角宽度

Given an angle of rotation, theta, and knowing the width and height of the

给定一个旋转，θ角，知道的宽度和高度

The influence of scattering intensity and angular distribution on scattering characteristic for different beam width is discussed by numerical simulation,and compared with those for the plane wave.

通过数值计算，讨论了散射强度及角分布在不同波束宽度情况下对其散射特性的影响，并与平面波的情况做了对比。

Experimental studies on angular distribution of photoelectrons are suggested to obtain information on widths of some states, which cannot be obtained from total cross section measurements.

我们详细探讨这些共振附近角分布和极化参数的变化，以及其与共振位置与宽度的关系，并且提供将来实验探讨的面向。

First, we have proved that the constraint of local constant gradient angles is equivalent to the minimization of total variation. Based on this, a stronger continuity constraint of gradient angle is presented. The interpolation formula (a 3-degree-PDE) derived from the constraint can ensure the continuity of level lines and reduce the width of edges. The contrast invariant of the regularizer of the formula is also proved.

首先证明了局部恒定的梯度角约束插值等价于总变分最小化；在此基础上，提出一个具有更强连续性的梯度角约束，由这个约束条件导出的三阶偏微分方程使插值的图像既可以保证水平线方向的连续性，又减小图像边缘的宽度；最后证明了插值方程中正则项的对比不变性。

Comclusion: transpetrous presigmoid retrolabrinth approach was rational approach for surgery on petroclivus and -4- CPA; it抯 important for accomplish the surgery to study and master the anatomy and variance of this approach; there was relative anatomical relationship among those structure on posterior of petrous bone; AAMP was the extracranial mark of inflexion of TS and SS; LAM and PSC were obvious bone marks for operation; we can confirm the abraded range of petrous bone lean upon LAM and/or GSS beside abrading step by step as literature, and it抯 unnecessary and unrational to emphasize to show PSC if the surgical space was enough; preceding sigmoid sinus and high jugular bulb often appeared at right and would bring disadvantage effect; interspace ,between CN V and CNVII or CNVII and CNJXI, were available to reach clivus and manage the mass on the range.

经SS前迷路后入路是处理岩斜坡区、桥小脑角区病变理想的手术入路；研究和熟悉手术入路中的解剖结构及部分变异对指导手术十分必要；岩骨内测面的骨性结构之间有着相对稳定的空间关系；顶乳缝前角是SS和TS转接处在颅外的标志；IAM和PSC等结构可以作为手术中的重要骨性标志；以PSC确定岩骨的磨除范围是较安全和可靠的，但亦可以结合影像检查，以内耳道和乙状窦前缘为基点判定切除范围，如果操作空间足够，过分强调磨出半规管是不适当的；右侧GSS的宽度和深度较对侧大，SS前置和颈静脉球高位较对侧多见，这些都对右侧入路有不利的影响，但仍可以进行手术操作；三叉神经和面神经间隙及面l 神经和舌咽神经间隙方便到达斜坡并处理病变。l

Methods: Eighty-six normal knee joints were measured. The height and width of the anterior, mid-body and posterior horn of medial and lateral menisci were measured on MRI for limbs.

采用膝关节专用线圈对86只正常膝关节的半月板的前角、后角及体部进行高度和宽度的测量。

Results: For the medial meniscus, the height and width of the anterior horn were 4.53mm and 7.89mm, the height of width of the mid-body were 5.79mm and 8.65mm, and the height and width of posterior were 5.39mm and 11.32mm, respectively.

结果 内侧半月板前角、体部、后角的宽度和高度分别为4.53mm和7.89mm，5.79mm和8.65mm，5.39mm和11.32mm。

For the lateral meniscus, the height and width of the anterior horn were 4.73mm and 9.23mm; the height of width of the mid-body were 6.39mm and 9.87mm; and the height and width of posterior were 6.15mm and 9.62mm, respectively.

外侧半月板前角、体部、后角的宽度和高度分别为4.73mm和9.23mm，6.39mm和9.87mm，6.15mm和9.62mm。

The flow .structure and river bed deformation near piers when an angle exists between the trend of piers and the direction of main-flow will be different from those when the angle equal to zero, such as the flow-obstructing width will increase, the diversion function will occur, the partial scouring pits get larger and deeper, and the main-flow and thalweg within a certain distance downstream the piers will deviate to on...

对桥渡附近的河床变形进行了实验研究，认为在桥墩走向与主流方向存在一定偏角时，桥墩附近的水流结构和河床变形将会不同于没有偏角时的情况，如增大阻水宽度，起到导流作用，使局部冲刷坑增大变深，以及能使下游一定范围内主流位置和深槽位置向某一侧发生偏移。

The results show that the temperature of the alloy gradually decreases from the casting mouth to the exit in the roll-shoe gap, and the isothermal line deviates from the shoe side to the roll side.

结果表明：辊靴型腔内合金的温度从入口至出口逐渐降低，合金等温线向工作辊偏移；随着浇注温度的降低，辊靴型腔内半固态区间逐渐增大；为了获得优良的半固态金属浆料，确定浇注温度为710~770 ℃；合金在辊靴型腔内层流运动时，越靠近工作辊内表面，合金的运动速度越快；随着挤压模具扩展角的增大，挤压模具出口型材宽度上中心与两侧边部合金的温度差减小；半固态合金进入模具后呈辐射状逐层向前推进填充模具扩展腔，最后再逐渐向模具出口合拢；为了改善模腔内金属流动速度的不均匀性，扩展角以45为宜。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。