表面面积

Irregularity of acetabulum increases cement-bone surface contact and reduces pressure per unit of surface.

髋臼不规则可增加骨水泥－骨的表面接触面积并降低单位表面的压力

An area of a cross section of the second discharge-port portion that is parallel to the main surface of the element substrate is larger than an area of the border portion at any cross section of the second discharge-port portion from an opening surface facing the bubble generation chamber to an end surface facing the first discharge-port portion.

平行于元件基板的第二排放口部分的横截面面积大于边界部分在由面向发泡腔室的开放表面延伸到面向第一排放口部分的端面对第二排放口部分所做的任一剖面处的面积。

The Conclusions are: 1. The surface morphology and the area of the cutting plane exerts great influences on the fabrication of s-BLM. Good surface morphology would help to improve the stability of s-BLM in the process of its thinning.

本论文得到的主要结论如下：(1)金属基底的表面形貌和端面面积对双层类脂膜的制备有很大影响，平整的表面形貌有助于增加双层类脂膜在变薄过程中的稳定性。

With the help of infrared spectroscopy, it is known that the linkage between dodecylamine and sodium oleate and diaspore, kaolinite, illite and pyrophyllite is fundamentally electrostatic forces, which contributes to physical adsorption. The adsorption is related with surface electric property of minerals. The effect of chemical composition of diaspores on their electrokinetics was investigated.

对于一水硬铝石矿物来说，三个主要晶面（010）、（100）和（001）上的单位面积断裂键数有如下关系：〓；一水硬铝石表面吸附的动力学模拟可以说明，一水硬铝石的（010）晶面、（100）晶面和（001）晶面，分别吸附几种捕收剂离子的吸附能大小为：（010）晶面的吸附能＞（100）晶面的吸附能＞（001）晶面的吸附能；分别吸附这些药剂离子的单位面积吸附量〓的大小顺序为：（010）晶面＞（100）晶面＞（001）晶面。

Optical density d of the material or the density of photographic film itself d field part of density d the density of the deep and change some of the most high density (h-red, green, or blue channels in maximum density) L intermediate density density (red, green, or blue channels in minimum density) M minimum density (red, green, or blue channels in the middle of the density) T transmission 4.2Murray-Davies formula in the measurement of surface films, film dot business card printing and membership card making dot area usually is the most important parameters.

光学密度 D 材料或片基本身的密度 D 实地部分的密度 D 深浅变化部分的密度 H 最高密度（红，绿或蓝通道的最大密度） L 中间密度密度（红，绿或蓝通道的最小密度） M 最低密度（红，绿或蓝通道的中间密度） T 透射率 4.2Murray-Davies公式在测量胶片的表面网点面积时，胶片制卡和会员卡制作网点面积通常是最重要的参数。

The chloroplast of the mesophyllous cells in the white part of the green-white leaf of PM3 were dissolving or had dissolved.

观察其叶片表面结构和叶肉细胞超微结构，结果表明：3个突变株系的叶片气孔密度增大，气孔面积减少，单位视野中气孔所占面积比则变化不大；叶肉细胞中叶绿体体积增大，形状变圆并移向细胞中央；PM3株系白绿相间叶片的白色部分，其叶肉细胞中叶绿体多数正在或已经消解，结构不完整。

The periostea of both experimental and control side of the mandibular ramus were taken and prepared, 2 of each 5 rabbits in a group were prepared for HE stain detection and 3 for proliferating cell nuclear antigen immunohistochemical detection.Results:1, The newly formed bone was detected on the lateral aspect of mandibular ramus after periosteal distraction. The bone was shaped like a hill. It looked very low and was full of holes at postoperative day 28. With the time of consolidation period lengthened, the newly formed bone matured gradually. X-ray examination showed the new bone shaped like a hill. The average values of new bone height at postoperative days 28,35,42 and 56 were 1.86 + 0.15mm, 2.29 + 0.29mm,3.19 + 0.13mm and 4.70 + 0.45mm. Histological examination of both HE stain and picricacid-fuchsin stain showed the increase in the number of osteoblasts and the change in the orientation of collagen fibers and bone trabecula. There were no significant differences between newly formed bone and original bone on the lateral aspect of mandibular ramus at postoperative day 56 histologically.2 Compared with the control side, the distracted periostea proliferated obviously under the microscope, and the number of periostealcells increased with satiation of cellular nuclear per unit area. The images of PCNA immunohistochemical stain of periosteum showed that the experimental periosteum proliferated obviously after distraction compared with the control side.

结果：骨膜牵张成骨的实验研究南京医科大学硕{学位论文l、骨膜牵张后，可见下领升支外侧的骨皮质上有新骨形成，新骨呈山峰状凸起，术后第28天的新生骨较低平，多孔隙，随着固定时间的延长，新骨逐渐成熟；下领升支前后向切线位X线投照显示新骨呈山峰样隆起；经测量，术后第28、35、42和56天组平均新生骨厚度分别为x.86士0.15mm、2.29士0.29mm、3.19士0.13mm和4.70 土0.45mm；脱钙骨组织的HE染色和不脱钙骨组织的苦味酸一品红染色的组织学观察均显示了新生骨在成骨细胞数量上的增长，以及胶原纤维和骨小梁排列方向上的变化，术后第56天的新生骨在组织学上与原升支骨组织已无明显区别。2、HE染色显示，与对照组相比较，实验侧骨膜增生明显，细胞间排列紧密，单位面积内骨膜细胞数增多，细胞核饱满；骨膜PCNA 免疫组化染色显示，与对照侧相比较，实验侧骨膜在牵张后出现了明显的增生迹象，PCNA阳性细胞分布紧密，单位面积内阳性细胞数较对照组多，靠近骨表面的骨膜中的阳性细胞数更多而且分布更为紧密。

Dot (3.15%), surface: dot area is made of the relative collesting region transmissional density calculation.

3.15网点面积，表面：网点面积是由实地区域的相对透射密度计算而来的。

And it also possesses production line of electric jetting and electroplating (imitation gold, black nickel, bronze, white nickel and etc.).

占地面积30000平方米，建筑面积20000平方米，拥有国内先进的大、中型注塑成型机、压力机、车床等设备；拥有电熔喷漆、电镀f仿金、黑镍、青古铜、白镍等流水线表面处理。

The system can scan stereoscopicly the internal tube of the measured object, the aim is to test the internal flaws of the inspected object, such as crazing, rust-eaten and dropping of electroplated coating.

该系统对被检测物体内表面进行立体扫描，可获得被检测物体内壁疵病信息，包括烧蚀面积，裂纹深度及电镀层脱落面积等。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。