薄层

Fat layer of experimental group became thinner,fat cell got smaller.

3实验组脂肪层变薄，脂肪细胞体积变小。

Ti underlayer improved the magnetic and high recording characteristics of the single CoCr film and CoCr/FeNi double layer media, CoCr/FeNi double layer floppy disk with inserted Ti underlayer have more smooth surface and better envelope curve.

钛膜底层的插入使得上部磁层的结晶取向及磁特性明显改善，结晶和磁性的均匀性提高。用钛膜打底的软盘，随t〓减薄，记录灵敏度提高，重放电压增加。

However, wax on paper fibers is not a good adhesion, especially when it has been brachea isopropylammonium 30 times in the future, its solid content only 1.5 ~ 1.7, the paper surface fiber only a thin was wax packages.

但是，蜡对纸纤维的附着力并不好，特别是当拔水剂被稀释了30倍以后，其固含量只有1.5~1.7，纸表面纤维只有很薄一层被蜡包裹。

This phenomenon could be relaxed using the SONOS structure, thanks to the thin ONO layer between the control gate and the channel.

所幸这是可以使用介於控制闸与元件通道之间薄的ONO层之SONOS 元件结构来缓和这个现象。

This time I used half of the amount sheets of glass as well cutting down on time to laminate and producing a thinner hull.

这个时候我用一半的数额表玻璃，以及降低对时间，层压板和生产更薄的船体。

Carving glaze is a porcelain body, Sincere on white or black glaze, and then press the pattern with the sharp tool to outline the contour shape and petal leaf ribs, crossed pattern outside the space, exposing porcelain body, Shi layer of thin transparent glass glaze , into the kiln firing, glaze formation of black and white tires and a strong color contrast.

雕釉是在瓷胎上先施白或黑釉，然后按花纹用尖状工具勾划出轮廓线和花瓣叶筋，划掉花纹以外的空间，露出瓷胎，施一层薄而透明的玻璃釉，入窑烧制，形成胎和釉黑白两色的强烈色泽对比。

Output performance and internal quantum efficiency of an InGaN light emitting diode LED）using thin AlGaN as strain-compensated layer is theoretically investigated.

薄的应力补偿层AlGaN的引进对InGaN量子阱结构的发光二极管输出功率和内量子效率的影响被详细考察。

Heat transfer will worsen if structure parameters of the spring inserts are not fit. The paper think that the mechanism of heat transfer enhances of the spring inserts is the laminar flow lining is thinner because of librating of the spring inserts, accordingly the part of convection is enhanced. But the part of boil is not influenced.

通过弹簧插入物的各个参数对传热性能的影响分析，认为弹簧插入物对竖管降膜蒸发传热强化的机理主要是弹簧的振动加强了液膜的湍动，减薄了层流内层，从而强化了对流传热分量，但对沸腾传热分量没有影响。

The interface between oxide film and substrate is distinctive, but there is no obvious interface between electrolytic coloring film and oxide film, which indicates that coloring metal is deposited in micropores.

图纹处氧化膜较厚，无图纹部分较薄，氧化膜与基体界面分明，而电解着色膜与氧化膜无明显的分界面，说明着色金属是沉积在多孔层微孔内。

The rules of fluid rate with different technical parameters: the increase of electromagnetic force causes the increases of the fluid rates at S/L interface and free surface, the decrease of skin depth, the increase of electric current density which will make the fluid at free surface flowing faster, while it doesnt affect the fluid rate at S/L interface. When the height of melt increases, the both of fluid rates will increase too. The increase of the width-thickness ratio augments the fluid rates along the wider edges at S/L interface evidently, while the rates along the narrow edges will have little change, and the rate at free surface has little change too. The increase of overheat degree minishes the range of mush zone, while the fluid rates at S/L interface and free surface will increase evidently.

流速的大小随各种不同工艺因素的变化呈现出一定的变化规律：随电磁力的增大，固液界面以及自由表面处的流速都会增大；集肤层渗入深度变薄，电流密度增大，会导致自由表面上流动的加强，但对固液界面处的流动速度影响不大；熔区高度的增加，也会使固液界面及自由表面处的流动增强；宽厚比增大时，固液界面上沿宽面方向的流动显著增强，但窄面方向流速变化不大，同时自由表面上流速变化也较小；过热度及温度梯度的增大，使糊状区减小，导致固液界面及自由表面处的流速显著增大。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。