装
- 与 装 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
In AUPU War, widespread use of military Pu-loading convenience, fast firing line after the loaded gun bore.
在奥普战争中,普军广泛使用装弹方便、发射速度快的线膛后装炮。
-
Derived from the 1929 fortress gun (itself a development of the old 1897 field gun) with a semi-automatic breech and an automatic loader added, the "high power" APX 75mm gun fired a mle 1915 HE round with a reduced charge at 400 m/s and the mle 1915 AP round at 570 m/s (50mm penetration at 1000 m) and its two sights and stereoscopic rangefinder allowed a direct fire range of 2000 m.
&大威力&APX型75毫米炮由1929型要塞炮(旧式1897型野炮的发展型)衍生而来,加装了半自动炮尾和一个自动装填器,发射减装药的1915型高爆弹(初速400米/秒),及1915型穿甲弹(初速570米/秒,1000米距离可穿透50毫米装甲)。
-
Major company position is basic and reasonable, ground wall uses waterproof material laid, roofing is decorated with plastic gusset plate. The enterprise of 91.67% has close cleanness of independent bathhouse, water treatment area, fill outfit area, container is alexipharmic area, warehouse for finished product, mandatory pool crossing a leg and ultraviolet sterilization lamp, character billabong is accomplished on working procedure, use machine of automatic fill outfit to be rinsed automatically entirely, disinfection and fill outfit.
大部分企业布局基本合理,地面墙壁采用不透水材料铺设,屋面用塑料扣板装修。91.67%的企业有封闭独立的更衣室、水处理区、灌装区、容器清洁消毒区、成品库、强制性过脚池和紫外线灭菌灯,工序上做到人物分流,全部采用自动灌装机自动冲洗、消毒和灌装。
-
The Company has a variety of knitting, woven, sweater, jeans, horse equipment, on-chip mounted printing, slurry, water slurry, pulp convex, pulling India and pressure velvet, hot American series of solid ink, gold and silver powder series, hair, hot , hot silver, hot stone, hot colored plastic beads, a variety of printing at the same time to develop new products.
本公司有各种针织、梳织、毛衫、牛仔、匹装、片装印花、胶浆、水浆、凸浆、拔印、压绒、美国热固油墨系列、金银粉系列、植毛、烫金、烫银、烫石、烫各色胶珠,同时共同开发各种印花新产品。
-
Do you see the glass as half-full rather than half-empty?
你看就被是装了半杯酒而不是半杯没装酒吗?
-
Do you see the glass as half-full rather than half-empty?
你看酒杯是装了半杯酒而不是半杯没装酒吗?
-
A front-back seal ring structure is adopted in the pump to prevent the liquid from leaking from the high-pressure area to the low-pressure area. The front seal ring is mounted on the pump body while the back seal ring mounted on the bearing body. They should be changed when they are so worn-out that they have an effect on the efficiency and self-priming performance of the pump after the operation for a long time.
泵内部防止液体由高压区向低压区泄漏的密封机构是前后密封环,前密封环装在泵体上,后密封环装在轴承体上,当泵经长期运转密封环磨损到一定程度,并影响到泵的效率和自吸性能时,应给予更换。
-
A front-back seal ring structure is adopted in the pump to prevent the liquid from leaking from the high-pressure area to the low-pressure area. The front seal ring is mounted on the pump body while the back seal ring mounted on the bearing body. They should be changed when they are so worn-out that they have an effect on the efficiencyself-priming performance of the pump after the operation for a long time.
泵内部防止液体由高压区向低压区泄漏的密封机构是前后密封环,前密封环装在泵体上,后密封环装在轴承体上,当泵经长期运转密封环磨损到一定程度,并影响到泵的效率和自吸性能时,应给予更换。
-
According to the character of the B/KNO3 fire composition,three igniters with different charging structure are comparative tested and analyzed,and aimed at the parameters of the electric igniter,calculation and design are made for the ignition charge,intermediate charge and igniter charge ring,then the charging structure of electric igniter for a certain solid rocket motor is determined.
基于B/KNO3点火药的特性,采用三种不同药型的点火具装药进行对比试验和分析,并针对电点火具的性能指标要求,分别对传火药、过渡药、点火药环进行了计算和设计,确定了适用于某固体火箭发动机用电点火具装药的药型。
-
The first direct measurement with micrometer diameter piston skirt, and then dial indicator card installed and the initial installation of the amount of good cylinder rod inserted card table micrometer mounted on the anvil between the seat and the measuring bar, adjust the volume of cylinder table Interpolation of the extended length of rod, when the dial indicator has small hands around 1.5-2 cell volume preloading lock locking rod inserted mother, and a large dial indicator to zero adjust the final stretch to the volume of cylinder table into the Cylinder Sleeve, large dial indicator hands than "zero" low value (considering the small hands reading) is the piston and cylinder liner with the space.
2先直接用千分尺测量活塞裙部的外径,然后将卡装好百分表和初步安装好插杆的量缸表卡装在千分尺的砧座和测杆之间,调整量缸表插杆的伸出长度,当百分表的小表针有1.5-2格左右的预压量时锁紧插杆锁母,并将百分表的大表盘调整到零,最后将量缸表伸入气缸套内,百分表大表针比&零&低的数值即为活塞和气缸套的配合间隙。
- 推荐网络例句
-
She gently rebuff ed him, but agreed that they could be friends
她婉言拒绝了,但同意作为朋友相处。
-
If in the penal farm, you were sure to be criticized.
要是在劳改农场,你等着挨绳子吧!
-
Several theories about reigniting and extinguishing of the arc have been refered.
本文综合考虑了几种电弧重燃和熄灭理论。