角锥

How does the angular error produced by manufacture affect the reflective characteristic of moving angular cone prism?

角度误差对运动角锥棱镜反射特性有何影响，国内未见报导。

Optical design of cube-corner retroreflectors having curved mirror surfaces.

用矢量方法分析角锥棱镜直角误差对其光路反射特性的影响。

A simplified computing method for radiated fields of the curvilinear antenna is presented.

基于简化计算方法，分别得到了圆柱螺旋线和角锥螺旋线的辐射场，并给出了高斯脉冲电流激励时的几个数值计算的实例。

The positions at cavity mirror of ray which propagates back and forth in the CCP laser resonator are analyzed, it shows that the CCP resonator with three equal dihedral angle errors (three dihedral angle errors are not 0) is an unstable resonator.

对在腔内往返传输的光线在镜面上的位置进行了分析，结果表明：3个二面角误差相同且不为零的角锥棱镜构成的谐振腔为约束非稳腔。

A unique 946 nm and 473 nm single-frequency non-planar ring cavity constituted of a thermally bonded Porro prism and a corner cube is proposed .

提出并实现了由热键合直角棱镜与角锥棱镜构成的新型946 nm及473 nm单频非平面环形激光器。

By thermally bonding the YAG crystal with 2 mm thick Nd∶YAG crystal,the Porro prism supplies multi-functions such as laser amplification,closuring the light path,polarization sensitivity to the 946 nm and so on.

直角棱镜由无掺杂的YAG晶体和2 mm厚的Nd∶YAG晶体热键合形成，可提供激光增益、光路闭合及对946 nm激光起偏等多种复合功能。角锥棱镜由熔融石英材料构成，在环形永磁铁作用下，提供法拉第旋转作用。

Finally, it is concluded that the right-angled roof prism should be used instead of the corner-cube prism.

最后得出可以用直角屋脊棱镜代替立方角锥棱镜的结论。

Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with

通过对Wisterch参数，钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸，并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同，导致钢丝进出模具的温度差别对钢丝机械性能的影响，在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验，得出结论，工作锥角越大则钢丝与模具接触长度越短，钢丝变形越剧烈，在模具中发热量就越高，导致钢丝出模温度高，使钢丝强度、硬度升高，弯曲、扭转次数降低，并且降低模具使用寿命。在其它条件相同的情况下，定径带越长则钢丝与定径带简壁磨擦增大，使钢丝发热量加大，从而使钢丝强度、硬度略升高，弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。

In different conditions on fluidized state and stability of conical fluidized bed. The conlusions are: the conical angel of the conical fluidized bed is 20°, the fluidized state havesmall difference in conical distributor and distributor plate. The angle of conical bed increase,the fluidized state will have big difference. The angle is 60°and the conical as distributor, themass of fluidized is less, the most of material is the bottom of conical bed. The effect ofdistributor plate is much better than the conical distributor. Sawdust and rice hull can fluidize.The annular gap of conical distributor different, the angle of conical bed is same, the fluidizedquality of 10mm annular gap is better than the other conical distributors. The annular gap ismore wide, the conical bed have more slugging phenomenon and the pressure fluctuate is turnbig.In the experiment the flow of 2％and 4％distributor plates don\'t easy to control, becausethe pressure is very big and the pressure fluctuate of conical bed is too big.

在不同的条件下对锥形床的流化状态和稳定性进行了研究，结果得出：锥形床的锥角为20度时，分布锥和分布板的流化状态相差不明显，随着锥形床锥角的增大，分布锥和分布板的流化现象会出现明显的变化，锥形床锥角越大，分布锥的流化状态变化越明显，流化的的物料越少，大量物料都聚集在锥形床底部，而分布板在加料量少的情况下，能流化起来。10mm、15mm和20mm环隙分布锥在锥形床锥角相同条件下，10mm环隙分布锥的流化质量要好于其它两个分布锥，环隙越大越容易出现腾涌现象的产生，压降波动范围增大。2％、4％和6％开孔率分布板在本实验测定时，2％和4％开孔率分布板的流量不容易调节，同时产生的压降波动范围也很大，比较来说，6％开孔率分布板流化质量好些。

The cells full of crystals observed in orient tobacco were verified to be crystal idioblasts. The crystals observed by SEM were multiangle.

研究表明，香料烟株内结晶细胞是一类特化的含晶细胞，细胞内充满晶体，晶体形状似角锥状，质体等被挤到细胞边缘。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。