薄膜

The first industrial production teflon thin film majority uses have re-equipped the plank veneer peeling lathe turns on lathe cuts the processing, this traditional veneer peeling lathe uses the mechanical drive control generally, produces not only the thin film the quality is not high, the reliability is bad; Moreover in the production process the noise is big, consumes energy much, the production efficiency is not high, is unable to adapt the now industrial production demand.

目前工业生产的聚四氟乙烯薄膜大多数使用改装过的木板旋切机旋切加工而得，这种传统旋切机一般采用机械传动控制，生产出来的薄膜不仅质量不高，可靠性差；而且生产过程中噪音大，耗能多，生产效率不高，无法适应当今的工业生产需求。

Systematic detection and analysis of the performance of synthetic water based gravure surface ink for plastic film was made.

结合水性凹版塑料薄膜表印油墨印刷性能妥求，进行配方和工艺设计，选择原材料进行加工，并对研制的水性凹版塑料薄膜表印油墨的性能进行了系统的检测分析。

This volume describes thin film magnetic properties and methods for characterising thin film structure topics that underpin the present 'spintronics' revolution in which devices are based on combined magnetic materials and semiconductors.

这卷为表现支持目前的pintronicsrevolution的薄膜架构题目的特性描述薄膜有磁性的特性和方法，设备基於结合的磁性材料和半导体。

Carving gravure of business card printing and membership card making production and offset business card printing and membership card making, and so on are very different, first of all the manuscripts submitted to approx 10 times, the perimeter line by hand is decisived on top of a piece of zinc tablet with a smaller machine to get an outside line back into the original large carved in a piece about an inch of eight brass, and copper strip it is some anticorrosive toppedwith films, because of copper strip is triggered from the perimeter line, so the rough body by hand for the film, when removed, and then use the medicine to the erosion of deep water, and proto-end knife with a magnifying glass and, thetolerant to the edge, sharp corners repaired, such as location on a layer of chrome, it's a printing plate.

雕刻凹版的制卡和会员卡制作制作与柯式制卡和会员卡制作等有很大的分别，首先把来稿放大约十倍，把外围线用手工刻划在一块锌片之上，再用一部缩细机械把外线缩回原大刻在一块约八份一寸的铜片上，而这件铜片上是涂有一些防腐蚀薄膜的，因为铜片只是勾上字的外围线，所以要用手工将粗身地上的薄膜刮去，然后用药水将印纹蚀深，最后仍要用放大镜及雕刻刀，耐性地将线边、尖角等位置修好，再镀上一层铬，这印版便大功告成。

The surface photovoltaic spectra of Bacteriorhodopsin based films were systematically measured. The results show that the BR films are characterized by the specific photovoltaic effect.

采用表面光电压谱系统地研究了细菌视紫红质的光伏特性，结果表明BR薄膜有着独特的光电性质，并且与BR薄膜的制备方法和湿度有关。

After treated with FAS, the films of TiOPc-coated ZnO nanorod array showed they were Cassie state superhydrophobic surfaces with fine photoconduction.

这种垂直于基底生长的氧化锌纳米棒薄膜经蒸镀酞菁氧钛、修饰氟硅烷后得到了光导性能很好的Cassie状态的超疏水薄膜。

The materials and devices:conductive glass,ink,conductive silver pase,film and so on

触摸屏原料及器件：导电玻璃、油墨、导电银浆、薄膜、薄膜开关、双面胶类、柔性线路板

At the same time, for ultraviolet, visible and near infrared range, the thickness, packing fraction and complex refractive indexes of the PZT thin films have been deduced from a transmission spectrum of the films by Envelope method.

同时，根据PZT铁电薄膜紫外、可见和近红外光区的透射光谱，采用&包络法&计算出了PZT薄膜的厚度、填充密度以及紫外、可见和近红外光区的复折射率及其射散频谱。

Plasma assisted molecular beam epitaxy was employed to prepare ZnO thin films on Si(111) substrate.

在Si(111)衬底上利用等离子体辅助分子束外延生长氧化锌薄膜，研究了在不同衬底生长温度下(350～750℃)制备的ZnO薄膜的结构和光学性质。

TEOS and PEG with different relative mol. wt. were used as raw materials to prepare single layer antireflective SiO2 films on borosilicate glass by sol-gel method. The relationships between preparing processes and optical properties of the films were investigated.

以正硅酸乙酯、不同相对分子量的聚乙二醇为主要原料，采用溶胶－凝胶法在硼硅酸盐玻璃板上制备单层SiO2减反射薄膜，研究了制备工艺对薄膜光学性能的影响。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新