英语人>网络例句>螺纹 相关的搜索结果
网络例句

螺纹

与 螺纹 相关的网络例句 [注:此内容来源于网络,仅供参考]

Therefore, in order to screw suction port separated from the oil discharge screw thread section is greater than the length of at least one lead.

因此,为了使螺杆能吸、排油口分隔开来,螺杆的螺纹段的长度至少要大于一个导程。

On the basis of three kinds of load form during different work stages of casing screw thread joints, a systemic analysis is made and some useful conclutions are obtained.

本文根据套管螺纹接头在不同工作阶段的三种载荷形式,对此进行了系统的分析研究,得出了一些有益的结论。

The structural feature of the cap,the forming technology and the mechanism of side core-pulling and internal screw thread were analyzed.

介绍了一种结构新颖的旅行杯瓶盖的结构特点、成型工艺及瓶盖注射模的侧抽芯和内螺纹结构,最后叙述了瓶盖注射模设计的要点及模具的工作过程。

At present, There may existent problems in traditional method of checking and measuring screw thread ring gauge. Based on measured theory, dependability of this way of measurement is analyzed in this paper.

针对我国目前在螺纹环规测量方法中存在的问题,根据其测量原理入行了可靠性分析。

Name three diameters connected with screw thread dimensions.

螺纹直径有关的三个直径名称。

Within the cylinder 6 and the nut 9 with M58XI. 5 followed by the thread fastening screw into one.

内筒体6与螺母9用M58XI.5的螺纹连接后再用螺钉紧固成一体。

Therefore, in order to enable the screw to smoke, Pai oil separated from the mouth, screw thread length is greater than at least one lead.

因此,为了使螺杆能吸、排油口分隔开来,螺杆的螺纹段的长度至少要大于一个导程。

A small square or hexagonal metal block with internal screw thread to be fitted onto a bolt.

内侧有螺纹儿、可以被固定到螺栓上的方形或六边形金属块。

Fig. 11 Measure screw thread pitch using screw gauge

图11。用螺纹规测量螺距的方法

Something, such as the thread of a screw or the spiral condenser in a still, that resembles a worm in form or appearance.

螺纹状的物品某物,如螺旋线或蒸馏器的螺旋冷凝器,在构成或外表上像蠕虫

第36/89页 首页 < ... 32 33 34 35 36 37 38 39 40 ... > 尾页
推荐网络例句

I didn't watch TV last night, because it .

昨晚我没有看电视,因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。

I'm running my simile to an extreme.

我比喻得过头了。