覆膜的

Avoid foaming of polymer-coated products are covered with plastic film in attention.

避免覆膜后的产品起泡也是覆膜中应引起重视的问题。

Screen printing is a polymer-coated paper with ice flower in high smoothness of surface covered with a layer of high vacuum of polymer-coated aluminum, is to determine the quality of ice screen printing quality of one of the key factors.

网印冰不攒覆膜纸是在矮平滑量的纸板表背包围了一层矮平华的假不满镀铝膜，覆膜量量是决不退冰不攒网印量量的关头不败不合之一。

In order to investigate the long-term effect of mulch-drip irrigation on the chemical properties of salt-affected soils by the method of time-space transformation. The characteristics of salinity and salt ions distribution in 0～150 cm soil profile in the fields with corn planted for one year and two years. At the same time, the uncropped saline waste land adjacent to the experimental site was taken as the control.

为了研究长期覆膜滴灌对土壤化学性质的影响，该文通过时空转化的方法研究了覆膜滴灌种植春玉米1a和2a的盐碱地土壤盐分及盐分离子在0～150 cm土壤剖面上的分布特征，同时以试验地附近未种植的盐碱荒地作为对照。

Not only good effect composite, and also the markinf matozoa near the cross-linking reaction, matozoa issued the curing approximate hard, so that when it again when heated intenerated reluctant, covered with plastic film operation the correct temperature control methods, and that is fine is extremely close to master the cross-linking reaction temperature of the resin coated temperature.

不仅复合效果好，同时还使热熔胶体接近交联反应的热点，胶体的固化近似发硬、这样当其再度受热时就不会轻易软化，覆膜操作正确的温度控制方法，就是精细掌握这种极为接近交联反应温度的覆膜温度。

Hotmelts gradually build Crystal rrepublic Crystal builds, increased sensitivity to temperature of matozoa, will be thrown out of the hotmelts of intenerated again is threatened by high-temperature polymer-coated occurrence causes a close Crosslinking thermal features, so we use water cooling and instant automatic segmentation algorithm to prevent heat build-up to resin coated products out of the heat source immediately after the creation of an area of low-temperature curing quenching.

会使热熔胶逐渐生成晶体。晶体的生成，提高了胶体到温度的灵敏性、将可能引发出热熔胶的再次软化，削弱了高温覆膜操作使其近似发生交联反应的抗热功能，所以我们使用水冷及即时进行自动分割，防止热量积聚，为覆膜产品脱离热源后即时创造一个低温骤冷固化区。

The results showed:Under the same fertilizer consumption,covered with straw and covered with film can increase the chlorophyll content and total leer area duration of the maize,can improve leaf nitrate reeducates activity,Photosynthesis and roots vigor,and the nitrate reeducates activity,the chlorophyll content and the roots vigor present positive correlation with yield. Meanwhile,average dry matter accumulation of straw-covered increased 7.1% than this of no-ploughed,yield increased 15.3%.The average dry matter accumulation of film-covered increased 20.1% than which of no-ploughed and 12.1% than which of plough and covered with straws.And yield increased 26.8% and 10.1%,notable differences.

结果表明：在相同的肥料用量条件下，秸秆覆盖和薄膜覆膜对玉米生长发育具有良好的促进作用，能显著增加玉米叶片叶绿素含量和光合势，增强叶片硝酸还原酶活性和根系活力，同时玉米叶片硝酸还原酶活性、叶绿素含量、根系活力等与最终籽粒产量呈正相关；秸秆覆盖比免耕全生育期平均单株干物质积累量增加7.1%，籽粒产量增加15.3%，薄膜覆膜分别比免耕和翻耕残茬覆盖全生育期平均单株干物质积累量增加20.1%和12.1%，最终籽粒产量增加26.8%和10.1%，差异显著。

The saving-water effect of Radish and Cabbage under PFM and appropriate irrigation,and the drought-resisting of radish seedling which seed was soaked by CaCl_2 were systematicly reseached by field observation and the experiment in door.The main results were summaried as follows:The soil temperature of 0~20cm cultivated layer was increased 3-4.5℃ in early growth period was only 1℃ in late growth period by PFM;there was more water saved up to 20.84mm in 0~60cm soil layer by PFM than no PFM in the early growth period of Radish;the yield and water use efficiency of Radish in L4 were exceeded respectively 10.1% and 21.9% of that contrast, the yield and water use efficiency of Cabbage in G4 were exceeded respectively 8.7% and 26.58% of that contrast, under PFM and appropriate irrigation.

主要研究结果如下：地膜覆盖在植株生长前期耕作层平均可增温3～4.5℃，在生长后期增温幅度减小，仅有1℃左右；地膜覆盖在植株生长前期可有效的保持土壤水分，在萝卜生长前期，使0～60cm土层内多储水20.84mm；在覆膜不灌水充分利用自然降雨的条件下生产萝卜，可比裸地正常灌水萝卜增产10.1%，水分利用效率提高21.9%；覆膜只浇一水生产甘蓝，可比裸地正常灌水生产甘蓝增产8.7%，水分利用效率提高26.58%。

Resin coated sand: all kinds of resin coated sand for iron, steel, aluminium, copper casting.

4覆膜砂：各种型号的铸钢、铸铁、铸铝、铸铜的覆膜砂

Based on the experience with more than 10 years running shell mould casting line and with the application of various resin coated sand s,some technical problems of resin coated sand s for shell mould castings were discussed.

根据壳型生产线十几年运行和各类覆膜砂应用的经验，对壳型铸造用覆膜砂的一些技术问题进行探讨。

The Measures of Improving the Sintered Strength of the Coated Sand Mold Made by Selected Laser Sintering SLS

分析了影响覆膜砂铸型烧结强度的因素，详细地讨论了提高选择性激光烧结覆膜砂铸型烧结强度的各种措施。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。