角系数

When the IPR method is used in the cases that there are few sources with same frequency, the matrix composed of noise eigenvectors is processed complexly. So we construct the matrix for computing the coefficient of polynomial with signal subspace.

针对IPR算法在信号较少时，噪声特征向量构成的矩阵计算量较大的问题，改进算法从信号子空间出发求出构造多项式的系数，从而求得到达角。

The soil static and dynamic universal triaxial and torsional shear apparatus which can simulate the cyclic stress characteristic of sand on seabed is used to perform experimental tests of loose carbonate sand s with a relative density of 30% subjected to vertical-and-torsional coupling cyclic shear with the rotation of principal stress axes induced by ocean wave.

利用土工静力-动力液压三轴-扭剪多功能剪切仪模拟海洋波浪的加载形式，对相对密度为30%的钙质砂进行了扭转和竖向耦合循环剪切试验，着重研究了复杂应力状态下初始主应力方向角α0和中主应力系数b对钙质砂动强度特性的影响。

On the basis of comparison of several algorithms of the calculation of unstable resonator"s mode. Fast Fourier transform method is chosen in this paper. The model of multi-layer distribution of gain is established. Sampling granularity in real space used in FFT, quotient of guard band and distance between subsections are made certain respectively. The convergence criterion of root-mean-square of plural y which is the quotient of the optical field"s distributions separated by one pass is established. Under the circs of multi-kind of distribution of gain and different measurement of distortion, the output optical field distribution is calculated.

在比较了各种计算腔模方法的基础上，根据角谱传播理论，选择FFT算法，建立谐振腔内多层增益分布模型，分别确定了FFT算法的空间采样间隔、保护带系数和分段计算的距离，选取光场往返一次之比的均方根值收敛准则，计算多种增益分布、不同镜面变形时的谐振腔输出光场分布，同时计算该光场的远场分布和传输有限距离之后的分布。

By making use of contraction mapping principle and similar matrices and graphical method ,this paper discusses some methods of asking its limit in accordance with recurrent sequence of number.3. The criteria whether Ⅰ,Ⅱ,Ⅲ types of crank-rocker mechanisms exist are given and the graphical method of synthesizing crank-rocker mechanisms with quick return characteristics are proposed.

针对目前具有急回特性的曲柄摇杆机构综合中存在的不足，对这类机构的图解法综合进行了深入的探讨，得到了行程速比系数和摇杆摆角取不同值时，Ⅰ型、Ⅱ型、Ⅲ型曲柄摇杆机构是否有解的判据，并给出用图解法综合具有急回特性的曲柄摇杆机构的方法。

Therefore, the relations among tidal inlet velocity, cross-sectional area, inlet length, phase lag and repletion coefficient as well as the effect of drift sand along the coast on the inlet have to be analyzed.

综合论述了潟湖潮汐通道口门之流速、断面面积、通道长度、延时角和饱满系数之间的关系，以及沿岸漂沙对口门的影响。

The investigation results indicated that the relative tolerances of resultant vector angle is less than 10％ and that of thrust coefficient is less than 2％ while nozzle vectoring, and the infrared radiation distribution of computation is consistent with that of engine test roughly as well as to meet the demands of engineering design for AVEN basically.

结果表明，在矢量状态下，气动矢量角的相对误差不大于10％，推力系数的相对误差不大于2％；在非矢量状态下，红外辐射的计算值与发动机实测值相比，其空间分布基本一致，基本可以满足工程设计的要求。

This method use the silhouette of object in image as feature, after approaching with polylateral, a serious control point can be got, the feature vector of object's contour can be got by calculating the parameter of AR model, which use the sequence of angles got from control points.

该方法以目标二维方面图轮廓为特征，经多边形逼近获得边界控制点，计算出边界控制点对应角序列的AR系数作为相应方面图的特征向量，建立三维目标的在各种姿态下的姿态特征库。

The dissipation factor tip-up D tan d , the change of capacitance D C / C 0, the maximum discharge q max and the mean discharge magnitude q mean , A compared investigation of the correlations between V min , V av and service time were compared with those between D tan d , D C / C 0, q max, q mean and respectively.

对大量的不同运行年数的线棒进行了超声波 V min 和 V av 测量，以及介质损耗角增量 D tan d 、电容变化率 D C / C 0、最大放电量 q max 和平均放电量 q mean 等电气测量试验，对比研究了超声参数( V min 和 V av )和电气测量参数( D tan d 、 D C / C 0、 q max 和 q mean )与运行年数的相关性，发现， V min 和 V av 与的相关性很强，相关系数 R 分别为0.892和0.890，而 D tan d 、 q max 和 q mean 与的相关性较弱， R 在0.55~0.60范围内， D C / C 0与几乎没有相关性， R 仅为0.310；采用线性回归分析，分别建立了 V min 和 V av 与的二阶和三阶线性函数的数学模型， R-S 分别为0.828和0.903，并分别提出了最可靠运行年数和置信度为95％的可靠运行年数的预测方法。

Finally, the boundary feedback control of the undamped Euler-Bernoulli beamwith both ends free is concerned.

最后，对两端自由的变系数无阻尼Euler-Bernoulli梁采用旋转角、角速度和位移、速度的线性边界反馈指数稳定化问题进行了讨论。

Analyzing the proved experiences of four kinds of end-bend models, and assuming a minor deviation, with the application of the aforementioned total pressure coefficient and deviation calculation model on the undesigning operating condition, numerical estimate is done on the characteristics change at designing rotating speed (n＝1. 0) after applying five various kinds of end-bend models.

总结了国内外有过成功经历的4种端弯模式，并且在小偏离假设下，应用上述非设计工况总压损失系数和落后角计算模型，对74A压气机采用5种不同的端弯模式后，在设计换算转速（n=1.0）下的特性改变情况进行了数值预测。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。