薄膜层

The least loss of the magnetization due to As diffusion has been found forFe overlayer grown on the surface covered with stable GaxS layer with well-ordered sites andlittle excess As.

结果显示，表面退火后富Ga的GaxS钝化层的状态以及表面富余As的存在，决定了生长在这一衬底上Fe薄膜的磁化强度。

Reseal film, an advanced peelable technology that exposes a pressure sensitive layer when the consumer opens the package.

重新封装薄膜，先进的剥离技术，暴露了压力感应层当消费者打开包。

In this paper, a new generation polymer of guide-3,4-poly ethylene dioxythio phene was introduced. Preparation processing of PEDT films was studied. Most of principle was recommended. The influence of different process factors on PEDT films properties had been discussed, observing the surface situation ,and studying the relationship between conductivity、surface situation and mensuration of degree of polymerization .

本文介绍了新一代导电聚合物材料PEDT(3，4—聚乙烯二氧噻吩)的主要特点，相关原理，及合成方法，研究发现影响薄膜电导率和致密度的影响因素如：聚合温度，单体和氧化剂配比等，研究了PEDT材料的热稳定性，对PEDT的膜层表面形貌以及分子量的测定方法进行了研究。

The results showed that in this experiment condition the optimal preparation condition for TiO2 films which have better photoactivity was found to be: TiO2 sol concentration 0.7mol/l, the amount of PEG 0.5g, coating cycles 3, heat-treated terms 480 C, Ih.

研究结果表明：在本实验条件下，具有较好光催化活性的TiO_2薄膜的最佳制备条件为：TiO_2溶胶的浓度为0.7mol／1，聚乙二醇的加入量为0.5g，镀膜层数为3，热处理温度为480℃，保温1h。

Section BiFeO〓 is known to have rhombohedrally distorted perovskite structure with the space group R3c, which allows the ferroelectric atomic displacement below 1083K and weak ferromagnetism below Neel temperature 643K simultaneously.

2具有Pt电极的SBT、BNT和BLT薄膜抗疲劳的原因主要有三种：稳定的氧八面体层导致氧空位迁徙困难；〓层对空间电荷有自我管理和补偿作用；畴壁解钉扎的速度很快，可以平衡畴壁钉扎的速度。

Incorporates several unique material/layer models (Rugate, EMA, Graded, User Defined Index, and Super Lattices) which give the thin film designer more power and flexibility to determine solutions of complex design and material characterization problems.

合并几种独特的材料/层模型给予薄膜设计工程师有力的灵活的确定材料特性。

Based on the research results of single layer films, three superlattice films of NbN/TiN, TaN/TiN and TaWN/TiN have been designed and synthesized and their microstructure has been investigated. The action of lattice mismatch and elastic modulus difference on the hardness anomalous increase of nano-multilayer films has been compared from the experimental research.

在单层膜的研究基础上，设计并制备了NbN／TiN、TaN／TiN和TaWN／TiN等三种超晶格薄膜，研究了它们的微结构特征，并通过实验研究对比了晶格错配度和弹性模量差异对纳米多层膜硬度异常升高的作用。

Because the water throws over covers the tectorial membrane the tensity is extremely good, is very easy to twine forms the chart article level to the product surface, the product surface on likely sprays paint equally obtains the entirely different outward appearance.

由于水披覆薄膜张力极好，很容易缠绕于产品表面形成图文层，产品表面就象喷漆一样得到截然不同的外观。

The ferroelectric-thin-film pixel is an essential element in uncooled infrared focal plane array of an infrared detector.

非制冷红外探测器内的铁电薄膜微桥是多层的结构体系。

We mainly discussed the bonging configurations and element of the SiOx/a-C:F/SiOx multiple-layered films, and the difference from one-layered films before and after annealing.

本文重点分析了SiO_x／a-C：F／SiO_x多层膜的结构与成分，并与单层的a-C：F薄膜比较了退火前后结构与介电性质的不同。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。