表面电阻

The thin and low-resistance conductive coating which less than 3μm and 10Ω/□was obtained through two mild post-treatments, water immersion and low-temperature sintering (150℃).

通过水浸泡与低温烧结(150℃)对导电涂层进行后处理，均能得到涂层厚度小于3μm，表面电阻小于10Ω/□的低电阻薄导电涂层。

The strength and toughness of the nanocomposites are improved because of the addition of anao-Zno. The volume resistance strength and toughness of the nanocomposites are improved because of the addition of nano-ZnO. The volume resistance coefficient is decreased 8×10 times, surface resistance coefficient is decreased 5.7×10^4 times, and the friction coefficient is decreased 29% by adding nano-ZnO. The friction, wear properties, and the antistatic property of MC Nylon 6/ZnO nanocomposite are better obviously than MC Nylon 6. The macro stress of MC Nylon 6 structure is changed by the tensile test so that the preferred orientation of crystal surface (002+202) is more obvious.

纳米ZnO的加入起到同时增强增韧的作用；使体积电阻系数降了8×10^4倍、表面电阻系数降了5.7×10^4倍、摩擦系数降低了29%，MC尼龙6/纳米ZnO复合材料摩擦磨损性能和抗静电性能明显优于MC尼龙6；经过力学拉伸试验的破坏，引起MC尼龙6结构发生宏观应力变化，造成（002+202晶面）产生明显的择优取向。

Volume and surface resistivity measurements are dependent on several factors.

体电阻率和表面电阻率的测量决定于几个因素。

5 Material type 材料类型 4.5.1 Antistatic Material: the material that used to prevent / inhibit the generation of the Triboelectric Charge; or the material that only generate less than 200V Triboelectric voltage; it has no requirement about surface resistivity and volume resistivity .

抗静电材料–能抑制摩擦生电的材料；摩擦电压在 200V 以下的材料；防静电材料没有表面电阻率或体积电阻率的要求。

TDE-85/DDS system is the suitable matrix for vapor as sisted resin transfer molding and the properties of GFRP equilibrium tube have e xceeded the technical-demands.

TDE-85/DDS体系完全符合VARTM工艺要求，其玻纤增强制品性能良好，马丁耐热为220℃，体积电阻率为2.4×108MΩm，表面电阻率为1.9×107MΩ。

The electrical properties, including surface resistance, volume resistance, breakdown strength and dielectric constant were researched mainly.

重点研究了薄膜的电性能，包括表面电阻、体积电阻、击穿强度以及介电常数等。

Polyethylene has excellent volume resistivity and surface characteristics similar to polystyrene.

聚乙烯具有与聚苯乙烯类似的、极好的体电阻率和表面电阻率。

Surface resistivity: leakage across the surface, a function primarily of surface contaminants.

表面电阻率：经过材料表面的泄漏，主要是表面污染的作用。

Humidity greatly affects the results of surface resistivity measurements and, to a lesser degree, volume resistivity measurements, as well.

湿度对表面电阻率测量有重大的影响，对体电阻率的测量也有影响，只是其程度要小一些。

However, because of ultra-high bulk resistivity and surface resistivity of PE and PP materials, the articles made of PP or PE have notorious static problem.

由于PE和PP具有极高的体积电阻率和表面电阻率而导致静电荷的积累，因此在使用中经常发生静电危害。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。