覆以薄膜

This paper deals with the phosphor used in FED, which works based on the principle of special cathodoluminescence. A processing method brought forward is that green phosphor ZnS:Cu,Al coated with a layer of SiO_2 film by sol-gel method.

针对用于FED的荧光粉应该是适合FED特殊工作机理的专用阴极射线激发发光材料，提出一种以绿色荧光粉ZnS：Cu，Al为基质，采用溶胶-凝胶法在其表面包覆一层SiO2薄膜作为FED用荧光粉。

It is seen from Fig.2 that the H concentration in the SiNx:H decreases upon annealing, however H may also effuse out towards the atmosphere.

经查验后的h分布在结构退火温度高达550 ℃，这是可见的H渗透在Si衬底上是增加相比，以作为沉积样本，因此，这是表示， H是发表对衬底上，无论是直接从A - Si ： H薄膜或从覆氮化硅：每小时它是从图2表示的H浓度在氮化硅： H的跌幅后，退火，但h也可能涌出了对大气中。

Transimitting extremely short, souvenirs…(when the workpiece runs at 12 m/min, its souvenirs… as 0.11s) and very small angle covered by the film, the custom paper substrate escape into the water, and at the same time to gaseity was sandwiched between film and paper, to the nature of the covering layer.

通过界面极短的瞬间（当工件运行速度为12m/min时，其瞬间为0.11s）和极小的夹角，使自纸张基体中逸出化为蒸汽的水分，又同时以气态被夹在薄膜与纸张间，以隔离层的性质覆为一体。

Therefore, we used physical mechanism trigger drug release from liposome. In this study, the small unilamellar vesicles liposome were encapsulated hydrophilic marker drug 5(6)-Carboxylfluorescein and prepared by the thin layer hydration and extrusion methods. Liposomal suspension were exposed to the magnetic field.

因此希望以物理方式驱动微脂粒药物释放，本研究以薄膜水合法与挤压法制造单层微胞微脂粒包覆水溶性药物5(6)-Carboxylfluorescein的萤光指示剂经由磁场照射，以粒径仪、界面电位仪与萤光仪发现微脂粒经由磁场照射后使得微脂粒形体改变，粒径和带电性明显变化、萤光药物释放量增加。

For the test of wound healing enhancement, the animals were anesthetized by barbiturate and then two 2 cm x 2 cm full thickness mirror-image wounds was cut along the both side of spinal cord. Then membranes of loofa and SACCHACHITIN as well as cotton gauge were applied onto the wound area of Wistar rats. The wound size and the healing progression were observed for each 3~4 days after treatment.

先用巴比妥酸盐将动物麻醉，再分别於脊髓两侧以施以全皮肤切除切两个2 cm x 2 cm镜相之伤口，再将丝瓜薄膜与SACCHACHITIN或纱布分别贴覆於伤口上，并於切除后每3~4天观察愈合情形及伤口大小。

For the test of wound healing enhancement, the animals were anesthetized by barbiturate and then two 2 cm x 2 cm full thickness mirror-image wounds was cut along the both side of spinal cord. Then membranes of loofa and SACCHACHITIN as well as cotton gauge were applied onto the wound area of Wistar rats. The wound size and the healing progression were observed for each 3~4 days after treatment. The results indicated that L.

先用巴比妥酸盐将动物麻醉，再分别於脊髓两侧以施以全皮肤切除切两个2 cm x 2 cm镜相之伤口，再将丝瓜薄膜与SACCHACHITIN或纱布分别贴覆於伤口上，并於切除后每3~4天观察愈合情形及伤口大小。

Second, a novel technique to produce a soft roller mold has been developed. A PC micro-lens mold is bent around a carved roller to form a shell-shaped cavity, and then PDMS is poured into it.

其次是滚轮式微透镜阵列软模之制作：将PC微透镜阵列薄膜包覆在刻沟矽胶滚轮上以形成一空穴，并注入PDMS溶液，待固化成型后直接制作出大面积之微透镜阵列滚轮模具。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。