角形

For gas flow past cylinder, the characters of flow field in different Mach number and Knudsen number condition were investigated, and especially for low Knudsen number cases, the results were compared with calculating results of Euler's equation. It showed that they are correspondent by comparing the characters of bow shock and wake. The convergence rates of different high resolution and implicit schemes were also investigated. The convergence behavior of the implicit WENO scheme developed in this paper is better than others. For gas flow past NACA 0012 airfoil, the calculating results were compared with results of experiment. It showed that the results of WENO scheme are of higher accuracy for the case with angle of attack.

在圆柱流场时，我们探讨不同马赫数且不同纽森数时的流场特性，并在低纽森数时，与那维尔-史托克方程式的计算结果比较，我们比较了弓形震波及尾流附近的特性，其结果是相当符合的，同时我们也比较不同高解析隐式算则的收敛历程，从收敛历程图可得到，本文发展出来的隐式WENO算则有较佳的收敛效果；在NACA 0012翼形的流场中，我们将与实验结果做比较，发现利用WENO算则计算的结果，对於具有攻角的流场，亦有相当高的准确度。

Sepals 3(or 5); lateral sepals free or connate, margins entire or serrate; lower sepal large, petaloid, usually navicular, funnelform, saccate, or cornute, tapering or abruptly constricted into a nectariferous spur broadly or narrowly filiform, straight, curved, incurved, or ± coiled, swollen at tip, or pointed, rarely 2-lobed, rarely without spur. Petals 5, free, upper petal flat or cucullate, small or large, often crested abaxially, lateral petals free or united in pairs. Stamens 5, alternating with petals, connate or nearly so into a ring surrounding ovary and stigma, falling off in one piece before stigma ripens; filaments short, flat with a scalelike appendage inside; anthers 2-celled, connivent, opening by a slit or pore.

萼片3(或5)；侧萼片离生或者合生，边缘全缘或者有锯齿；更低的萼片大，瓣状，通常舟形，漏斗状，囊状，或具角状突起，渐减突然或缢缩进一分泌蜜汁具距或宽狭丝状，花瓣5，离生，上面的花瓣平坦的或者兜状，雄蕊5，与花瓣互生，合生或者近合生成环而围绕子房和柱头，在柱头成熟之前完整地从上面落下；花丝短，扁平，在里面的有一鳞片状附属物；花药2室，靠合，通过一条裂缝或者孔开裂。

It basically operates the main point as follows: The left hand holds the ticket, the palm is downward, the thumb is pinned in the middle of the left end of the front of the bank note, the forefinger and middle finger are on the back of the bank note, pinch the bank note together with thumb; Left hand the third finger naturally curly, pinch, get up bank note little finger stretch to bank note front push down bank note below the Left deviation; The middle finger of left hand is exerted oneself slightly, the bank note of tight card together with the third finger, little finger; The left hand forefinger is stretched, the thumb is moved upwards, pin the side of the bank note, keep the bank note into the tile shape; Left hand wipe from tabletop bank note, bank note turn, thumb strength wiped from tabletop to borrow prop up bank note covering of a fan and oblique to oneself of WeiKai Cheng; Three fingers of right hand dip in water, rotate and move the lower right corner of the bank note downwards sharp with the thumb, the forefinger cooperates with the thumb to rotate and move on the back of the bank note; Play in one's arms, count while ordering with right hand the third finger bank note got up to rotate; Pay attention to the posture at the some paper money, the health is straight and upright, the eyes It must keep eyeball and bank note from,put dual tactics elbow at tabletop.

其基本操作要领如下：左手持票，手心向下，拇指按住钞票正面的左端中央，食指和中指在钞票背面，与拇指一起捏住钞票；左手无名指自然卷曲，捏起钞票后小拇指伸向钞票正面压住钞票左下方；左手中指稍用力，与无名指、小拇指一起紧卡钞票；左手食指伸直，拇指向上移动，按住钞票的侧面，将钞票压成瓦形；左手将钞票从桌面上擦过，钞票翻转，拇指借从桌面上擦过的力量将钞票撑成微开的扇面并斜对自己面前；右手三个指头沾水，用拇指尖向下捻动钞票右下角，食指在钞票背面配合拇指捻动；用右手无名指将捻起的钞票往怀里弹，边点边记数；点钞时注意姿式，身体挺直，眼睛和钞票保持一定距离，两手肘部放在桌面上。

Results:The 2 male crania were dated back to the Donghan epoch. Their sex and age were determined based on morphology, The morphological observation and craniometry showed that the crania in Niya were dolichocrany, orthocrany, leptorrhine.

结果：新疆和田民乐县尼雅遗址墓葬出土颅骨的特点是：颅形卵圆形、长颅、正颅、狭颅，眶口前倾、中眶型，梨状孔下缘锐，狭鼻型，面部较突出，颧上颌角较小，犬齿窝深，鼻前棘中等。

Perianth subglobose, hemispheric, or urceolate, 5-parted or -lobed, slightly fleshy or herbaceous; segments abaxially thickened or becoming winglike or hornlike, rarely not modified, adaxially concave or cucullate.

花被近球形，半球形，或者瓶形，5深裂或者浅裂，稍肉质或草质；背面的裂片加厚的或变得翅状或角状，很少不修改，正面凹或兜状。

The effects of cylindrical lens shape and the laser-fiber distance on relative coupling efficiency are also studied.

给出了一个计算980 nm泵浦激光二极管与柱形透镜光纤耦合角向容忍度的理论模型，并选择圆形的柱透镜光纤进行数值计算，得出了在水平和垂直方向上偏转加平移时的相对耦合效率及绕光纤轴向转动的相对耦合效率的数值计算结果并加以分析，同时也研究了光纤透镜的形状和激光二极管与光纤的间距对相对耦合效率的影响。

A systematic analysis of the various combinations of the hexagonal, boat, and pentagonal star in the crystalline approximants of decagonal quasicrystal has been made. This was compared with the structural subunits in some approximants observed by high-resolution electron microscopy.

系统地分析了二维十重准晶的近似晶体相中六角、船形和五角星等结构块的不同排列组合，并与我们已用高分辨电子显微镜观察到的一些近似相中的结构单元进行了比较。

Based on a series of shear creep tests of discontinuous plane with regular dentation,the relationship between shear creep and different normal stress,shear stress,and slope ratio is obtained.

文章在规则齿形结构面剪切蠕变试验的基础上，分析了剪切蠕变随不同的爬坡角、正应力和剪应力的影响，拟合了剪切蠕变曲线，并将拟合的方程与Burgers模型的本构方程进行了比较分析，讨论了Burgers模型中剪切模量、粘滞系数的变化规律及其影响因素，取得了较为理想的结论，为结构面剪切蠕变本构方程的建立提出了较为合理简便的方法。

To obtain new ideas on optimal composite material structure, the fine structures of the trabeculae of the elytra of Allomyrina dichotoma Linné and Prosopocoilus inclinatus Motschulsky were investigated using scanning electron microscope.

为了从仿生学的角度，获得复合材料构造的最优化设计的指导思想，用扫描电子显微镜考察了独角仙和锹形虫前翅中的小柱微细构造，结果在昆虫形态学方面也得到了一些新的见解1与甲虫前翅上下层相连的小柱，其形状和尺寸的大小因甲虫种类而异。

Our company mainly engaged in: grinding wheel, emery cloth wheel, flower-shaped wheel, wire wheels, wire wheels, sponge wheels, flying wing wheel, nylon wheel, wool wheel, cloth round Ma round, cutting blades, angle grinding, sanding, emery cloth, oilstone, diamond, polishing wax, 3M scouring pad, handle a variety of grinding head polishing polishing material.

我公司主要经营：砂轮、砂布页轮、花形页轮、钢丝轮、铜丝轮、海绵轮、飞翼轮、尼龙轮、羊毛轮、布轮麻轮、切割锯片、角磨片、砂纸、砂布、油石、金钢石、抛光腊、3M百洁布、带柄磨头等各种抛光打磨材料。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐