薄膜地

In order to increase the practical application of this waster water treating technology, in this text, we tried to improvement the feasible on economy and technology from preparation of photocatalysists, design of reactor and the influence of different reaction conditions etc.A P25 TiO2 film supported on UV light surface was prepared using sol-gel method at 200℃ calcinations temperature, and the photocatalyst has shown a good stability and performance for the photodegradation of orthocresol solution irradiated with UV light of 254nm, when reaction for 30min, the photodegradation still more then 85%.

为了更快地将这种处理技术用于大规模生产当中，本文以焦化废水中的邻甲酚作为目标污染物，试图从催化剂薄膜的制备、反应器的设计、反应条件的影响等各方面来深入研究TiO_2膜催化剂的催化降解作用以便促进提高其实际应用中的经济技术可行性。

These bombardments can eliminate high-energy default configurations priorly and leave stable configurations behind.

自从SW效应发现以来，这种亚稳特性一直制约氢化非晶硅薄膜在应用过程中地进一步发展。

The recovery of the pseudocubic angle of LSMO resulting from the relaxation of the shear strain introduced by the growth of rhombohedral LSMO on cubic LSAT was suggested to be the origin of the superlattice structure.

不对称的(103)倒易空间图强有力地证明了这面内调制结构源于因菱形的LSMO和立方衬底LSAT之间的角度失配引起的一种剪切应力的弛豫而导致LSMO薄膜中赝立方角的恢复。

The stoichiometrical preferred-orientation AlN (100) polycrystalline films were deposited on Si (100) wafers with DE=1.0 J*cm-2, PN2=13.333 kPa, Tsub=200℃, V=650 V, f=5 Hz, and dS-T=4 cm.

实验结果表明，当DE=1.0 J*cm-2，PN2=13.333 kPa，Tsub=200℃，V=650 V，f=5 Hz，dS-T=4 cm时，高质量的AlN薄膜被成功地沉积于Si(100)基片上。

Are used to study the structure, crystallograph quality, surface structure, conductivity and chemical status of grown films. The minimum full width at half maximum of XRD rocking curve of CdTe, ZnSe and ZnTe epilayers are 630, 133, 110 arcsec respectively. Compared to MBE and MOVPE, ICB allows the epitaxy at lower temperature onto various substrates with higher deposition rates.

实验在GaAs等衬底上分别生长了CdTe、ZnTe、ZnTe单晶薄膜，其X光摆动曲线半高宽分别达到了630、133和110弧秒，与MBE、MOVPE相比，ICB技术外延时，大幅度地降低了生长温度，提高了生长速率，在实际应用方面具有特别重要的意义。

They have good aerating performance and ageing resistance that ordinary plastic films do not possess. This is a first experimental program in China.

它作为地布覆盖材料，具有一般塑料薄膜所不具备的透气性和耐老化等优点，经喷涂除草剂后覆盖于畦面。

We take pleasure to introduce us as one of the largest vinyl three-dimensional laminates films factory in Guangdong, China.

我们高兴地介绍，我们作为最大的乙烯三维立体层板薄膜厂在广东，中国。

An ultra-high strength, weldable, low alloy steel with excellent cryogenic temperature toughness in the base plate and in the heat affected zone when welded, having a tensile strength greater than 830 MPa (120 ksi) and a micro-laminate microstructure comprising austenite film layers and fine-grained martensite/lower bainite laths, is prepared by heating a steel slab comprising iron and specified weight percentages of some or all of the additives carbon, manganese, nickel, nitrogen, copper, chromium, molybdenum, silicon, niobium, vanadium, titanium, aluminum, and boron; reducing the slab to form plate in one or more passes in a temperature range in which austenite recrystallizes; finish rolling the plate in one or more passes in a temperature range below the austenite recrystallization temperature and above the Ar3 transformation temperature; quenching the finish rolled plate to a suitable Quench Stop Temperature; stopping the quenching; and either, for a period of time, holding the plate substantially isothermally at the QST or slow-cooling the plate before air cooling, or simply air cooling the plate to ambient temperature.

在基体板以及焊接时的热影响区处的低温韧性优异的超高强度、可焊接、低合金钢具有高于830MPa（120ksi）的抗拉强度，并且具有包含奥氏体薄膜层和细晶粒的马氏体／下贝氏体板条的显微层状组织，所述钢的制备过程为：加热含有铁以及特定重量百分比的添加元素的钢坯，所述添加元素为碳，锰，镍，氮，铜，铬，钼，硅，铌，钒，钛，铝，以及硼中的一些或全部；在奥氏体可发生再结晶的温度范围内，采用一个或多个道次，将所述钢坯轧制成板材；在低于奥氏体再结晶温度但高于Ar 3 转变点的温度下，采用一个或多个道次对所述板材进行终轧；将所述终轧板材淬火至一适当淬火终止温度；停止所述淬火；或者在空冷前在QST点基本等温保持所述板材一段时间，或者对所述板材进行缓慢冷却，或者只是简单地将所述板材空冷至室温。

Similar to Pt/Co multilayers, the PMA in the Co-Pt alloy film originates from the reduction of symmetry in the interface between magnetic and non-magnetic layers. Addition of a small amount of Ni in the Co-Pt alloy film leads to an obvious decrease in the Curie temperature, but the decreases in Kerr rotaion and PMA are quite limited. Furthermore, it promotes the growth of grains and roughens the film surface and thus enhances the coercivity of the film, which are of advantage for short-wavelength MO recording.

在Co-Pt合金薄膜中加入少量的Ni可促进晶粒生长、增加表面粗糙度、提高矫顽力，并且在不明显减弱垂直磁各向异性和极克尔角的情况下，能有效地降低居里温度，有利于短波长高密度磁光存储。

Antimony doped tin oxide nano-powder was prepared by hydrothermal synthesis.

锑锡氧化物(antimony doped tin oxide，简称ATo)是一种n型导电材料，具有优良的导电性能和光学性能，被广泛地应用于各种平板显示器…、太阳能电池川、电致变色功能薄膜、红外遥感探测等领域。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。