衍射曲线

Taking the nonlinear refraction and the nonlinear absorption into account simultaneously, this paper investigated the diffraction theory model of the Z-scan technique, and analyzed the features of Z-scan curves and their variation rules.

在同时考虑非线性折射和非线性吸收的情况下，借助光的衍射理论，研究了Z-扫描技术的衍射理论模型，分析了非线性折射和非线性吸收同时存在时Z-扫描曲线的形状特征和变化规律。

Department of Scientific History and Archaeometry; Graduate University of Chinese Academy of Sciences; Beijing 100049;4.Institute of Archaeology; Chinese Academy of Social Sciences; Beijing 100710; China;The fabrication technologies in terms of phase composition,structure,firing temperature,porosity,density and water permeability of ceramic water pipes and contrastive ceramic tilesexcavated from Anyang Yin Ruins of Shang dynasty were studied by X-ray fluorescence,X-ray diffraction and dilatometer,respectively.It was found that the contents of CaO,K2O,MgO and P2O5 in CWP were relatively higher than those in contrastive CT.The difference was further confirmed by the mass ratio of flux...

采用X射线荧光、X射线衍射、热膨胀等分析手段对比研究了安阳商代陶水管的制作工艺，发现陶水管化学成分中各类熔剂的质量分数均略高于对比陶片中熔剂的质量分数，CaO、K2O、MgO等助熔剂与A l2O3的质量比进一步证实该现象，而这种差异性则外在地表现为陶水管的气孔度低于对比陶片以及陶水管热膨胀曲线中出现玻璃化现象，该结果表明陶水管原料应为一种易熔粘土，或者在沉淀粘土中人为地掺和了草木灰类掺和料，这有利于陶水管烧制与成型，有助于熔剂在熔融状态下，较好地进入陶水管中的空隙，使陶水管变得更加致密，一定程度上有利于防止陶水管的渗水，显示出陶水管制作工艺的特殊性。

The reflectivity of the multilayer is measured at Bessy Ⅱ synchrotron radiation, and the peak reflectivity is measured to be 7.5%.

对衍射仪测量的掠入射反射曲线和同步辐射测量的反射率曲线分别进行拟合，得到的粗糙度和厚度比的结果相近。

Fully regarded the piezoelectric effect, the electrooptic effect caused by the applied electric field and based on the equation of diffraction efficiency and Bragg condition, the of between the applied electric field, the writing beam ratio with respect to the writing angles are analyzed.

全面考虑了电场作用下晶体的压电和电光效应，基于衍射效率公式和光栅的布拉格条件，给出了为获得最佳衍射效率比时外加电场及写入光束比与记录角度间的关系曲线。

The asymmetrical Bragg reflection STD scan mode with the conventional X-ray diffraction rocking curve was used to determine the lattice distortion of CdZnTe single crystal in this method.

在高分辨X射线衍射仪上，利用不对称布拉格衍射STD技术与单晶摇摆曲线技术相结合的方法，对碲锌镉单晶材料的晶格畸变进行了分析测定。

Based on theσs1/8 -T curve and X-ray diffraction analysis, the changes in volume fraction,saturation magnetization and Curie temperature of α-Fe phase and residual amorphous phase with annealing temperatures as well as the correlation between them were determined.

研究了Fe(72.7)Cu1Nb2V(1.8)Si(13.5)B9非晶合金在不同温度（763—883K）退火1h后的热磁曲线借助于碰分析的方法，由σs1/B－T曲线并通过X射线衍射分析确定了合金中α－Fe相和剩余非晶相的体积分数、饱和磁化强度及Curie温度随退火温度Ta的变化及其相互关系。

For these two effective focal lengths, the spots on the image surface at zero view field, 0.7-view field and full view field are all inside the airy disc. The system MTF curve of each effective focal length are accordance with the corresponding diffraction limits curve. The biggest wave aberration is smaller than 1/4 wave lengths. The maximum field curvature and maximum f-theta system distortion respectively satisfies the precision demand of the laser marking machine in China.

系统像面在0视场、0.7视场和全视场的光斑都落在相应的爱里斑以内，系统的MTF曲线接近相应的衍射极限曲线，最大波像差小于四分之一波长，系统的最大场曲和最大f-theta相对畸变都很好地满足了国内激光打标机的精度要求。

And the devices'properties and improve the properties to prepare the artificial boundary. The bi-epitaxial YBCO superconducting film with 45°grain boundary in a-b plane was made for the first time in China in this article by magnetic sputtering instrument that was designed and fabricated by ourselves. The x-ray θ～ 2θ scan 、Ф scan、rocking curve、non-symmetry diffraction and SEM、 TEM、AES etc. were utilized in the study.

为此，本工作采用自行设计制造的全金属密封超高真空磁控溅射设备，利用x射线θ～2θ扫描、Ф扫描、摇摆曲线、非对称衍射及SEM、TEM、AES等分析测试手段，在国内首次、也是至今唯一的一家，制得a—b平面内具有45°人工晶界的双外延YBCO超导薄膜，并进而得到双外延晶界Josephson结。

It is shown that the difference of minority carrier lifetimes were caused by the crystal defects in GaAs layer generated in bonding process.

采用X射线衍射动力学理论，在忽略衬底反射的条件下，模拟了阴极组件的X射线衍射的摇摆曲线。

The rocking curves of different area have been measured by high resolution X-ray diffractometry. The reflections were indexed, furthermore the polytype structures were identified. The results are consistent with those of Raman spectroscopy analysis. It is demonstrated that Raman spectroscopy is a simple and powerful method for the determination of SiC polytypes.

同时采用高分辨X射线衍射测量了该晶片不同区域的摇摆曲线，将不同多型体的计算衍射角与实验值加以比较，对SiC晶片中的多型进行了标注，所得结论与激光Raman光谱测定结果相一致，说明Raman光谱是一种简单、快速地鉴定多型结构的强有力的工具。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。