表面

The experimental results showed that under the treatment of different plasma conditions , the wool fiber surface appeared the varying degree physics and chemical corrasion .

实验结果表明，经不同条件的等离子体处理后，羊毛纤维表面出现了不同程度的物理与化学刻蚀作用，纤维的表面性能得到了较大改善。

The experimental results showed that under the treatment of different plasma renditions , the wool fiber surface appeared the varying degree physics and chemical corrasion .

实验结果表明，经不同条件的等离子体处理后，羊毛纤维表面出现了不同程度的物理与化学刻蚀作用，纤维的表面性能得到了较大改善。

With increasing La content, however, the phase structure of the alloys 〓(x=0.03-0.1) can be changed from C15 to C14, but that of the alloys 〓(x=0.03-0.1) has not still changed, and the second phase of both alloys decreases. Some diffluent phase appear on the surface of both alloys, because there some holes on the surface of alloys after corrasion.

结果发现，在低La含量时，两种合金均保持原有的相结构，但合金表面存在少量易溶相，在样品制备中由于腐蚀合金表面出现孔洞，合金的活化性能和放电容量得到提高。

The external scale of cobalt sulfide and yttrium oxide-surfide particles in the inner scale were found respectively after corrasion in Pa .!$+ lo-'' Pa Q. Beneath the external scale, a region of internal sulfidation-oxidation of yttrium was also present. The comion pduct in lo-' Pa .!$+ 10-l5 Pa Q was only a very thin surface layer of yttrium oxysulfide and an internal oxidation zone of yttrium.

并有助于降低纯Co的腐蚀速率，10＾02Pa硫压下，合金表面形成的腐蚀产物为多层、以为硫化钴，中间层为由两金属化合物怕成分复杂的混合物层，最内层是由氧和硫引起的Y的内腐蚀区；在10＾－3Pa硫压下，合金没有形成外层硫钴，仅在表面形成较薄的Y的硫氧化物，其下为Y的内氧化区。

Further reflective type measurement can be implemented by THz-TDS. Interface information is obtained from the measured THz waveform reflected from stacked burned and normal porcine skins for simulating partial burned skin. Reflective wave from surface, interface between burned and unburned, back surface of unburned porcine had been correctively and clearly observed. Waveform and time of flight matched well with the original reflected waveform of normal and burned porcine skin.

我们进一步应用兆赫光谱技术来作样品反射式讯号的量测，可以观察到用来模拟部分烧伤的皮肤的由一层烧烫伤以及一层正常的猪皮样品堆叠成的结构中的界面，经由这个模拟结构表面以及内部界面和背面反射的讯号波形都可以正确清楚地判别，所得到反射的波形以及表面和界面间的飞行时间和个别量测正常及烧烫伤样品的结果吻合。

The standard curve of correlation between membrane surface and fluorescence intensity of FPE was obtained by acid titration. The membrane surface pH was measured according to this curve.

在不影响膜结构的条件下，利用微量TritonX－100消除膜表面与介质之间的质子浓度差，通过酸滴定实验，能够得到膜表面pH与FPE荧光强度之间的相关曲线。

Gloss is associated with the capacity of a surface to reflect more light in some dirctions than in others.the directions associated with mirrorreflection nor mally have the highest reflectances,measurements by this test method correlate with visual observations of surface shininess made at roughly the corresponding angles.

登录后回答可以获得积分奖励，并可以查看和管理所有的回答。登录|机器翻译的光泽与能力的一个表面，以反映更多的光线有些dirctions比others.the方向与镜子反射，也没有马利拥有最高的反射，测量了该测试方法与视觉相关的意见作出的表面shininess大致相应的角度。

The most important part of the brain is the outside surface of the brain, called the cerebral cortex.

大脑最主要的部分是它的外表面，这一外表面称为大脑皮层。

In order to increase the reversibility and the amplitude of the salt-water oscillation, the salt-water oscillation and the liquid membrane oscillation were coupled to create a compound oscillator.

实验结果表明，有表面活性作用的物质可以增加盐水振荡的振幅，有络合性能的物质的络合作用是盐水振荡可逆的关键，既有络合作用，又可以起到表面活性剂作用的物质既可以增加盐水振荡的振幅，又可以使盐水振荡可逆。

It can get the three-dimensional profile of the object surface effectively. Because of the cragginess of the three-dimensional surface when sine grating is projected the image of the sine grating is modulated and the modulated image is taken by a CCD camera with an angel compared to projecting direction. After the phase shift measuring method, the phase is gotten. Because the phase is calculated by the phase shift measuring ranges from –π to +π it isn't continuous. The phase unwrapping is necessary to recover the continuous phase about the object shape.

这种方法采用结构光照明，将正弦光栅图像投影到被测物体表面，用与投影方向成一定角度的CCD摄像机获取受物体表面面形调制的变形光栅像，根据数字相移算法计算出相位分布，由于从相移计算的相位被截断在反三角函数的主值范围内，因而是不连续的，必须通过相位展开恢复出连续相位分布，由相位－高度关系最终求出物体轮廓的三维数据信息。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。