计算

Main creative points of the thesis are as following:1. It is the first time to apply 2-D and 3-D turbulent model of the air-water two phases flow to the study on hydraulic properties of groyne. It makes description of the turbulent flow field to be possible precisely. This offers a more accurate method to determine the water surface in channel improvement.2. Based on the results of experiment and simulation for 3-D turbulent model of air-water two phases flow, a new formula to compute the height of damming is built.3. Based on the 2-D mode and the formula to compute the height of damming, the subdivision method of 2-D computation for water surface at upstream and downstream.

本文的创新工作主要是：首次将三维水气两相流紊流数学模型应用于丁坝水动力学特性研究，使丁坝附近流场和紊动场的精细描述成为可能，为航道整治中水面线确定提供了一个更为准确的方法；(2)基于水槽实验和三维水气两相流紊流数学模型数值模拟结果，建立了新的丁坝前奎水高度计算公式；(3)基于上述奎水高度计算公式和本文二维水面计算数学模型，首次提出了丁坝上下游二维水面分段计算方法。

Then the pile-soil stress characteristics and stabilizing mechanism of the composite foundation are fully discussed. Based on the close analysis of the influence factors of the vertical bearing capacity, circular aperture extension theory is employed to establish the computing formulas for the pile vertical stress and the foundation vertical bearing capacity, respectively. Moreover, with analyzing the features of the calculation parameters such as materials of gunite mortar, jet pressure, diameter of the jet pipe, pile length, pile layout, a design theory for chemical churning pile composite foundation is proposed. Then, the variation of the pipe deformation with loads, the deformation coordination of pile and soil are studied. And methods to decide pile-soil stress ratio and the compressive modulus are developed. Meanwhile, the corresponding design method and the design parameters are proposed. In addition, studies for construction technique and quality detection of the chemical churning pile composite foundation are presented.

在此基础上深入探讨了旋喷桩的桩土受力特性及其复合地基的加固机理，从影响旋喷桩复合地基竖向承载力的因素入手，基于圆孔扩张理论给出了桩体竖向应力及旋喷桩复合地基的竖向承载力计算公式；通过对喷射浆液、喷射压力选取、喷射直径估算、桩长及桩位设计等各种计算参数的深入分析和研究，提出了一套相应的旋喷桩复合地基设计计算方法；通过计算分析，深入探讨了旋喷桩复合地基变形随荷载变化规律、桩和桩间土变形协调关系、桩土应力比及复合地基压缩模量的确定，并提出相应的设计方法和修正参数；此外，结合工程应用，对旋喷桩复合地基的施工技术及其现场质量检测方法进行了较全面的探讨。

Numerical simulations were done by ANSYS based on the finite element method,in which the functional is solved by Hamilton principle.

模拟软件采用ANSYS，数值计算基于有限元数值计算方法，并利用哈密顿原理求解泛函，在控制计算精度的基础上，得出了该电子光学系统的内部静电场分布和轴上电位分布，同时对静态条件下的电子轨迹进行了模拟计算。

The numerical method of the diffusive-gray enclosure radiation heat transfer in complex geometry was studied, and its application was introduced into these two processes to improve the quality of handsaw and single crystal.

复杂结构的辐射换热计算所遇到的主要问题是：结构复杂导致计算量巨大；辐射角系数的计算因遮挡或数值计算误差而难以满足对称性和完整性，从而导致辐射换热计算不准确。

Chapter 4 puts up the basic theory of non-linear finite element calculation methods and deduces calculation iterative formula and relevant accelerating iterative format. In the calculation of non-linear finite element, yielding element calculation is a difficult problem,"fictitious elastic stress" methods propounded in this paper puts the axe in the helve.

第四章提出了非线性随机有限元法的基本理论，并推导了计算迭代公式，为加快计算速度，提出了相应的加速迭代格式，对于基于非线性随机有限元的可靠度计算中，屈服单元的计算方法是一个难题，本文提出了"虚拟弹性应力"法，较好的解决这个难点。

In this paper the software using the method of integral equation to calculate 3D magnetic field and another two programs which use the finite column method to calculate 3D heat field with phase transition and 2D gas-flow field are completed. These programs provide such technique as the access to large quantity data and a simple but effective method to eliminate hidden lines of objects, which are necessary for the calculating of 3D field.

本文应用积分方程法，编制了三维磁场计算软件，应用有限容积法编制了考虑相变的温度场计算软件和气流场计算软件，软件中实现了大容量数据的存储，提出一种简便的消隐方法，这些功能对于三维场的计算不可缺少。

Classic technique is the Newton-Raphson iterative. But when the system grows much bigger, the computing is much more hugeness. And it is very difficult to get the result in a short time under the current hardware and software situation.

经典的潮流计算方法是采用牛顿拉夫逊法迭代计算，但是随着电力系统的规模的增大，计算量异常庞大，在现有的软硬件的很难在短时间内得到潮流计算的解。

The first part of the whole, including: the main-scale displacement and the identification, map type, weight and general layout of calculating the focus of the plan is formally established; into the second performance, including: self-transformation and-line mapping, static water Calculation and static hydraulic curve, the stability of floating state calculation; third dip into the calculation; summed up into the fourth part, based on an evaluation of the design, lessons learned, the comprehensive knowledge.

第一部分为总体部分，包括：排水量及主尺度的确定、型线图、重量重心计算和总布置正式图的确定；第二部分为性能部分，包括：仿式变换与型线图绘制、静水力计算及静水力曲线图、稳性浮态计算；第三部分为大倾角计算；第四部分为总结部分，为本次设计作出评价，总结经验教训，综合所学知识。什么专业的？搞这么复杂的东西。报酬就免了，给了我也拿不到。

On the base of analysis,two methods are given in this paper. One is the model simplification technology which reduces identity matrix K dimension considerably, and the other is the improved iteration method which reduces the amount of calculating work from n' to n.

通过研究和分析，提出两种提高系统模型计算速度的方法，一是采取模型简化技术，从而大大降低了系统特性矩阵的维数；二是改进常规的迭代计算方法，它避免了"0"元素的存储和计算，从而将计算工作量从二次方级降至一次方级。

A series of theoretical and experimental studies on the microstrip patch antennas with dielectric superstrates is carried out systematically. Firstly, a comprehensive survey of the microstrip antenna technology and its theories are presented. Then, two analysis techniques, named as the spectral domain Green's function method and the spectral domain integral equation method are developed. The SDGF method is a simplified analysis technique, which takes advantage of the spectral domain immittance approach to find the dyadic Green's function for the stratified media, and obtains the complete closed-form formulas for radiation patterns, directivity, efficiency, gain etc. Some interesting calculated results are presented. The SDIE method is capable of determining resonant frequency, radiation characteristics, input impedance etc, for the covered microstrip patch antennas. Comparing with other full-wave analyses it reduced computation and mathematical labour remarkably. The singularities near the pole location of the surface-wave modes and the difficulty of the integral computation over infinite range of oscillating integrands are dealt with actively and documented well. Results predicted by the SDIE method agree extremely well with our experimental results for resonant frequencies of various superstrates. The superstrate effects on impedance and radiation characteristics also have been investigated experimentally so that the gap due to lack of measured data and computed results for multi-layered superstrate has been filled to some degrees and two useful observations have been achieved for weakening the resonant frequency shift and optimizing the microstrip antenna gain. As a meaningful application, the design and analysis of a 4×4 patch array are introduced.

实用微带天线普遍加介质覆盖层来防护热，物理损伤和环境影响，也可能在飞行或严酷气候条件下自然形成覆盖层本论文对带介质覆盖层的微带贴片天线系统地作了一系列理论和实验研究首先，对微带天线技术和理论作了全面的综述然后，发展了两种分析方法，称为谱域格林函数法和谱域积分方程法SDGF法是一种简化的分析技术，它利用谱域导抗法来求得分层媒质的并矢格林函数，并得出方向图、方向性系数、增益等参数的完整的闭式公式，给出了一些令人感兴趣的计算结果SDIE法能确定介质覆盖微带天线的谐振频率、辐射特性和输入阻抗等与其它全波分析方法相比，它明显减小了计算量和数学工作量已有效地处理了表面波模极点附近的奇异性和对振荡的被积函数的无限区间积分计算的困难对于不同覆盖层情况下的谐振频率，由SDIE法所预示的结果与我们的实验结果吻合得很好对于覆盖层对阻抗和辐射特性的影响也已作了实验研究这在某种程度上填补了缺少实验数据和计算结果之间的间隙，并得出了缓解谐振频率偏移和优化天线增益的两点有用的结论作为有意义的应用，介绍了一个4×4元矩形贴片天线阵的设计和分析。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。