balance; when the ratio of the execution time of a point addition to that of a point doubling is 3 during computing the scalar multiplication, the parallel efficiency of the proposed algorithm is up to 90%.

结果表明：各并行处理器单元具有较好的负载均衡特性；当执行并行基点判断算法，其标量乘的点加计算时间是点倍数计算时间的三倍时，算法的并行效率可达90%。

Compared with the classic fuzzy classification algorithm, which is based on the computation of the transitive closure of a given relative matrix and of the O(n3log n) time, the new algorithm decreases O time factor at least.

与经典的基于模糊传递闭包计算的模糊聚类算法的O(n3log n)计算时间相比，新算法至少降低了O时间因子。

The method is called apparent density inversion. The inversion technique overcomes drawbacks of long computation and unstable solution, it takes less than 20 seconds to compute a density data set of 128 ×128×10 points on a PC of 1.99 GHz. The method is demonstrated on synthetic models and on real gravity data

本反演方法克服了传统已有方法计算时间特别长、解稳定性差的缺点，在主频1.99 GHz的微机上，反演128×128×10个密度值的计算时间小于20 s，理论模型和实际资料的应用表明反演具有较好的效果。

The workunits generated at first by the S5R4 workunit generator all at the upper end of the runtime variation for a given frequency band. They should average out over time, but at the beginning we got all "bad" ones.

S5R4目前的任务单元计算时间都偏长（译注：所以导致得分率的实际降低比例超过了25%），以后的任务单元计算时间平均来说会比较正常，但现在最早这批全是时间比较长的

When analyzing wrinkling and fracture, it is found that the results of the simulation have a better consistency with the results of simulation using real drawhead than using equivalent drawbead of Dynaform. Furthermore, compared with simulation using real drawbead, simulation using equivalent drawbead spends less time on both computation and modeling.

在模拟软件Dynaform中，将建立的拉延筋阻力计算模型作为等效拉延筋使用，模拟分析了表盘座某部件的成形，在分析起皱、破裂等成形问题时，比使用Dynaform自带等效拉延筋更接近使用真实拉延筋模拟的结果，而且，比使用真实拉延筋模拟节省了计算时间及建模时间。

The multi-stage Tabu Search fits for the situation where the problem has middle size, the quality of solution is important, and the speed is not restricted too much.(4) The combined algorithm which shares the advantages of HR and TS—high speed and high quality—is the most practicable one for middle-scale problems.

通过仿真实验对分枝定界算法、基于运行的启发式算法、多阶段禁忌搜索算法和组合算法进行一系列的对比研究，得出以下几点结论：(1)分枝定界算法只适用于问题规模小且对计算时间要求不高的场合，它是一种最优化算法；(2)启发式算法适合于求解大规模问题，尤其是实际应用中遇到的大型问题，对计算时间要求较高而对解的质量只要满意即可。

The adaptability of arch dam to geology is more and more high, when the influence of complicated geology is considered, and the widespread used modern calculating methods in engineering, such as the finite element method, is considered during optimization design, the new challenge to old optimization design system of crown cantilever analysis is the full-automatic calculation problem of the different condition, different arch dam parameter, the possibility and the efficiency which were caused by the increments of calculation time.

高拱坝设计对地质条件的适应性要求越来越高，优化设计时要考虑到复杂地质条件的影响，最好采用已被工程界普遍接受的有限单元法等现代计算方法，这对以拱梁分载法为主的拱坝优化设计体系提出了新的挑战，除了需要解决不同条件、不同拱坝参数的全自动计算问题，还要解决由于结构计算时间增加所带来的优化计算的可行性和效率问题。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。