角距

The spiral angle of graduated circle was rough estimated by measuring the addendum circle diameter and modified on milling machine.

介绍了精确测绘单一斜齿圆柱齿轮齿形参数的简便方法，即测量公法线长度计算基圆齿距从而查表确定模数和压力角；测量齿顶圆直径估算分度圆螺旋角，用分度头在铣床上修正分度圆螺旋角，并进行误差分析。

Through transformation of parameters, the meshing design system among Hy-Vo silent chain, sprocket and hob was built up based on the research of the pitch increment and the equivalent apothem increment of the effects on the common normal line length when the Hy-Vo silent chain was wrapped around and located on the sprocket, with the proper meshing conditions of Hy-Vo silent chain and sprocket into consideration. The design method of common normal line length was put forward that can be used when the value of the sprocket pressure angle was equal or unequal to the value of the Hy-Vo chain plate pressure angle.

在分析Hy-Vo齿形链链节围在链轮轮齿上定位时其节距增量和当量边心距增量对链轮公法线长度影响的基础上，根据Hy-Vo齿形链与链轮的正确啮合条件，通过参数变化，建立了Hy-Vo齿形链－链轮－滚刀三者之间的啮合设计体系，提出了既适用于链板齿形角等于链轮压力角情况，也适用于链板齿形角不等于链轮压力角情况的Hy-Vo齿形链链轮公法线长度的计算方法。

Considering the factors such as randomness of natural lightning locus and the coexistence of primary and secondary leaders, it is necessary to lead in the concept of dynamic lightning protection shielding angle. It is suggested that the angular bisector of practical protective angle formed by ground wire or earth pin in UHVAC transmission line and conductor should be aligned with the direction of lightning leader as well as the ratio of vertical span to horizontal span and the impact of wind speed should be considered.

考虑自然闪电轨迹的随机性和雷电主先导与次先导并存现象等因素，有必要引入动态防雷保护角概念，建议特高压交流线路中地线对导线的实际保护角形成的角平分线应与雷电先导的来向一致，并应计及垂直档距和水平档距的比值和风速的影响。

In respect to the relationship between cam profile and pressure angles, the design method of cam profile with constant pressure angle was discussed and the cam profile was derived by means of the Euler Formula and the FORTRAN program.

在讨论了凸轮轮廓曲线与压力角的关系的基础上，探讨了等压力角凸轮机构轮廓曲线的设计方法，用改进型的欧拉公式经 FORTRAN编程得出相应的轮廓曲线，并着重分析了凸轮机构中基圆半径、偏距和压力角各参数的变化对凸轮轮廓曲线的影响。

The measurement accuracy of the photoelectric theodolite is decided based on measurement requirement of the ballistic trajectory. Two simple equations were derived mathematically, one expression for positioning error of the ballistic trajectory, angle error of the photoelectric theodolite, ranging error, target slant range and height when one instrument is used, another expression for positioning error of the ballistic trajectory, angel error of the photoelectric theodolite, target slant range and intersection angle when two symmetrical intersection instruments are used.

通过数学解析的方法，推导建立了2个简洁的公式：1）单站定位体制下弹道点位精度和光电经纬仪测角、测距精度以及目标斜距、高角之间的数学表达式；2）对称交会测量体制下弹道点位精度和光电经纬仪测角精度以及目标斜距、交会角之间的数学表达式。

The centre of infraspinous fossa was infraspinatus. The distance from the origin of teres minor on the margo lateralis of scapula to inferior angle of scapula was 5.8-7.0 cm and it was 4.0-6.5 cm for teres major.

冈下肌位于冈下窝内，小圆肌附着于肩胛骨腋缘距肩胛骨下角5.8～7.0cm处，大圆肌附着于肩胛骨腋缘距肩胛骨下角4.0~6.5cm处。

For class III malocclusion there are no significant differences in Ls-SGo,Li-SGo,upper lip length , lower lip length , Cm-Sn-Ls, upper lip angle of inclination and Li-H line . There are significant differences in lower lip angle of inclination , mentolabial sulcus angle , upper lower lip angle , H angle.

安氏Ⅰ类错合患者与安氏Ⅲ类错合患者相比，在上唇突点到SGo距离、下唇突点到SGo距离、上唇长、下唇长、鼻唇角、上唇倾角和下唇突点到H线距这些测量指标上无显著性差异；其他表示唇部形态和位置的指标，下唇倾角、颏唇沟角、H角、上下唇角都有显著性差异。

Then calculates clearances in radius direction for all kinds of nonparallel degree between input shaft and output shaft, and presents conditions of adjustability. Applies the experimental device, which is developed for this paper research, as example, introduce calculation formulation of overlapping coefficient and pressure angle while the distance between two centers is uncertain, in this way, we get the range of the center distance.

以本论文的实验研究装置为例，引入了中心距不确定状况下的重迭系数、压力角等计算公式，以两齿轮啮合时的分度圆不能相割为最小中心距，以两齿轮啮合的重迭系数不小于1为最大中心距，从而得到相应的中心距范围。

The autoaligment instrument and accuracy turntable with digital display are used to detect the step angle after 32 subdivision, and the experiment results are given, the mean-square error of step angle after 32 subdivision is less than 3.7%.

为了检测32细分后的步距角，采用了自准直仪加精密数显转台的光学测量方法，并给出了实验结果，32细分步距角的均方误差不大于3.7％。

During a low speed, the pitch angle is a constant, wind turbines keep on the optimum speed ratio between the pitch and wind so as to absorb the maximum energy.

该风力机在低风速时桨距角不变，保持最佳叶尖速比以获得最大风能；在高风速时储存或释放部分能量，桨距角仅完成限制最大输出功率，减少机械应力，风能储存在风力机机械惯性中，减少力矩冲击。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失