薄涂
- 与 薄涂 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
To smear with birdlime.
给灌浆;给涂薄胶泥用薄灰浆或薄泥浆充填或粉饰
-
Brayer:a small hand roller used to spread ink thinly and evenly.
涂墨滚:手动小滚筒,用于薄而匀地涂墨水
-
Firebrick coated with alumina is used as column substrate for the separation of gaseous hydrocarbon mixtures.
氧化铝以薄层形式涂渍于耐火砖上,可以用作快速分析气体烃混合物的色谱柱填充物。
-
Floppy disk — thin flexible disk coated with magnetic material, enclosed in a protective plastic case.
软盘——在又薄又软的盘面上涂上磁介质,装在一个用于保护的塑料套中。
-
Pet film, Business card printing and membership card making ink, aluminum, gelatinize and subsealing PE (as a thermal composite materials), the result of color print ink business card printing and membership card at the end of China and India making up full white ink all on bond in adhesives, resulting in aucilisty and membrane separation from Fox: there is another situation is when the business card printing and membership card making ink ink film the thin membrane with a composite of PE attachthemselves fastness and ink adhesion of film thickness.
例如PET不薄膜、制卡和会员卡制息油不朱、真空镀铝、涂胶与PE不简单,甘休不黑白油不朱制卡和会员卡制息后,末了印上来的满版白不朱全部粘结在胶粘剂上,导致PET与底膜的别离:还有一栽境况是:制卡和会员卡制息油不朱不朱膜层不薄的,在与底膜的PE不简单后附着牢度好,而不朱膜层薄的附着不对。
-
In the early days copper was normally followed by a relatively thin bright nickel layer with conventional chromium topcoat.
早期,涂覆铜层之后,再涂一薄层光亮镍,然后传统的铬层位于最外层。
-
For the veneering with 0.3mm thick veneer over a graduated particleboard, the optimum processing conditions were a UF adhesive level at 78g/m~2 over the board, a PVAC adhesive level at 42g/m~2 over the veneers and 4.6 percent 36% HCL ...
用0.3mm厚的水曲柳薄木对渐变结构刨花板饰面时,其最佳工艺条件为:脲醛树脂胶在刨花板上的涂胶量为78g/m~2,聚醋酸乙烯酯乳液在薄木上的涂胶量为42g/m~2,38%盐酸用量为聚醋酸乙烯酯乳液重量的4.6%。
-
The surface and cross section of uncoated and coated Polyvinyl acetals were analyzed by microscope and SEM, results showed that, the contact angle of the coated fiber decreased in most of the areas of the fibers, the chitosan film on the fibers was thin and uniform. At the same time, there was no residual material in the coating process and the whole process was environmentally friendly.
结果表明,该方法切实可行,通过显微镜和SEM照片对涂覆壳聚糖前后的维纶纤维进行微观分析,发现在化学纤维表面形成的壳聚糖膜薄而均匀,同时增加了化学纤维的表面粗糙度,涂覆效果较好;通过接触角的变化说明纤维的亲水性得到改善;该方法还具有无残留物和对环境友好的优点。
-
Precise pressure control from 22.8 MPa (400 psi to 3300 psi), for spraying light-bodied coatings all the way up to low-VOC striping paints.
精确的压力控制区间(400psi 到3300psi ),最高压力22.8MPa (3300psi ,可喷涂薄涂型涂料,以及低 VOC 划线涂料。
-
Optimum column pressure, plate height, resolution, tailing factor and resistance coefficient of mass trunsfer were determined.
由于薄涂色谱柱柱子短,较复杂组分的分离效果欠佳,因而限制了它的应用。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。