蒸发的

Wavy distribution of soil water along hillslope resulted from the fluctuation of runoff, upslope runoff infiltration, lateral downslope flow, and the difference of infiltration rate and evapotranspiration.

4土壤水分沿坡面呈"波浪形"分布是坡面径流的波动性、上方来水的沿程入渗、侧向沿坡向下流以及坡面各处入渗性能和蒸发蒸腾作用的差异等综合作用的结果。

Finally, two short-path distillation processes and one falling film evaporator are applied in the regeneration of waste lubricating oil. In the test, the diesel oil, gasoline and lubricating oil are distilled respectively, while the gelatinoid materials, asphaltene and carbon residue remain in the draft. The regenerative lubricating oil accords with the standards of base oil. And the recovery efficiency is up to 75 percent. The technology used in the test doesnt comprise processes like pickling and alkali neutralization, which would cause secondary pollution like acid draff and sulfur dioxide and so on. As a result of this, our technology is friendly to the environment.

最后，利用一级薄膜蒸发和两级短程蒸馏工艺对废润滑油进行了再生回收工业应用试验，将柴油、汽油等轻油以及润滑油馏分分别蒸馏出来，而大部分胶质、沥青质、碳垢存在于残渣中，试验得到的再生润滑油符合基础油的标准，回收率达到75％，达到废润滑油再生的目的；同时再生过程中没有酸洗、碱中和等工序，不产生酸渣、二氧化硫等二次污染，是一种清洁环保的废润滑油再生工艺。

Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue

薄膜或纸张表面不干净，裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象，薄膜卷边换用新膜干燥温度过高，粘合剂表面结皮调整烘道温度，清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡；薄膜两端松紧不一致或波浪边；调整覆膜机器胶层过厚，溶剂蒸发不彻底，影响了粘度，受压力滚筒挤压，纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化，在光、热、紫外线的影响下，发生化学变化，生成有色物质应换用新胶水

In addition, Comparing with the results of expanding evaporating source model and an isospin-dependent p...

另外，通过与膨胀蒸发源模型及同位旋相关的渗透模型分析结果的比较，发现这种差别主要是由同位旋相关的反应动力学所造成的。

Based on the previous results in open literature, a new and simplified model of evaporation zone was developed.

本文在分析前人工作的基础上，建立了新的简化的锅炉蒸发区的动态数学模型。

The reasons: first, the ink dry slowly tends to be a result of the slow evaporation rate of water, usually as a result of viscidity exorbitance or monochamus version xuetie deep and too thick membrane or for non-absorbent plastic, aluminum foil, and so on do not absorb ink, the other is for full wind conditions or no drying equipment condition or drying (including infrared small magnetic dry power) caused by the temperature low and so on.

原因：一是油墨干燥慢往往是因水的蒸发速率慢引起的，通常也会因粘度过高或版穴深而墨膜过厚或因非吸收性塑料，铝箔等不吸收油墨导致的，二是因完全无风状态下或无烘干设备条件或烘干(包括红外磁波干燥功率小)温度低造成的等等。

If fluxed parts are allowed to stand, the water in the flux will evaporate, and dried flux is liable to flake off, exposing metal surfaces to oxidation.

如果允许涂上焊剂的部件处于直立状态，那么焊剂中的水分会蒸发掉，而干燥的焊剂很容易脱落，致使暴露的金属表面容易被氧化。

If flux ed parts are allowed to stand, the water in the flux will evaporate; and dried flux is liable to flake off, exposing metal surfaces to oxidation.

如果允许涂上焊剂的部件处于直立状态，那么焊剂中的水分会蒸发掉，而干燥的焊剂很容易脱落，致使暴露的金属表面容易被氧化。

If fluxed parts are allowed to stand, the water in the flux will evaporate,dried flux is liable to flake off, exposing metal surfaces to oxidation.

如果允许涂上焊剂的部件处于直立状态，那么焊剂中的水分会蒸发掉，而干燥的焊剂很容易脱落，致使暴露的金属表面容易被氧化。

Since the spray flow is influenced strongly by the condition of gaseous phase, the simulation of gas flow field is illustrated especially at the first part of the thesis.

此外，本文对离散液滴模型中液滴的分组采样、液滴运动轨迹的计算以及液滴的蒸发模型也作了详尽的阐述。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。